New machine failure problem Please advise 10

Whether the symptom is to click the power button, the indicator light is on, the monitor does not reflect, the self-test does not reflect, it will automatically turn off after about 2 seconds, and then automatically turn on again, and then turn off in 2 seconds. Repeating the cycle?

If so, don't neglect the memory in addition to checking the power supply and motherboard! Memory failures can also cause this phenomenon!!

It's not that your memory is not in good contact or 100% bad, but it is caused by poor compatibility, and fake Kingston favorites to have this symptom, and it may be fine if you change to another motherboard.

1.Redo the system.,I encountered this kind of machine a few days ago.,It's just that it's automatically logged out and then hibernate after going into XP.,Solve it after redoing the system.。

2.The monitor doesn't light up? Is your monitor plugged in?

3.It shouldn't be a memory problem, and the memory problem can't be a long beep alarm when booted.

4.The power supply is a cheap and inferior power supply, and it is a bulk power supply that is not certified, and the shutdown is caused by power supply problems.

5.If the motherboard is damaged, find a manufacturer for repair.

Carefully check the connection between the case and the motherboard, check the motherboard manual to see if there is any wrong plugging, if there is no suggestion, also unplug and re-plug the side, it may be a mistake or poor contact.

The switch is not very flexible, it can't pop up after pressing it, it is in a straight state, and it only pops up after a few seconds. If the monitor does not light up, it may be that the graphics card is not plugged in.

Is the CPU overheating, check the CPU temperature. Or see if the North-South Bridge chip is overheating.

If you don't want to change the cable between the case and the monitor, try it if you can use it.

The reason for the motherboard.

Go to the workshop for testing.

Summary. Hello dear, according to the situation you described, it is not normal, because of the effect of damage, the appearance of the myocardium is defective is a substandard product, and it should be returned to the factory in time when it leaves the factory, and it can be replaced and repaired before it can be used normally.

There is a condition in the new machine, and I don't know if it is normal or not.

This is the case with new machines.

According to the situation you described, it is not normal, because of the effect of damage, the appearance of the myocardium is defective and it is a substandard product.

No, it opens the software slowly.

There is a circle next to the mouse, whether it is a computer problem or a network problem.

Hello dear, according to the situation you described, 1. Right-click "My Computer" - Properties - Hard Branch Brief - Device Manager - IDE TAT ATAPI Controller - Secondary IDE Channel - Advanced Settings - "Device Type" Select "None", "Transfer Mode" Select "DNA (if available)" - Mengpai - Other Fiber "Secondary IDE Channel" and "Primary IDE Channel" are also the same settings. 2. Same as above, it is also in "My Computer" - Properties - Advanced - Performance - Settings - Adjust to the best performance 3, Startup and Failure Recovery - Remove all the checks 4, System Restore - tick "Turn off System Restore on all drives" 5, Auto Update - Turn off Auto Update 6, Remote - Turn off all.