-
1 8 Step by Step Reading.
The rearview mirror of the car is very important in the driving of the vehicle, the angle of view of our human eye is only 120 degrees, in the process of driving, we need to use the rearview mirror to observe the rear and side road conditions, as well as observe the surrounding driving environment, to ensure our safe driving, whether the rearview mirror is suitable is directly related to driving safety.
As a driver, after getting into the car, we must first adjust the seat, after adjusting the seat, we have to adjust the indoor rearview mirror, the indoor rearview mirror mainly observes the rear of the vehicle, so that he can see the maximum situation in the rear, that is, we adjust the rearview mirror standard, to ensure that the rearview mirror sees the four corners of the rear windshield.
After adjusting the indoor rearview mirror, we need to adjust the outdoor rearview mirror, that is, the left and right rearview mirrors we are talking about, first of all, we must adjust the left and right rearview mirrors, and when adjusting the inclination angle of the left and right rearview mirrors, we should let the body occupy 1/4 of the interior rearview mirror, and the left and right sides are the same as the body occupies 1/4 of the interior. After adjusting the inclination, we adjust the elevation angle of the rearview mirror, and the rearview mirror on the left side should be adjusted to the sky and the earth each accounting for half of the rearview mirror, and the connection between the sky and the earth is in the rearview mirror.
When adjusting the right rearview mirror, there is a certain difference with the left rearview mirror, which is due to the relationship between the driver's position, and the adjustment should occupy 1/3 of the upper part of the mirror, and the ground accounts for the lower 2/3 of the mirror.
Now let's do a simple experiment, we put a mineral water bottle about 18cm high 15cm away from the right rear wheel of the car, and see if it can be seen from the rearview mirror?
It can be seen that we did not find the water bottle in the mirror until we adjusted it according to the expert's method.
When we adjust it in this way, we will see that there is a bottle cap leaking out under the mirror, which is not very noticeable, but we can also observe it.
This adjustment standard can not only observe the situation in the distance to the greatest extent, but also observe the situation near the body to the greatest extent, and whether you are a small car or a large SUV, you can adjust it according to this method.
-
The motor has to reach almost 20 amps to generate electricity.
-
If the car exceeds the prescribed speed by more than 10% but does not reach 20% on the highway, a fine of 200 yuan shall be imposed and 3 points shall be deducted. Breaking the law is 142001.
The demerit points for highway fines for ordinary vehicles are as follows:
1. If the speeding penalty exceeds the specified speed by less than 10%, the penalty will not be imposed temporarily;
2. If the speed exceeds the limit by more than 10% but does not reach 20%, a fine of 200 yuan will be imposed and 3 points will be deducted;
3. If the speed exceeds the prescribed speed by more than 20% but does not reach 50%, a fine of 200 yuan will be imposed and 6 points will be deducted;
4. If the speed exceeds the limit by more than 50%, a fine of 2,000 yuan will be imposed and 12 points will be deducted.
-
1. The deduction points for speeding fines on highways for ordinary vehicles are as follows:
1. If the speeding penalty exceeds the specified speed by less than 10%, the penalty will not be imposed temporarily;
2. If the speed exceeds the limit by more than 10% but does not reach 20%, a fine of 200 yuan will be imposed and 3 points will be deducted;
3. If the speed exceeds the prescribed speed by more than 20% but does not reach 30%, a fine of 200 yuan will be imposed and 6 points will be deducted;
4. If the speed exceeds the prescribed speed by more than 30% but does not reach 50%, a fine of 200 yuan will be imposed and 6 points will be deducted;
5. If the speed exceeds the limit by more than 50% but does not reach 70%, a fine of 1,000 yuan shall be imposed, 12 points shall be deducted, and the driver's license may be revoked concurrently;
6. If the speed exceeds 70% of the prescribed speed, a fine of 2,000 yuan shall be imposed, 12 points will be deducted, and the driver's license may be revoked.
Among them, if the speed limit is less than 50% on the road with a speed limit of less than 60 km, a warning will be given.
Second, not all violations have **, the accompanying drawings are illustrated:
-
A fine of 50, no deduction points, I only went to pay it this week, ** I can't remember, I will be in the unit, I am speeding on the Yanjing Expressway in Jiangsu Province, so rest assured, prepare 50 yuan on OK.
-
Driving medium-sized or above passenger and cargo vehicles or dangerous goods transport vehicles on roads other than highways and urban expressways, or driving other motor vehicles that exceed the prescribed speed by less than 20%; 3 points will be deducted.
1303b stands for speeding by 10%--20% on the highway
In addition, please click on the next --- to adopt. Thank you.
-
Why didn't I get 3 points and a fine of 300 if my speed didn't exceed 20 percent per hour?
-
The speed of the plane is not yet bearable. This is not a question of speed, but acceleration and stability of the body. The current automobile engine acceleration is far from reaching the limit of the human body, the full throttle acceleration of the engine is generally in, the sports car can reach 1g, the human body is estimated to be very uncomfortable under the horizontal acceleration of about 4g, and the current supercar brake reverse acceleration is only about 2g, it is very difficult to develop to 4g, tire grip, body strength are problems.
