Can the line of AKG K450 not be unpulled

From the perspective of service life, the effect of non-unplugging is better, because the gold plating layer of the pin will wear out under the condition of frequent insertion and unplugging, which is easy to cause poor contact and abnormal pronunciation. And K450 earphones have a serious design mistake, if the telescopic rod is often pulled, it will cause the head beam line (there is a wire under the steel bar on the top of the head, connected to the speaker of the right ear) to break, resulting in the right ear does not ring, this situation is very common, if you have time, you can take a look, basically half of the users will have this kind of problem, so K450 earphones in daily use, pay attention to these points: first, the earphone cable should not be plugged and unplugged frequently; Second, the telescopic rod should not be pulled frequently, and when generally used, it can be fixed in a position suitable for your head shape; Of course, when you go out to carry headphones, it is safer to disassemble the headphone cable and put it in the storage bag, but you must pay attention to the above two points if you can avoid it, you can get it a few times occasionally, remember not to operate frequently, in this way, you can effectively extend the service life of the headphones by more than double!

Don't pull it out.,There's only a good thing about the headphones.,It's easy to break if you pull it out more.,Make the headphone cable into a roll before putting it in the box.,Reserve a little length and put it on the top of the grid of the box.,No effect.,I use k452

You can not pull it out,,, no matter what it is...

1.**Most of the so-called original wiring on the high imitation.

This price point is extremely cost-effective, so it is not recommended.

I was deceived by the so-called post on the Internet to improve the sound of changing the line, and spent more than 200 yuan to buy the Fortress line on the **, uncle's, the sound has not improved at all, how do I feel that it is not as good as before, the low frequency is still scattered and not tightened a lot as said on the Internet, the only benefit is that the quality of the wire has improved, much thicker than before! Maybe I'm not an audiophile and my voice doesn't improve! In short, the line change is not much different from before.

Didn't change the line.

But someone in his group has changed.

It's not more of a tuning difference than a quality difference.,It's not stuffy.,There's less low frequency (Furukawa line)In addition,I think K450It's not much point to change the line.,It's such a quality.,There's no need to invest so much to change the line to get a trace of improvement.。

There is no other way than the return of origin, and the same situation is passed by - to solve it

It can be screwed, but not at 45 degrees, but at 90 degrees. However, I advise you not to twist it too often, and unplug it often. The plug of the 450 is relatively tight, and if it is often unplugged and unplugged, the plug will be damaged, and it may also lead to poor contact.

Yes. Impactful. This kind of audio cable is not good either. Because the amplifiers also process the audio signal. So it's good that no audio cable is required.

If you need it, you only need to twist it for half a week, about 45°.

K450 is not a headset that can replace the cable, and its own cable is very ordinary, that is, an ordinary cable. If the thread is broken, it will be better than the original thread if you buy one on the **. I'm sorry, I was wrong.

It's K420. 450 can be changed, and it is sold again.

There are a lot of lines on the K450 **...

There will be a negligible change in the K450 upgrade line, but it is really not necessary on this low-end K450 (what grade of horse with what grade of saddle). 1. If you want to improve the sound quality, it is recommended to buy 2000 to 3000 large earphones or earbuds (there is no doubt that the sound quality of large ears at the same price is definitely more than that of earbuds) 2. If the original line is damaged, it is recommended to buy more than 30 yuan in **. The original wiring of any grade of headphones is the most suitable for it, and the manufacturer will naturally adapt the appropriate wire according to its grade, and there will be changes in the line, but whether this change is an "upgrade" should be a question mark.

If you want to improve the sound quality of your portable device, you can only upgrade it from the "audio source file, front-end, and headphones", and the headphone cable is secondary and you don't need to think about it, because when you buy the headphones, the manufacturer has already adapted the right cable for you.

There is not much need, if you want to upgrade, you can choose a silver wire according to the price, you can appropriately reduce its excessive low frequency and increase the gloss of high frequency, and the overall sound will be **.

Yes, the premise is that the remote part must have a microphone and the plug corresponds to the mobile phone, but welding is difficult, because the remote control is small and needs to be accurate and can restore and fasten the remote after welding, so it is not recommended to try.