Can the keyboard be removed and cleaned with water???

Yes, but don't wash the PCB board inside. The rest can be washed and dried with a hair dryer.

After the keyboard is disassembled, the keys can be cleaned with water, and when it is dry, the keyboard tray can only be swept with a small broom, and then the circuit board inside is not touched.

It's okay, I've dismantled it, and I can dry it with a hair dryer, and if there's a problem, add me to the number.

Some parts can be keyboard caps or something, but the circuit board can't do anything, and after disassembly, you must ensure that it is completely dry before putting it back up.

Let's see if your keyboard has that function

Like the Microsoft Sidewinder X6 gaming keyboard.

It can be disassembled.

But it's best that you don't disassemble it.

If you don't go back, you'll have to buy a new one...

1. Remove the keyboard cap: Use a screwdriver to gently warp the side of the keyboard cap, and the keyboard cap will easily fall off for slipping. Due to the large number of keys, removing the keyboard cap is a big project, but you need to be patient.

2. Clean the keyboard caps: The cleaning method is similar to our usual laundry, put all the keyboard caps into the bucket, use laundry detergent or other detergents, and wash them thoroughly with water.

3. Clean the inside of the keyboard: The inside of the keyboard is relatively cumbersome, use a brush to remove the dirt inside, sweep the dust and other miscellaneous things thoroughly, and then wipe it several times with a wrung out wet towel.

4. In order to prevent residual moisture and ensure that the keyboard can continue to work after cleaning, it is important to place the keyboard cap and keyboard in a ventilated place to dry.

5. Finally, the restoration of the keyboard, the dried keyboard caps are installed one by one according to the original position, this step mainly tests everyone's familiarity with the keys. The cleaned keyboard has been given a "new lease of life" and a new look that people can't put down.

The keyboard can be rinsed with water. Before cleaning, you need to remove the PCB board inside the keyboard, and then clean it with a small brush with a soft head, and after the upper and lower caps of the keyboard are all disassembled, you can rinse them directly, and then reassemble all the parts to use normally.

Precautions for keyboard cleaningIf you don't want to be so troublesome, or will not disassemble, then you can use a small brush to sweep the dust inside, or use wet wipes to wipe it, so that you can also clean the keyboard very clean, there are many metal accessories in the keyboard, these metal accessories can not be put into the water to rinse, to remove them.

If it won't be disassembled, then you can ask a professional to disassemble it, and then let the professional install it after cleaning. The keycaps of the keyboard are almost all made of plastic, and there is no effect after washing and drying.

It is better not to wash the keyboard. It is best not to rinse the keyboard directly with water, although it can be cleaned more cleanly, it is easy to clean the letters on the keyboard. Whether it is a keyboard on a notebook or a keyboard that is usually used, try to wipe it with a rag to avoid leaving water inside the keyboard and affecting the normal use of the keyboard.

Keyboard cleaning precautionsOnce the cleaning is complete, allow the cleaned keyboard to dry for a few hours or use a hair dryer to dry, then install the keyboard as it is. When installing, you should first put the panel facing down on the table, put the two sides with book pads, and then put the small rubber pads into the buttons one by one, then put the circuit board and bottom panel, and finally put the screws, and then you are done.

If it is a special notebook keyboard film, that is, a keyboard film that matches the keys and models, the cleaning principle is the same. Wash it in the same way and spread it in the air, but remember not to pull it in the sun, otherwise it will deform quickly and shorten the life of the keyboard membrane.