After connecting to the route, you can t access the Internet, and the reward is 30 points!!

You disconnect the router, hold down the reset button with a pointed object (such as a pen tip), plug it back in (you still need to hold down the reset key during this process), and release the reset button when you notice the sys indicator flashing. After that, the router will be restored to its factory state. After the reset, the router will be restored to factory settings, and the default login IP is; The default username and password is admin admin.

To set up an ADSL account and password in the route.

TP may be possible oh, you try.

Reset the router and reset it to change the data cable, it is also possible that there is a problem with the data cable.

Why can't some of the ** be opened?

Since some ** can be opened, it can be judged that the router is in normal working condition, and the connection to the external network is also normal. This situation is most likely caused by setting up or automatically obtaining an incorrect DNS server, such as obtaining a DNS server address provided by a foreign ISP instead of a local ISP, resulting in the unsuccessful resolution of certain domain names, so that they cannot be accessed.

Another possibility is the problem of MTU, please modify the MTU from 1500 (1492 in PPPoe mode) to 1400 in the network parameters WAN port setting (PPPoE is in the advanced setting options of WAN port settings) on the router management interface to see how the usage is used.

Or the problem is solved after automatically obtaining the IP and automatically obtaining the DNS.

1. There is a small hole on the front and back panel of the router with the word "reset" next to it;

2. When the router is powered on, find a sharp object like a pen tip and press and hold the reset key;

3 When you observe the SYS indicator flashing, release the reset button and the router will be restored to its factory state.

4. No matter what the problem, this is the most effective solution.

It seems that there are a lot of problems!

1. An exclamation mark indicates that your network is restricted, and the solution is to set the IP to a fixed IP! As follows:

Right-click Network Neighbor - Properties - Right-click Local Connection - Properties - Double-click Internet Protocol - Use the IP address below.

Enter the IP address here, if the routing address is then you set this x as long as it is not 0,1,255, the default gateway is the routing IP, and the DNS is also the routing IP).

If you have a fork, it means that your route is not working properly! It is recommended to check the line!

Second, the connection is normal but you can't connect to the Internet, this is because you just connected to the router, but the cat is not working properly, so you can't connect to the Internet.

Third, the cat only has one light on, that must be the power light, the other is not lit is estimated to be a problem with the line, or the cat is broken!

Fourth, the question is the same as above!

It is advisable to check the replacement line, most likely the cat is broken!

Good luck! Still have questions can hi me!