How to run in Suteng car, how to run in Suteng new car

Therefore, there are several things to pay attention to during the run-in period: 1Control engine speed:

The run-in period is not to control the speed of the car, but to control the speed of the engine, the engine speed is controlled between 2000-3000rpm (gasoline engine) The load of the engine is the lightest, due to the poor lubrication during the run-in period, too high speed is easy to strain the components, the speed is too low (the gear is too high), the power of the engine to do work becomes an impact, which will also cause wear, so it is necessary to change gears frequently to control the engine speed. Automatic transmission cars only need to control the engine speed below 3000rpm. 2.

Reduce the load: During the run-in period, because the best lubrication state can not be reached, the heavy load will aggravate the wear, so try to reduce the load in the first 500 kilometers, and do not exceed 50% of the maximum load during the 3000 kilometers running-in period, and gradually increase the load after the running-in period. In addition, the braking system is not fully running-in, the braking effect is not good, and the load also needs to be lightened.

3.Don't change the oil too early: The initial oil of the car is a special lubricating oil during the run-in period, which requires low viscosity, good heat dissipation, superior cleaning and oxidation resistance, and some car factories also add abrasives that are conducive to the run-in, so do not change the oil too early during the run-in period.

There is no need to worry about excessive abrasive debris as they will remain in the filter and the oil can be changed at the time specified by the manufacturer. It is also important to change the oil for the first time after the break-in period, and it is still necessary to use a lower viscosity oil, such as the viscosity of SAE5W30.

4.Don't use additives: New car owners are very protective of their new cars and are most likely to be persuaded to buy so-called "protective products".

After additives are added to the engine oil during the run-in period, it will seriously affect the run-in effect, prolong the run-in period, and even produce a chemical reaction with the oil additives, forming oil sludge or bubbles, which will reduce the oil pressure, and at the same time make the lubrication worse and accelerate the speed of wear, so do not use any additives during the run-in period. 5.Warm up before you start:

The new car must be warmed up before starting, the so-called preheating is actually to give the engine a full lubrication time, because the lubricating oil can not reach the friction surface immediately after starting, so it is necessary to wait until the lubricating oil has reached all the parts that need to be lubricated (especially turbocharged models) before starting. The time for adequate lubrication varies depending on the air temperature, oil viscosity, and permeability of the oil filter, so it takes at least one minute to ensure that the lubrication is in place.

The run-in period refers to the period when the new car walks for a period of time to make the various parts of the engine smooth, and the new car leaves the factory and starts to drive. Since the moving parts of the car have not yet been run-in, they must be used with caution, otherwise the damage to the parts will be exacerbated. Therefore, it is generally stipulated that within a certain initial mileage, the arm such as 1500 to 2000 kilometers of the car driving should be strictly implemented in accordance with the regulations, this period of time is called the car's closing period or running-in period.

Of course, this is not to say that the car is necessarily damaged if it is not closed. In order to maintain good performance for a long time, it is necessary to walk and close, and if it can be done correctly, it can also greatly improve the good feeling when driving.

Hello! Generally, the speed of the run-in period does not exceed 100, and the speed does not exceed 3000 rpm, and the first insurance is carried out at 3000 5000 kilometers.

It's the same as any other brand of car.

1. In the first 200 kilometers, the tire friction is not enough, so it is necessary to use more force than normal when braking. This also includes when you have just changed to a new tyre or a new brake pedal.

2. In the first 500 kilometers, the new tires have not yet reached the best adhesion, and the emergency braking fluid car should be avoided as much as possible when turning quickly.

3. In the first 2500 kilometers, you should drive gently, the speed should not exceed 100 kilometers per hour, and the speed should not exceed 2500 rpm.

4. In the first 2500-3500 kilometers, the water temperature has reached the working temperature (the water temperature pointer is half to the scale), which can be gradually increased to the maximum speed or the maximum engine speed.

It is best to do a regular maintenance (using the original engine oil) for kilometers, and then the cooperation between all the moving parts in the car can achieve a smooth state of movement, and the vehicle can be driven at its best performance.

Precautions for the run-in period of speed Kilometers for the initial run-in, the speed of the branch rent should not be too fast at this time, generally 70-80 kilometers below, the speed should not exceed 2200 rpm -1000 km for the mid-term run-in, the maximum speed can be appropriately increased, generally can reach 90-100 km, the speed is still below 2500 rpm is good; Proper acceleration will not only not affect the motivation of the fierce omen, but can promote the run-in, and you can see if there is any abnormality when the speed is re-accelerated -1500 km is the later run-in, and the speed can be increased to below 120 km, because the run-in is a gradual process, and the speed must not exceed 3000 rpm; 4. When all cars are driving at low speed, the actual burden is greater than that of medium speed, so the run-in period should not be run in below 60 kilometers per hour for a long time.

The run-in period and the first warranty period of Volkswagen Sutar are both 7,500 kilometers. The main content of the first warranty is to replace the oil filter, because there are a lot of metal shavings in the oil at this time. If it is not replaced in time, it will affect the performance of later use, aggravate engine wear, and thus affect the service life.

The first insurance is free of charge. Please make an appointment with the 4S store in advance, and bring your ID and the first insurance-free card.

