Why can t Pinnacle capture card software adjust the resolution?

Yes, yes. Now the mainstream** capture card,The supported resolution is 1024 768,The resolution of the display must be adjusted to such a when it is installed,So that when you open the monitoring interface, it can be full screen,When the driver and software of the capture card are installed,You can adjust the resolution of the display to others,For example1280 1024,In this way, the windows interface will be very clear,The monitoring interface can not reach the full screen。

It could be the monitoring software lock screen feature.

The problem of distance is not good, and the standards of individuals are different. Clarity, illumination, these are different, but also different.

Today's cameras have several fixed focal length lenses such as 6mm, 8mm, 12mm, 16mm, 25mm, etc., and the zoom all-in-one machine has 18 times, 22 times, 26 times, 27 times, and 32 times, and there are many zoom lenses.

You can choose according to the situation.

This problem is very common because the camera xenoplasm is not very high, and the image captured is less than 1028*768

The monitoring software only supports a resolution of 1024*768.

Look what kind of camera you are.

It doesn't matter if you zoom.

If it's a fixed focal length.

It depends on the actual situation.

As long as the child looks at it clearly.

The monitoring software supports this at the highest, and the fixed focus lens is limited, and the zoom is different. It mainly depends on your requirements to choose the material.

It could be a software version compatibility issue. Or the capture card is not suitable. You can look at the same three-dimensional one.

You can use the elimination method to solve the existing problem:

Eliminate whether there is a problem with the capture card and change the computer; Excluding the computer system is very unstable, it is recommended that you rebuild the system.

You said it could be used before, I think it should be a problem with the system.

What version of Pinnacle software are you using? As far as I know, Pinnacle's software cannot be opened without hardware, as you said at the moment, the situation may be related to your computer system, it is recommended that you do the system to see if there is a problem, and then check the interface problem,

Is it the reason for the poor interface contact?

When the gain is too low, some weak signals cannot reach the high voltage value, and cannot be distinguished during conversion.

**Zoom easy jam machine, I purchased Pinnacle 9 from 2006Now I've upgraded to.,The problem is that you didn't set 16:9 when the camera shoots**,My Sony hard disk SR100E camera is set like this.,There's no black bar.,Unless you're inserting 4:

This phenomenon only occurs when 3 of **.