-
A friend on the 5th floor said very well that this kind of ball is quite difficult! Even for a professional golfer who has been professionally trained for several years, only 3 out of 10 may be able to play.
The level of the people who hit this ball is absolutely high! The landlord may wish to try the method on the 5th floor.
I think I should be able to play it, and I've played this kind of ball unintentionally. It's just a blind shot, and after the fact, 100 rods in a row. I can't hit it, but I remember that I didn't use any force at all, and the rod was hit in the middle of the white ball, and it was rubbed down, and the white ball did feel like it was stop-and-go, and the moment it hit the target ball, the white ball felt like it was moving back a little bit slowly, and then it suddenly started to run back strongly.
But I did it afterwards, but I just couldn't get it. But I really think that you don't need to use force to play this kind of ball, I remember watching O'Sullivan also hit the kind of ball that a friend on the 5th floor said in August: the distance between the two balls should be in the tee position to the bottom bank, and then retracted to the bottom bank.
I was dumbfounded when I saw this ball, and even the commentator of CCTV-5 didn't know how to hit it. Later, when I came to my senses, I thought that he hit this ball because he felt that the rod was very light and he didn't use any force. As for shrinking by 1,2 meters at close range, that's a minor problem.
My takeaway is to shoot low (find the cut-off point where you don't think you can jump) and make sure you hit the ball at a level quickly. The gun must be fast. There is also more practice.
-
It's very simple, as long as the position of the shot is at the bottom of the cue ball, but not too low, otherwise it will become a jump ball...
-
The lower the bottom of the club, the better, the back of the hand as much as possible, and the ball should be level when hitting the ball
-
It is quite difficult to close the ball from a distance, and in one year in the league, Eberton played an ultra-long distance reduction shot, and the distance between the two balls should be in the tee position to the bottom bank, and then retracted to the bottom bank.
Therefore, the long-distance rod reduction must show that the basic skills of people are solid.
As for the main points: one is the accuracy of hitting the ball, and the other is that the hitting power must be large and the frequency of action must be fast. Remember not to hit combos, the so-called "combos" are when the clubhead touches the ball and pushes the ball forward an inch or two, which is an action that happens in a split second, and this small detail will affect the effect of the rod reduction, in fact, most people, even experienced people, may not notice this problem.
-
Billiards shrinking rod is also known as the pull rod, which can make the cue ball collide with the first target ball, and roll back in reverse direction until it touches the second target ball, which is a kind of billiards skills.
The tips for shrinking the rod are as follows:
1. When hitting the ball with a club, the force should be fast and fast.
2. Pay attention to the extension of the cue, and also advise not to immediately withdraw the cue with the cue, which will cause insufficient force, which is commonly known as shaking the wrist.
3. Use more swing of the little arm, especially in the case of unstable back hand, and less swing of the wrist to exert force.
4. The cue stick should be flattened as much as possible, because if the cue ball is placed diagonally, when the cue ball is hit, it will cause a part of the downward component, resulting in the low club is not strong.
5. When aiming at the ball, the nearest point should be as close as possible to the cue ball, not greater than centimeters, firstly, it is conducive to improving the accuracy, and secondly, the force will be closer to the expected value when you aim at the ball, so that the force is sufficient.
-
Hit the bottom point Billiards is a lot to learn The shrinking rod you are talking about should be the pull rod After the cue ball hits the ball, go back? If you hit the cue ball directly below with the head of the club, he will retract in a straight line If it is a little to the left, it is the left retraction rod CCTV generally says the left low rod If it is right, it is the right retraction rod, also called the right low rod, this thing can be understood, I don't know if you understand.
-
Rub the powder well and avoid the slider. The front hand drives the V fulcrum low, the back hand holds the rod horizontally, and the leather head is aimed at the center point of the cue ball about 2 cm down (there is no need to hit it too low), the shot is straight and fast, and there is a pause after the leather head hits the cue ball.
-
You go to snooker8 to take a look at the specific information.,The details are a bit much.···.
-
When you shout "shrink" when you come out of the pole, it will come back.
-
At the bottom of the game, there is a feeling of closing immediately after playing, like the kind of contraction that your body automatically reacts to when you hit something very hot.
-
The rack should be as low as possible so that the club is nearly parallel to the table. Hit the middle and lower part of the white ball and hit the white ball through. From point A to point K, it is about the distance of three balls from the stroke.
-
First of all, you replace "shrink" with the word "low", and you will naturally understand later.
Set the ball, when the white ball is not far from the target ball, if the distance is far, then the middle of the ball is the distance of one or two club heads, this depends on the situation, the force is not easy to grasp. Shrink the rod, hit the white ball just down, try to go down, but not too close to the mud, you can try to grasp it yourself. The farther away the retract rod, the harder it is to hit. >>>More
I also like to play billiards.
Theoretically, the lower the point of impact on the cue ball, the stronger the drawdown. But there are often mistakes. >>>More
Maybe you misunderstood, it's not the meaning of not using force at all, the force of the big and small arms is joint, and it is impossible for the big arm not to use the force of the small arm, but the big arm can't see the movement when the force is forced, and the side view is the swing of the small arm, and the big arm looks like it is not moving. This is what I usually do when I practice, and the big arm is not moved to better control the stability and strength of the shot, so this is generally the standard movement. Hope it helps.
Only the ideal state does not consider friction, and in this practical problem, friction must be considered! >>>More
1 There is no such thing as an intelligent processor or a Xeon processor, but the so-called intelligent processor is the latest technology added to the i-series processor. The i7 has this technology. >>>More