At the initial range of 200 to 300 km, the new brake pads did not have the best braking effect, and &ldquo running-in &rdquo had to be carried out first. At this stage, the slightly reduced braking force can be compensated by increasing the pedaling force of the brake pedal. In the process of grinding the socks, when the brake pedal is pressed to the end or when the brake brake is braked urgently, the braking distance is longer than that when the brake pads are running-in.

During the break-in process, it is necessary to avoid pressing the brake pedal all the way down and excessive braking loads.

New tires also have a break-in period. Please drive cautiously for the first 600 kilometers. This new engine had to go through a 1500-kilometer run-in.

The friction resistance of the mosong qin two hours before the engine runs is greater than the friction resistance after the break-in. During the running-in process, the engine speed should not be too high, preferably not more than 4000rpm.

Millions of car purchase subsidies.

Volkswagen Suteng run-in period and the first warranty period are all 7500 kilometers, the important content of the first insurance is to rent acres to replace the oil filter, because at this time the car oil has more metal material chips, if not immediately replaced, it will affect the performance indicators in the middle and late stages, aggravate the damage to the car engine and then affect the use of the life of the sakura. The first insurance is completely free, please book with the car 4S shop in advance, and bring the documents with the car ridge line and the first insurance card is completely free.

In the initial range of 200 to 300 km, the new brake pads do not have the best braking effect, and they need to be "running-in" first. In this section, a slightly reduced braking force can be compensated by increasing the braking pedal force. During the running-in period, when the brake pedal is pressed to the end or emergency braking, the braking spacing is longer than that of the brake pads.

During the running-in period, it is necessary to prevent the brake pedal from being pressed to the bottom and the brake load from being too large.

There is also a break-in period for new tires, so drive carefully for the first 600 kilometers. The new car engine must go through 1,500km running-in, the friction resistance of the car engine in the first two hours of operation should be greater than that after the run-in, and the speed of the car during the run-in period is not too large, preferably not exceeding 4000rpm.

Millions of car purchase subsidies.

Run-in period: within 1 year after the purchase of the car.

The first two years after the purchase of a new car are the complete period of vehicle function, which can be said to be the time when the car is in the best condition, which is equivalent to the youth of a person. If there is any fatal quality problem with the vehicle, it can basically be found within a year.

If there is no quality problem, then the vehicle is in excellent condition at this stage, and as long as regular maintenance is carried out, there will be basically no problems. During this phase, everyone should pay attention to safe driving.

Volkswagen Sutar has a run-in period of 3,000 kilometers. Although the current car technology is excellent, there will still be a run-in period for new cars. Please pay attention to the following: how to use the new car correctly during the run-in period, how to use the new car correctly during the run-in period He Qianxiang.

1.Do not brake suddenly.

Emergency braking greatly increases the impact on the engine and chassis, and Zen stupidity is also a great damage to the car's braking system.

2.Do not drive at high speeds.

Especially if you like floor oil, it will greatly increase the operating load of the engine, which may cause premature strain of the piston and crankshaft parts. The engine speed should not exceed 3000 rpm.

3.The load should not be excessive.

The increase in load and fuel consumption is trivial, mainly because the high pressure accelerates the damage of parts. Better practice, the bearing capacity should not exceed 70% of the standard load.

4.Use high-quality fuel.

Poor quality fuel can clog the oil lines, so be sure to use fuel that meets the standards.

5. Cold start and preheat first.

When the car just starts, the engine temperature is low and the lubricating oil is not in place, which is easy to cause dry grinding of parts. The warm-up time should not be too long, and the car can be started when the operating temperature is reached.

6.The gear should be appropriate.

Anyone who has ever studied manual transmission should know that when the gear does not match the speed, you need to be vigilant. Remember high, high, and low gears.

Millions of car purchase subsidies.

The run-in period of Volkswagen is 3,000 kilometers. Despite the excellent machining technology of the current car, there will still be a break-in period for the new car. How to correctly apply the new car during the run-in period, and how to correctly apply the new car during the run-in period, we must pay attention to the following matters.

1. Do not stop in an emergency.

The emergency brake pedal seriously increases the impact force on the engine and suspension of the car, and it is also a huge hazard to the brake system of the car.

2. It cannot be used by car.

Especially for those who love floor oil, the huge Jian Feng greatly improves the operating load of the automobile engine, which is likely to cause premature muscle strain of the piston rod and engine crankshaft parts. The speed of the car is not suitable for exceeding 3000r min.

3. The loading should not be too heavy.

The increase in load capacity and fuel consumption are trivial, mainly because the burden of high toughness will accelerate the destruction of parts. It is better to have a bearing capacity of no more than 70% of the standard load.

4. Apply high-quality fuel.

Shoddy fuel is likely to clog the pipeline, so try to use qualified fuel.

5. Heat up the cold car before starting.

When the car is just running, the temperature of the car engine is low, the grease is not in time, it is very easy to cause the parts to be polished, and the heating interval does not need to be too long, so that the operating temperature can be run.

6. The gear should be suitable.

Those who have learned the manual gear need to understand that the gear and speed are not paired must be careful, remember the fast medium and high-end, and the low gear of the downspeed.

Millions of car purchase subsidies.