Help Problems with system installation

It should be a bad sector in the hard disk, and I personally feel that unless there is a big mistake in the hard disk, such as the damage of the platter, it is necessary to be cautious and low-level operation, and the damage to the hard disk is too great. It is recommended to use the XP2 disk to install and format normally, the formatting of the XP system is a format with the least damage to the hard disk (VSTAR has not been studied), install the operating system normally, and use fast FAT32 to format it once before installation and then install it directly.

It will be affected, it is recommended to reformat the entire hard disk first, not fast format, because fast format can not repair the small problems in the hard disk, so do not use fast format, so see if the format can pass, if not, it means that the magnetic conductance is seriously damaged, and it must be solved by low grid or 0 track of the mobile hard disk.

It could be an issue with the hard drive. Try 100% low grid. If it is done successfully, the hard drive will be fine

If the hard drive has serious physical bad sectors. Low tiles cannot be completed 100% of the time. At this time, you can try to hide the part of the bad zone. Good place to zone

Check first to see if there's something wrong with your hardware! If it's okay, you can wait for a while before reinstalling the system, or try a different system disk.

It may be that the hard disk cable is not connected properly or that it is not good.

Otherwise, your hard drive will break.

It may be that your hard drive is too large for DM to support.

If your machine is old, there is no secret, but it should be noted that your installation version is not the original, and it is recommended that an xp1 is also recommended, xp2 is much slower than it (if you don't require some special use professionally).

Disk problems, try to change the card.

If you have a problem with your disc, it is recommended to change the disc.

It is recommended to lf once, dm, redo the system.

I have a computer troubleshooting card here, intentional mmm

My system disk sometimes has a situation like yours.

You turn it on, turn it on again after a minute, and reinstall the system.

Sometimes it stops, you don't care, it will pass.

It's not a big deal, just reload.

PS: Make sure your system disk is fine.

Please ask whether your machine is new or old, consider your system disk for the new one, and consider whether there is a problem with your hard disk for the old one.

You spend a few dollars to buy a new system disk, don't use quick format when installing it, it should be installed smoothly!

First of all, the installation directory and the installation file directory are in English, secondly, the installation file can be run in compatibility mode, and finally win8, it is best to install and above versions.

It's not because you're using a win7 system that you can't install the XP system!

The prompt is the problem of the disc or optical drive, and the problem of changing the disc or changing the optical drive will be solved!

Generally, there are several situations where A: Error occurs:

2.Disc quality: The recovery failed due to the purchase of the disc or the quality of the burning disc.

3.Optical drive quality: The recovery failure is due to the aging of the laser head in the optical area and the decrease in the ability to read the disk.

4.Recorder: The recovery fails due to the poor recording quality of the recorder or the quality of the burned disk due to aging.

5.Burning method: The disc is not easy to read due to the burning speed being too fast, it is recommended to choose 16x 24x speed to burn at a time.

6.Over-burning: Recovery failure caused by incomplete data due to exceeding the capacity of the burning disk, which is generally suitable within 680m.

7.The hard disk has bad sectors: The ghost cannot be written because of bad sectors.

8.Hard disk problem: Format the C drive completely, do not add Q (e.g. format c:).

9.Hard disk without drive letter: Recovery failure caused by virus or other loss of partition table.

10.Overclocking: Recovery failure due to unstable overclocking.

Happy every day!!