Ask about the configuration of the street basket, please solve the problem of the street basket game

Upstairs, you get a Pentium 3+256 memory to play fs2008?

Upgraded to 2008, the configuration has also been improved a bit! Your memory is enough, I suggest you go and replace the processor and get a Pentium 4, but this thing is also old, it's not easy to buy, but it's cheap! My home is Pentium memory + independent display 128 when reading the game, the picture will also be a little stuck!

The network speed should be at least 2m, otherwise no matter how good the configuration is, it will kill you.

The network speed requirements seem to have increased, how many meters is the Internet speed of your home?

It should be at least 2m

I've seen it. I seem to have had this problem before. But it doesn't seem to be the reason for street basketball

It should be the relationship between the system、I suggest you still look for the reason for the system。 I used to be reloaded.

The hoop should be made of solid iron bars with an inner warp of meters and painted orange. The diameter of the ring bar is a minimum of meters and a maximum of a meter, and the lower edge of the ring is provided with a small ring or something similar to allow the net to be suspended. The hoop should be firmly mounted on the backboard, preferably on the structural frame of the backboard, so that the force on the hoop will not act directly on the backboard.

The top plane of the hoop should be horizontal, meters from the floor, equal to the distance between the two vertical sides of the backboard, and the closest point between the backboard surface and the inner edge of the hoop is meters.

First divide the net, then build a ladder, stand up, put one end in it, pull it down, and finally throw two balls to open the net a little bit, and it's OK.

You need to build a ladder to the basket and take a look.

Wrap the net bag you bought along the basket with wire on it, and just tie the net bag to it.

Thread the wire through the net and fix it.

Thread a thin wire on the net, and then thread the thin wire to the basket, which is very simple.

Just buy a few more ticks.

Let's see what others have to say.

Laptop or desktop? Reboot it first and try it!

If not, the method of reinstalling the system is roughly the same, find a way to enter the BIOS interface, usually F2 or F12, and some may have a small button to enter directly.

After entering, adjust the boot option to disk boot, so that the system can be booted from the system installation disk, and install the win system after starting, and the decoration driver can be.

It can be installed with either a USB flash drive or a CD-ROM disk.

Analysis: BSOD is usually caused by software or hardware failure, and the reasons are many and complex, such as system file corruption, virus infection, too many self-starting programs in the background or multiple security software installations causing the system to freeze death, or problems with the graphics card or memory. Its errors** are generally not definitively diagnostic.

Suggestion: Reinstalling the system is the easiest and quickest way to do it, and if the system is successfully reinstalled, you can also rule out hardware problems.

1.Restart the computer, if you can enter the system normally, it means that the last blue screen was just an occasional program or system running error, and it doesn't matter.

2.If you have frequent blue screens or can't enter the system normally, press F8 immediately after booting to see if you can enter the safe mode or configure the correct mode for the last time, if so, enter and exit, and then restart to enter the normal mode.

3.If not, press F11 after rebooting to see if there is a one-click backup, and if so, one-click restore.

4.If there is no one-click restore, use the system USB flash drive to reinstall the system. After booting up, press the del key (notebooks are generally F2 or according to the bottom line of the screen prompt characters) to enter CMOS, and set the U disk as the first boot item.

Reboot into the boot menu of the USB flash drive, select Clone Installation, and then follow the prompts.