Broadband connection error 676, broadband connection error

The general manifestation of this error is that when you connect to the network, you will automatically disconnect after going online for a period of time, and then dial up the number is "error 676 ** busy", and it generally takes a while to reconnect successfully. And it's often repeated.

Friends who encounter this situation generally think of their own computer failure, restart the computer, disable the network card and re-enable, modify the working mode of the network card, change the IP address, change the network card (this method is usually effective for a short period of time), check the firewall settings, etc., and even redo the system ......, but generally does not solve the problem. Then I think about the problem of the network provider, and calling customer service ** usually can't solve the problem.

If you have done the above work and the fault is still not resolved, then it is necessary to consider the cause of the hardware address of the network card. In fact, when you change the new network card, solve the problem in a short time, and when it happens again after a period of time, you can use the following method: right-click "Local Connection" in "Network Neighbor", select "Properties", click "Configuration", and then click "Advanced", check the "Network Address" item, then you see that the general is on the "non-existent" selection, please change it to "Value", and then enter a set of 12-digit numbers in the input box, and finally confirm.

This is to change the hardware address of the network card, which is equivalent to changing a new network card, if there is error 676 again, then repeat the above operation, and then change a set of numbers). The reason is generally that the address pool is full or your hardware address is stolen, and most of the users who have error 676 are caused by the hardware address of the network card, so this method is the most effective solution for most error 676.

Broadband Internet access shows "Error 676" is generally caused by multiple incorrect dialing in a short period of time, it is recommended to check whether the Internet access and password are correct, and wait for 15 minutes before dialing attempt.

Change your MB's network card, why don't you just say change the computer with S, B?

Change a network card to ensure that this will not happen, hehe! Give it a try!

Many netizens often get error 676 when opening a broadband connection, which is very likely to be a network card failure or ** busy. Here are some solutions to the error 676 on your broadband connection, I hope it will be helpful to you!

Click Start-Run, enter cmd, and check the local MAC address.

Enter the ipconfig all key in the DOS interface, so that you can view the MAC address of the machine. Remember first, then modify.

Click "Online Neighbors" and select "Properties" to open the network connection window.

Right-click "Local Connection" and select "Properties" to open the Benji Connection window.

Select the "General tab" and click "Configure".

Select the "Advanced" tab in the dialog box that comes out.

Select the Network Address option in the list of attributes.

Change the value in the value on the right to any hexadecimal number, but it cannot be the same as the MAC address of the host, click Confirm. That's it, you can dial up the Internet normally.

end