-
I find you quite boring, the average car can't reach this speed at all.
-
1: The steering wheel is not in a deadbolt state. The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing.
2: Did you not return the gear to P when you parked? Think about it, if the D or R gear can be ignited, the jump of the vehicle at the moment of ignition is undoubtedly a huge safety hazard.
Therefore, for automatic transmission vehicles (AT, CVT, AMT), the manufacturer will preset this mode, and repeatedly tell in the manual: make sure that the gear is in the P gear position when ignition.
3: One-button start sometimes encounters the trouble of power loss of the smart key, obviously the key is in the car, but the instrument always shows 'key matching error', this situation is likely to be the power loss of the smart key, and the starting system can not sense the weak radio waves emitted by the key. Therefore, it is recommended to pick up the smart key and put it on the start button, and then press the button to start.
4: Check whether the battery has power. If the ignition is not ignited, it may be due to the loss of power or the expiration of the battery life due to the long-term headlights have not been turned off, and the battery is generally replaced in time according to the maintenance manual.
5: See if there's oil. If the fuel gauge shows that it is below the red line, it will not ignite. At the same time, pay attention to the quality of the oil. There have been car owners who found that there was water and mud in the fuel tank after disassembling the car, and with such oil, it is impossible for the car not to break.
6: No antifreeze.
Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.
-
The new battery has no power. Or the battery is low.
-
There are many phenomena of motorcycle starter failure. The first Hengzhou number is that the carbon brushes are too worn to conduct current. The second is that the starter coil is short-circuited and broken, or it may be a short circuit that causes the starter coil to burn out.
The third is that the starter relay fails. The fourth is that the starting line fails, which may also cause the starter to not rotate. The fifth is the starter gear combiner problem.
-
There is no value in repairing, replacing it with a new one.
-
Guangzhou Mada Technology **** is a limited liability company (natural person investment or holding) registered in Baiyun District, Guangzhou City, Guangdong Province on 2017-12-14, with its registered address located in Room 332, No. 1392, Baiyun Avenue North, Baiyun District, Guangzhou.
The unified social credit ** registration number of Guangzhou Mada Technology **** is 91440101MA5AN2PJ0C, and the enterprise is currently in a state of operation.
The business scope of Guangzhou Mada Technology **** is: leather and leather products wholesale; software development; research and development of network technology; computer technology development and technical services; software wholesale; software services; software testing services; software retail; electronic anti-counterfeiting system technology development and technical services; investment advisory services; business management consulting services; educational consulting services; cultural and artistic consulting services; planning creative services; commodity information consulting services; marketing planning services; Large-scale event organization and planning services (large-scale activities refer to evening parties, sports meetings, celebrations, art and model competitions, art festivals, film festivals, public welfare performances, exhibitions, etc., and activities requiring special approval should be operated only after obtaining approval); biotechnology development services; biotechnology consulting and communication services; scientific and technological information consulting services; Internet sales of goods (except for licensed and approved goods); For projects subject to approval in accordance with the law, business activities can only be carried out after approval by relevant departments). Within the scope of this province, the registered capital of the current enterprise belongs to the general.
Through corporate credit.
-
Hello, check what the starting voltage of the battery is, check the quality of the battery, I hope mine can make you satisfied, I wish you a happy car!
-
Hello, the battery is not enough power, charge it, or change it to a new battery.
-
Hello, I need to measure whether there is no starting power supply, or the motor is broken,
-
See if the starter carbon brush has been worn out? ‘’
-
Hello, it is possible that the starter is faulty, it is recommended that you drive to the repair shop to check it.
PIN 2 (Personal Identification Number 2) is a personal identification code that needs to be entered when entering a special function (such as setting a fixed number, setting up call billing, etc.). This password is confidential and cannot be accessed by ordinary users, so the operator will not provide it to users and cannot be queried. >>>More
Uh, saying that Miranda has to go on vacation with her family in advance. >>>More
Qianli Eagle, relying on a variety of false standards to make up a small domestic brand (I don't know which factory it comes from). The false label is too serious to believe the authenticity of other parameters and materials reported by this brand. More than 100 yuan can buy 60 times hand-held binoculars. >>>More
Outstanding Period: Simply put, it provides a buffer period for planners to deal with it in advance. Under the logic of reverse scheduling, for example, the start date of the planned order created by MRP is 5 days, and the open period is 3 days, then if the current date is 1st, it has not yet entered the open period, and the planner does not need to process the planned order so early, and if the current date is 3 days, it is in the open period, at this time, there will be an exception message 05 generated in MD04, which is used to prompt the planner to convert the planned order into a production order or a purchase requisition. This gives the planner enough time to process the order. >>>More
I think it's Deidara, although Deidara is only 17 years old, but he is very good and has very strong analytical skills, he has genius genes, he can not only play the bomb to the extreme, regard art as ** and firmly believe in his own principles, but also so confident, it is difficult to win, just happened to meet the nemesis.