Haier automatic washing machine QS45 888 how to set to wash three times

Haier automatic washing machine QS45-888, set to wash clothes three times.

It is not possible to directly set the laundry to be washed three times, so you need to set it one at a time.

Put the laundry that needs to be washed in the bucket of the washing machine, set the water level of the water level switch, choose to set the "Laundry Only" (or Laundry Alone) program, and start the washing machine.

The washing machine will follow the set "Laundry Only" (or Single Laundry) program, starting with water filling, and after the water level reaches the set water level, it will start to complete the "Laundry Only" (or Single Laundry) work.

After the laundry is completed, the buzzer will sound to inform that the laundry is completed, and the washing machine will not open the drain valve for drainage.

The "Laundry Only" (or Laundry Alone) program is one of the programs reserved for the user's choice when the washing machine is designed (there are also "spin only", "rinse only", "drain only" and so on for users to freely combine and use).

Using these programs for laundry work can save water by using multiple uses of water.

Note that when using the "laundry only" (or single laundry) program multiple times, wash light-coloured laundry first, dark-coloured laundry second, and wash laundry that is prone to discolouration last, so as to avoid staining each other.

Take a look at the manual, which has detailed instructions.

You can't set this one, it's all set automatically in each program.

Connect the power supply, water inlet pipe, drain pipe; Then put the clothes in the washing machine, add laundry detergent or laundry detergent, cover the lid, turn on the faucet, press the power button, select the washing program, and press the start button.

Hello, thank you for asking the company.

Automatic water discharge, you don't have to worry about it. This type of washing machine is inherently a waste of water. You can turn the amount of water down a bit. However, the number of times the water is discharged.

Hello, thank you for asking the company.

The automatic washing machine is washed, rinsed and spun dried according to the set program, and the specific number of times the water is consistent with the number of clothes to be washed and the water level requirements. It is recommended to check the specific operation according to the manual. Thank you.

You are welcome to ask the company questions again.

We wish you a happy work life

Friendly reminder: Don't forget to take the answer when you see the reply.

What do you mean? I don't understand what you said, how do you want to wash it?

Generally, the washing machine has a soaking function, which can achieve the washing effect and minimize the damage to the clothes. Landlord to see if you have chosen this program, if not, then contact the after-sales service to help you check it.

If your water pressure is not big enough, resulting in a mess of the circuit board, it will also be done, find after-sales service to help you check it.

It is estimated that you have to find an after-sales service to check it, whether it is a problem with the computer board or motor.

But the washing machine was not soaked on it, and it didn't wash it, and it didn't turn for a minute, and it stopped for ten minutes, and then another minute, and then for ten minutes.

If you have a problem with the computer board, ask the manufacturer 4006999999

The safety switch is broken, open the entire upper cover of the washing machine There is a micro switch in the lower left corner Short circuit OK

The laundry program is messed up and there are not even two of the procedures: after washing the clothes and dehydrating, it is over, and there is no second rinse.

The default value of most programs is 6

Hello, thank you for asking the company.

You are welcome to ask the company questions again.

We wish you a happy work life