Invalid media type reading drive C abort,retry,fail when installing ghost xp with one click? What to

Change to a ghost version If there are some different versions of the backup, you need to restore it with the same version.

I don't know about anything else, but I know the last word that failed, and it's not a disk problem, it's a CD-ROM problem.

Check the partition format of the E drive, most of which are caused by partition errors. It is recommended that you back up only the C partition. There is no need to back up the whole disk, and you can choose other partitions as backup and save the disk!

I only read the D disk, the partition is wrong, please redivide the disk, kid, don't worry, don't worry, it's not a big problem, it's just that the partition is a little problematic, it is not recommended to use the opinion partition, and the manual partition is more stable. Are you using a USB flash drive to install it?,C disk is defaulted to C disk.。

The system can't find the hard disk, you need to go to the BIOS to set the hard disk mode.

Use a USB flash drive to install it, and the format of the hard disk is not complete. It is very convenient to make a startup item on the USB flash drive.

There is installation software in PE.

Use the installation directly.

Formatted with NTFS.

abort retry fail means ignore retry failed, which prompts you to select the command with the first character. Generally, if you hit a to return to the dos command, your situation is that there is an error in accessing the partition, heh, the disk you are accessing may be the optical drive. However, the driver of the optical drive may not be loaded when starting the DOS.

So can't access it. It is not necessarily a hard disk failure, generally speaking, the floppy disk is bad or a partition boot sector is bad, and this prompt will also appear when the liquid is closed to access this floppy disk or partition under DOS, it is recommended to see if you can open this partition under Windows, and when it can't be opened, it means that there is a problem in this partition, try to crack the partition. If it can't be formatted, it means that the hard drive is broken.

It means that the C disk reads and writes the crack with error, does not know the type of cavity plexus, ignores, retrys, cancels.

If the 63-sector I-O table of the hard disk is damaged, you can use Disk Utility to restore the I-O table of the 69th sector to the 63rd sector to overwrite, and the data can be kept intact.

Generally, DRIVE A is a floppy drive.

Check if there is a disk in the floppy drive?

After pressing A, the Abort operation is executed.

So I went back to the prompt d: > before this operation

Correct operation. You can put a formatted floppy disk in the floppy drive.

Press r and retry.

Check your C drive, it should not be formatted.

You're using a dish, right? The system on the disc is broken, and you change the disc.

The system driver file is gone, it has been corrupted, and the system is changed!

Translation: G disc drive without disc.

Press a to ignore. Press r to try again.

Press F to end. It may be that the optical drive is damaged.

The DM or PQ reformatting of the ghost belt cannot be installed without a D disk.

You use the Ghost with the Windowspe system to boot it up and see if the D drive can read and write.

Or try it on a different plate.

You format the hard drive and then set the C drive as the active partition to see.

Change the format of the hard disk under the BIOS.