Is it possible to create a host table on a personal PC with some DOS commands like a router?

No, it doesn't. The PC is not a router and cannot learn information from other PCs. Therefore, it is not possible to display information from other PCs. The ping command is generally pinged after knowing the address or ** of the other party, and is not obtained from the machine.

The IP address is followed by the IP address of the machine.

Physical address is the physical IP address, which is the MAC address.

Your IP is dynamic. Every time it changes, ipconfig finds out that the router assigns you the IP. If you want to see the dynamically assigned IP for each time, go into the router and look at it. Generally look at it in the working state.

This command depends on the information of your network card. It seems that you are not clear about this order.

This command. You can see all the information of your network card, plus a whole can also see more details。。。

Do you want to see the public IP? Use.

Look. You are in a LAN environment. So you can't see your own public IP address with this command.

c:\documents and settings\administrator>ipconfig

Windows IP ConfigurationEthernet Adapter Wi-Fi:

connection-specific dns suffix .

ip address. .This is your native ipsubnet maskThis is the subnet mask.

default gateway .This is the IP of the router

How is that possible? The query is the IP of the computer.

ping help

Then just do it yourself.

This has nothing to do with the system, it should be a piece of software in the computer that sends out a ping route similar to DDOS.

We also have some computers in our company that have this situation, usually caused by some malware, or the installation of an unknown operating system with a backdoor.

Install an antivirus to kill the virus once and see if the most fundamental solution is to reinstall the system once.

Correct Answer:

d. route print

1. SH ip route is the show command of the Cisco router, check the route table information. For example, in the following example, ospf is limited to show only ospf routes, and if ospf is not entered, just show ip route, the router itself and all learned routes will be displayed

2. arp -a is a command entered under dos, which displays the arp information, as shown in the following figure

3. Tracert can be used under DOS, it is a command to trace a node, and each IP node will return a message to tell you which node you have reached, as follows:

4. Route Print is used under DOS, you can view the interface list of the machine, and IPv4&V6 route information, as follows:

As explained above, I hope it can help you!

Obviously d.

Routing information. Use Route Print to view the route table on your computer.

Run --cmd--telnet. *Other party's IP).

If the other person has the relevant function turned on, you will be able to access his computer!

telnet is generally ip).

The premise is that the other computer's computer needs to turn on the telnet service.

Use antivirus software to see if the computer is controlled by a DOS Trojan virus program, and change the router password

By what software is antivirus? If it's Kingsoft Antivirus, Rising Antivirus, a toy antivirus software, I suggest you change to a little red umbrella or nod32.

Is the router home or enterprise-grade? If there is no problem with the antivirus, and it is a home use, then the router may be faulty.

If it's an enterprise-grade router, I recommend reinstalling your personal computer operating system.