How Do I Solve the Network Congestion Caused by the HUB?

Updated on healthy 2024-05-12
13 answers
  1. Anonymous users2024-02-10

    No, it can only be solved by replacing it with a switch, because the machines in the same hub belong to the same conflict domain, and the working mode of the hub is half-duplex, changing the hub is actually very simple, you only need to buy a switch with the same number of ports to replace it, it is recommended to use TP-Link products.

  2. Anonymous users2024-02-09

    Connection problems, if you use routing, it is a level 2 router, and the switch is also used below The top is the core switch, and it is very likely that the routing function above is not enough, and the backplane is low It is normal to cause this situation.

  3. Anonymous users2024-02-08

    This is a typical static IP binding. ISP in order to prevent you from using a router to do **. You can hit ** to tell them to unbind and let them tell them your router MAC address.

  4. Anonymous users2024-02-07

    This network mode does not support router sharing to access the Internet.

  5. Anonymous users2024-02-06

    Yes, because the hub sends data in the form of broadcasts, it would be better if you used a switch.

  6. Anonymous users2024-02-05

    The network cable connection method is incorrect, and the switch-hub is cross-connected (the original switch-computer network cable is used by the straight-through connection method).

  7. Anonymous users2024-02-04

    What is the code of your current connection?

    Network egress - main switch - hub you want to add - n computer switches and hubs can be cascaded.

    From any LAN port of your switch, the WAN port of the connection hub is on the line, and the cascade does not need to cross the line, which is the jumper method of dual-machine interconnection, and I do it on the LAN in our bedroom, which is very clear.

    If you are using the Internet by virtual dial-up (account password), you still need to route if you have a fixed IP, and the IP is not bound to the MAC, you can access it through the hub.

  8. Anonymous users2024-02-03

    After connecting to the hub, can the computer ping the router?

    If the pings are different, there's nothing to say, it's either a hub problem or a network cable problem.

  9. Anonymous users2024-02-02

    Test the hub, connect the two computers with the hub, connect the cable from the router after communication, if the situation is still the same, manually set the IP of the computer, and the router can be on the same segment.

  10. Anonymous users2024-02-01

    Easily troubleshoot five common types of LAN faults.

    The top 10 miracles can easily cope with the top 10 faults of the local area network.

  11. Anonymous users2024-01-31

    Hello! If your router has four LAN ports and your hub also has four LAN ports, the problem is very easy to solve.

    1. This step is the most critical. One LAN port of the router is connected to any LAN port of the HUB, note: the general HUB port does not support UP-LINK, that is to say, there is no automatic flip function.

    If the LAN port of your router does not have this function, you will have to use crossover wires for cascading. The cross line is an RJ45 jumper with two different connections: 568A and 568B.

    2. There are a total of 6 LAN ports left, and your six computers are just enough.

    3. In the router, LAN is set to DHCP to dynamically assign IP addresses. hub does not need to be set up.

    Test. Needless to say, three computers connected to the router will definitely be able to access the Internet normally. The tests were three computers connected to the hub.

    It would be nice if they could all be on. If that doesn't work, you can unplug the hub, change the straight-through cable and use the LAN port of the router to connect directly to a computer, and check the IP address assigned by DHCP. Then reconnect the hub.

    Set static IP addresses for the three computers connected to the hub, and make sure that the IP addresses do not conflict with the other three computers using routers. The gateway uses the automatically assigned IP address that was tested just now.

    Then try again.

    I wish you all the best.

  12. Anonymous users2024-01-30

    You only need to set all the computers according to the requirements, and the hub does not need to make any settings, but the router needs to occupy an IP address (the default IP address of the router needs to be modified to your school), which means that there are only 6 IPs in your dormitory, which is not enough.

    Don't bother like this, I suggest you buy a small hub. The connection method is: connect the hub under the hub, so that the opening on the hub is enough.

  13. Anonymous users2024-01-29

    The hub is a half-duplex device and cannot send and receive data at the same time. It looks like your dorm is congested because of that new hub.

    It is recommended not to use the hub anymore and buy a porous router. Hubs are not suitable for this multi-user environment.

Related questions
What type of network is made up of hubs?
3 answers2024-05-12

Networks with hubs as the central node typically adopt a star topology. >>>More

How Do I Solve the Network Latency of CS?
6 answers2024-05-12

Now we will not have an IP terminal on the network, a region always has to open a few terminals, the problem you said is that his network end is in a server, yours is right in a server B, because it is in different service terminals, the number of people carried, the speed is different, so the speed is different, even if it is door-to-door, if the IP port of two people is located in different server terminals, the service is also different, and the network speed will be different. Our country's network speed and server and inter equipment are still relatively backward compared with Europe and the United States, not to mention the speed of a country, that is, the speed of a province and a region is not connected, resulting in our CS level is limited to one place, and the reason why the CS level in Europe and the United States is high is because they are a country with the same speed no matter where they are, such as Sweden, their country you have the same speed no matter where you are in Sweden, so there are many masters!

What causes blocked fallopian tubes?
11 answers2024-05-12

Congenital dysplasia of the fallopian tubes, congenital lesions of the fallopian tubes, slender twists, or dysfunction of the fallopian tubes can cause tubal obstruction. >>>More

Is there any solution to the problem that the shower is easy to clog?
17 answers2024-05-12

After the shower nozzle is used for a long time, it is easy to be clogged due to water quality and quality reasons, and many people don't know what to do. If some of the small holes in your shower at home are blocked, then drain the water first to see which holes are blocked. Then you have to turn on the shower head and see that the shower head has a lot of holes in it. >>>More

How to solve CSOL network problems?
16 answers2024-05-12

Is there a situation where you suddenly can't walk while playing, and then you don't come back to life, and others can still beat you? >>>More