Red alert LAN connection, how to connect red alert to LAN

Updated on technology 2024-04-13
6 answers
  1. Anonymous users2024-02-07

    No matter what version of Red Alert can be connected, it is a problem with your computer's IP settings, and you do not have a protocol for LAN data exchange installed, so you can't play against LAN.

    Workaround: Right-click Network Neighbor -> Properties -> right-click Local Connection -> Properties -> click Install -> Protocol ->Microsoft->nwlink IPX SPX NetBios Compatible Transport Protocol ->OK.

    That's it.

    Name the names of the two of you can't be the same, I wish: success and have a good time!!

  2. Anonymous users2024-02-06

    Right-click on Network Neighbor -> Properties -> right-click Local Connection -> Properties -> click Install -> Protocol -> Microsoft-> nwlink IPX SPX NetBios Compatible Transport Protocol ->OK. In the game, select "Settings" - Network - Network domain name fill in 00 and fill in the next column.

  3. Anonymous users2024-02-05

    This is because the registration code of your game is the same, in order to protect the copyright of a game can only have one registration code, if the registration code on the game on the two machines is the same, it cannot be online, the solution is to use the red alert registration code modifier to modify the game on one of the machines, or from another**address** a version of the game (be careful not to go down to the same anymore).

  4. Anonymous users2024-02-04

    Is it in an Internet café? A LAN is a network! Click in, and each player can play without having the same name. But there are also Internet cafes that can't be connected!

  5. Anonymous users2024-02-03

    The problem with the serial number is to find a modifier online.

  6. Anonymous users2024-02-02

    Tools required: computer, red alert.

    First, you need to open the Red Alert game and enter the interface, as shown in the figure below.

    2. After entering this page, select the option, and the game options interface will pop up, as shown in the figure below.

    3. Then click Network to enter the settings page. This is shown in the figure below.

    Fourth, set the target network, both online computers set the target network to: This is shown in the figure below.

    5. Click OK to enter the main interface, click on the network, and you can start to join the LAN game. and you're done.

Related questions
11 answers2024-04-13

The airdrop building bug is only available in the most rubbish versions, and the version that has undergone a few upgrades will not work. >>>More

15 answers2024-04-13

The patch is installed incorrectly, and the general campaign jumps out and installs the patch If you are a cracked version, please install the cracked patch If it is genuine, do not use the cracked patch And the patch installation location is the game root folder of Red Alert 3 Don't press the wrong one.

10 answers2024-04-13

The main technical parameters are bandwidth speed, bus mode, and electrical interface mode. Hub: Mainly refers to a shared hub. >>>More

6 answers2024-04-13

As far as I can tell, there are probably the following scenarios: >>>More

5 answers2024-04-13

Hardware devices typically required for enterprise LAN installation: firewalls, routers, switches. >>>More