-
1: The steering wheel is not in a deadbolt state. The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing.
2: Did you not return the gear to P when you parked? Think about it, if the D or R gear can be ignited, the jump of the vehicle at the moment of ignition is undoubtedly a huge safety hazard.
Therefore, for automatic transmission vehicles (AT, CVT, AMT), the manufacturer will preset this mode, and repeatedly tell in the manual: make sure that the gear is in the P gear position when ignition.
3: One-button start sometimes encounters the trouble of power loss of the smart key, obviously the key is in the car, but the instrument always shows 'key matching error', this situation is likely to be the power loss of the smart key, and the starting system can not sense the weak radio waves emitted by the key. Therefore, it is recommended to pick up the smart key and put it on the start button, and then press the button to start.
4: Check whether the battery has power. If the ignition is not ignited, it may be due to the loss of power or the expiration of the battery life due to the long-term headlights have not been turned off, and the battery is generally replaced in time according to the maintenance manual.
5: See if there's oil. If the fuel gauge shows that it is below the red line, it will not ignite. At the same time, pay attention to the quality of the oil. There have been car owners who found that there was water and mud in the fuel tank after disassembling the car, and with such oil, it is impossible for the car not to break.
6: No antifreeze.
Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.
-
220's, in the lower right corner of the front windshield in the fuse box, on the right, the first, black square, I hope to give a thumbs up, thank you [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】
-
If there is no problem with the starter, the first thing to check is that the crankshaft position sensor is between the engine and the gearbox. You need to stand on the left front wheel and look down. This thing is a consumable part.
-
Hello, there are many reasons for this kind of problem, it is recommended that you contact the maintenance service station directly, I told you, you may not be able to diagnose it at once, this is also the most effective way to solve the problem.
-
Summary. Hello, Mercedes-Benz this car has a temperature too high and too low, can not start this situation, and gasoline pressure fuel injector carbon deposition valve carbon deposition, water temperature signal oxygen sensor and empty these places have a relationship, you can first check the places I said, if there is no problem, it is caused by valve sealing problems. After the cylinder head is disassembled, the valves are re-ground and the variable timing mechanism is replaced.
If a large amount of carbon is found, the engine needs to be thoroughly disassembled and then cleaned by ultrasonic.
Hello, Mercedes-Benz this car has too high and too low temperature, can not start this situation, and gasoline pressure fuel injector carbon valve carbon dust selling, water temperature signal oxygen sensor and empty these places have a relationship, you can first check my book said these places, if there is no problem, it is caused by valve sealing problems. After disassembling the cylinder head, re-grinding the valve and replacing the variable timing mechanism. If a large amount of carbon is found, the engine needs to be thoroughly disassembled and then cleaned by ultrasonic.
This phenomenon appeared intermittently, and after about ten minutes, it was able to fight again.
It may be caused by the mixture being too thick, check the fuel injector, valve carbon deposit and canister solenoid valve.
-
If this is the case, it is advisable to check the battery and ignition system . If there is no problem with the battery and ignition system, it is advisable to check the oil supply system and air intake system again. Most cars don't catch fire because of faulty batteries and ignition systems.
Batteries are an important part of a car. Without this part, the car would not be able to run properly.
Batteries are consumable parts and need to be replaced regularly.
When the engine does not start, the battery is responsible for supplying power to the vehicle's electronic devices, and the battery is also responsible for starting the engine.
When starting the engine, the starter, oil supply system, ignition system, etc. All require surgery.
The system above cannot operate without electricity. If the battery is dead, the car's engine won't start properly.
When the engine starts, the engine drives the generator to run.
When the generator is running, it can continuously charge the battery and can supply power to the electronic equipment of the whole vehicle.
As the number of charge and discharge increases, the performance of the battery also decreases.
During charging and discharging, the ions in the battery move through the electrolyte, and some ions react chemically with the electrolyte as they move through the electrolyte.
As the number of charge and discharge increases, the number of ions in the battery decreases, so the performance of the battery also decreases.
If you can maintain the correct car habits, you can effectively extend the life of the battery.
-
The Spike Ridge EMU does not catch fire, and there are several places to check:1. Check if your vehicle's battery is charged.
2.Check if the vehicle's oil system is clogged. 3.
Check that the engine's injectors are working properly. 4.Check that the engine ignition switch and spark plug are working properly.
Can the Mercedes not catch fire, can it be pushed and started.
It is not recommended to start. For automatic transmission models, it cannot be started by pushing. There are manual transmission models that have no problem. When dragging the automatic transmission model, it is also necessary to pay attention to the gear adjustment to infiltrate the N gear, otherwise it will affect the transmission of the vehicle.
The founding time of Beijing Benz.
The full name of the company is Beijing Benz Automobile Co., Ltd., which was established in August 2005 and is jointly funded by Beijing Automotive Co., Ltd., Daimler AG and Daimler Greater China Investment Co., Ltd., headquartered in Beijing, and produces Mercedes-Benz E-class, Mercedes-Benz C-class and Mercedes-Benz GLK.
Millions of car purchase subsidies.
-
Motor vehicles do not catch fire, there are several places to check:1. Check if your vehicle's battery is charged.
2.Check if the vehicle's oil system is clogged. 3.
The only thing to check is that the engine's injectors are working properly. 4.Check that the engine ignition switch and spark plug are working properly.
Can the Mercedes not catch fire, can it be pushed and started.
It is not recommended to start. For automatic transmission models, it cannot be started by pushing. There are manual transmission models that have no problem. When dragging an automatic transmission model, it is also important to note that you must adjust the gear to N gear, otherwise it will affect the transmission of the vehicle.
The founding time of Beijing Benz.
The full name of the company is Beijing Benz Automobile Co., Ltd., which was established in August 2005, jointly funded by Beijing Automotive Co., Ltd., Daimler AG and Daimler Greater China Investment Co., Ltd., headquartered in Beijing, and the models produced by Wu Pei are Mercedes-Benz E-class, Mercedes-Benz C-class and Mercedes-Benz GLK.
1. Start with an external power supply.
Bring the two cars close together, use a cable with sufficient bearing capacity and an insulating sheath, determine the positive and negative poles of the two batteries, and connect them separately to ensure the reliable connection of the cables, so that the engine runs for a few minutes to ensure that the power is sufficient. Then start the non-electric vehicle in the normal way, after starting, you should gently press the accelerator pedal, and turn off the ignition switches of the two vehicles and remove the cables after no problem. >>>More
Hello, ESP is an operation switch next to the emergency light switch, if you press it, it is to turn off the system, if you don't press it, use the detection instrument to check the fault, generally ABS speed sensor, 4, one of them is broken. Hope it can help you [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】
Teach you why the gas stove won't catch fire.
Hello! This is called start-up difficulty, and it may generally be caused by the following reasons. >>>More
Let's see if there's something wrong with the PC version? Remove the battery and put it back on, OK! >>>More