How to install trekking poles, how to install trekking poles

Hold the trekking pole and stand on the plane to adjust the length of the trekking pole, the arm hangs down naturally, use the elbow as the fulcrum, raise the forearm up to 90 degrees with the upper arm, and then adjust the tip of the trekking pole down to touch the ground; Or place the head of the trekking pole 5 8 cm under the armpit, and then adjust the tip of the pole downward until it touches the ground.

Lock all the poles of your trekking poles. Another trekking pole that has not yet been adjusted can be adjusted to the same length as the locked pole. Trekking poles should not be adjusted to exceed the maximum length shown on the poles, and the length adjustment can be made when purchasing trekking poles to determine whether you have purchased the right length of trekking poles.

The strongest state of the three-section adjustable trekking pole is when the length of the three-section pole is the same, so do not extend only one section of the pole without using the other pole, or exceed the warning scale of the pole, which will cause the trekking pole to be easily bent and deformed and cannot be used.

The best way to use it is to adjust the other two extendable poles to the same length, which will ensure the support strength of the trekking poles and also increase the life of the trekking poles.

Loosen counterclockwise, pull to the predetermined length, and tighten clockwise.

Most of the trekking poles are sectional, the structure is an internal spring, the second section is fixed by the hoop force generated by tightening after the thick pipe sleeve and the thin tube, and the elastic spring inside will reduce the vibration caused by the trekking pole point on the hard ground, and the use of trekking poles can reduce the waste of physical strength when climbing.

Insert the spring head of the trekking pole into the previous section of the tube, most of them are tightened clockwise, and some trekking poles also need to be slightly slightly twisted counterclockwise, the effect is to open the spring structure, and the trekking poles are tightened with an external fixed buckle, similar to the buckle principle of the lock cup.

Question 1: How to install trekking poles Loosen it counterclockwise, pull it to the predetermined length, and then tighten it clockwise.

Question 2: How to install trekking poles Loosen it counterclockwise, pull it to the predetermined length, and then tighten it clockwise.

Question 3: How to install trekking poles Loosen them counterclockwise, pull them to the predetermined length, and then tighten them clockwise.

Question 4: Help! My trekking poles were pulled out by me and I can't install them now! Twist the expanded plastic block on the head of the trekking pole that is pulled out in the opposite direction of the lock, and after the expansion is sent, put it back on the previous trekking pole and tighten it again.

Question 5: How to install a camera gimbal on the existing trekking poles The key is to see if there are screws needed to install the gimbal on the top, the common ones are 1 4 and 3 8. If you have this or can modify it yourself, you can install the gimbal, the trekking pole is equivalent to the monopod, and it is more suitable for the monopod special two-pin Shenwei gimbal.

You can refer to a detachable monopod at Benro, and the top can be installed as a walking stick, a tripod for trekking poles, which is a reason.

Question 6: MBC M 200 trekking pole Installation of the wristband Pull out the wristband rope, there is a small beam in the middle of the pole head, thread the rope through, and then choose the appropriate length, and put the small joint on the wristband **Go to OK.

Question 7: How to use Robinson trekking poles, and can they be packed in the bag Hiking bags all have an external system, and there are special places to hang trekking poles. It is not recommended to put it in the bag, it will break the bag.