Foton Monpai Kamitsu turned on the air conditioner engine shook what was going on

Updated on Car 2024-04-15
8 answers
  1. Anonymous users2024-02-07

    The main cause of idle jitter;

    1. The most common cause of car shaking is that the throttle valve is too dirty or the fuel injector has too much carbon.

    2. When the carbon deposition inside the engine is too much, the gasoline sprayed by the cold start fuel injector will be absorbed by a large amount of carbon deposition, resulting in the mixture of cold start being too thin, making it difficult to start, in this case, only when the gasoline absorbed by carbon deposition is saturated, it is easy to get started, 3. After the car is adsorbed, the gasoline adsorbed on the carbon deposition will be sucked into the cylinder by the vacuum suction of the engine for combustion, and the mixture becomes thick, and the combustible mixture of the engine is dilute and thick, resulting in idle shaking after cold start. The lower the temperature, the greater the amount of oil required for the cold start, and the more carbon deposits will affect the smooth cold start.

    Severe idle vibration is generally caused by engine cylinder failure, aging or loose foot rubber, carbon deposits, fuel system failure, etc.

    1.Serious engine carbon deposits: Cars always have the problem of carbon deposits, including cylinder carbon deposits, throttle carbon deposits, spark plug carbon deposits, intake carbon deposits, etc.

    When the engine has too much carbon deposit, it will affect the ignition energy, air intake efficiency and air-fuel ratio of the car, resulting in the unstable power output of the car, and the phenomenon of idle speed and acceleration jitter appears.

    2.Unstable oil pressure: If you have cleaned the engine carbon deposits, cleaned the throttle, replaced the oil gasket and spark plug, etc.

    And when idling, you still find that the body shakes, it is recommended that you go to the 4S shop to check whether the oil supply pressure and intake pressure sensor are normal, if the oil pump supply pressure is abnormal, or the intake pressure sensor value is wrong, and the work is not good, it will cause the body to shake.

    3.Engine cylinder shortage: Engine cylinder deficiency mainly refers to the engine one or more cylinders are not working properly, which is generally manifested as:

    The exhaust fumes coming out of the car are obviously intermittent, and the exhaust pipe shakes violently, and the engine shake can be clearly felt, sometimes accompanied by abnormal noises. This is mostly related to ignition coil failure.

    4.Aging of engine parts: Shake in the car is also associated with the aging of the engine feet (also known as claw pads).

    The engine foot is actually the shock absorber system of the engine. The engine feet are responsible for absorbing slight vibrations when the engine is running. If there is a problem with the engine base, these vibrations can be transmitted to the steering wheel and cab, causing vibrations at idle.

    Solution; The best way is to clean the oil circuit, clean it regularly, and use PNF fuel additives to solve the above problems caused by carbon deposits. The fuel quality is not very good or the initial fuel of the new car is stored for too long, resulting in a rapid increase in the colloidal composition of the oil circuit, which will continue to pollute the fresh fuel and cause no good fuel to participate in combustion in the later stage, and the carbon deposition exceeds the standard, which is especially common for China VI vehicles. We can only gradually alleviate most of the problems by maintaining clean oil circuits.

  2. Anonymous users2024-02-06

    Carbon deposits can cause insufficient combustion of gasoline and cause the engine to shake. The impact of engine carbon deposition on the car is quite large, first of all, to reduce the engine power, that is, to make the power output uneven and gradually decay, in other words, more and more powerless. The second is to increase fuel consumption and increase your financial burden.

    The third is the difficulty of cold start, that is, the difficulty of ignition, it is not easy to get on the car, and finally the carbon deposit in the combustion chamber is strict, and a heavy one will also cause cylinder detonation, and there will be a sound of low-speed acceleration, which will cause damage to the piston and crankshaft, and cause high temperature of the engine, which will seriously affect the safety of the car. Then there is the excessive discharge, which not only fails the annual inspection and inspection, but also directly aggravates the harm of polluting the environment.

    There is another reason: the throttle valve is faulty. Both of these problems can cause engine shake and unstable speed.

  3. Anonymous users2024-02-05

    The ultimate reason for the high water temperature of the water tank is the poor heat dissipation of the engine, the engine load is large when the air conditioner is turned on, the amount of fuel injected is large, and the heat is generated, and the water temperature will be high due to poor heat dissipation of the engine.

    Causes of poor heat dissipation:

    1) There is too much scale in the water tank and engine jacket, resulting in poor heat dissipation and increased water temperature.

    2) The thermostat is damaged and cannot be opened, so that the coolant can not enter the water tank smoothly to form a large circulation, so that the water temperature rises quickly and causes the pot to boil.

    3) The pump is damaged or the transmission belt is slipped, resulting in poor working of the pump.

    4) Lack of antifreeze and poor engine heat dissipation.

    5) The cooling fan does not rotate or the speed is low.

    Solution: 1) Clean the limescale inside the engine.

    2) Check or replace the thermostat.

    3) Check the water pump water volume, check or replace the water pump.

    4) Add antifreeze to sufficient as prescribed.

    5) Check the reason why the fan does not rotate or the speed is low.

    Summary: The engine water temperature is high, which can have a great impact on the engine, and may damage the engine in serious cases.

  4. Anonymous users2024-02-04

    To detect the junction thermostat, you can go to the car wash and flush the water tank and condenser.

  5. Anonymous users2024-02-03

    The shortcomings of the easy solidification of diesel, which is most concerned by users, have been completely overcome by Foton Monpac, and the test has shown that the Montpac diesel-powered MPV can be started smoothly in any alpine region in China.

  6. Anonymous users2024-02-02

    It's okay! Mitsubishi's engine....Theory oil hao six or seven hairs! Actually, it depends on how it opens....

  7. Anonymous users2024-02-01

    What is the specific fault** [There is a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

  8. Anonymous users2024-01-31

    Hello dear, according to your description of the fault lamp lit, it is recommended that you use the fault diagnostic instrument to analyze what is caused by the finch respect, specific analysis, dear, [cavity grinding car problems, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Related questions