-
Based on my experience, I give you the following analysis:
1. The broadband connection is disconnected when it is suspended, because you are using Unicom broadband, it is likely to be caused by the unstable line signal, but this fault will be restored quickly, which is also the trouble of Unicom.
2. It may also be a problem with the dialing software, it is recommended that you delete the dialing software and create a new one. The steps are as follows: open "Internet Neighbors" - "View Network Connection" - Delete the original "Broadband Connection" (at this time, you can delete the shortcut on the desktop by the way, even if you don't delete it) - "Create a new connection" - "Next" - "Next" - "Manually set my connection" in front of the checkbox, and then "Next" - "Connect with a broadband connection that requires a username and password" in front of the checkmark, and then "Next" - "Next" - "Next" - " Add a shortcut to this connection on my desktop" and then "Done"—and finally enter the correct password so you can dial up the Internet with the new dialer.
Because the network problems caused by dial-up software also often exist, it is recommended that you use the dial-up software of the computer system to set up according to the method I said, and do not use the disc to set up, because the disc is set back to occupy a certain space and will infect the computer system.
3. If the frequency of dropping is too high, it is likely to be caused by the extreme instability of the line, in this case, it is recommended that you declare the fault (if you do not respond to your complaint), you can only install the maintenance division to solve it for you, if it still can't be solved, it is recommended that you do not use Unicom broadband, cheap and not good.
4. According to your description, it may also be a problem with the moden. It is recommended that you use the new products of ZTE or Huawei, and do not go out to buy knockoffs in order to save money.
Okay, that's all I can say to you. If you don't understand, please feel free to ask.
-
I think you can find the installed machine to check it, generally if it is not the cause of your computer network card, it is the aging of the access line or the poor contact of the network cable, of course, it is also possible that the cat has a problem and the work is unstable.
-
1.It may be a voltage problem that causes the broadband cat to restart and cause the connection to drop, find a multimeter to test the voltage to see if it is normal; 2.Check whether the status of the broadband cat is normal when the connection is dropped, whether there is a DSL or link light is always on, the DSL or Link light on the broadband cat indicates the communication status between your broadband cat and the operator's equipment room, it should be always on at normal times, if it is not bright or shiny, the biggest possibility is that there is a problem with your **line, directly call the operator's customer service** to report the obstacle for people to check and repair:
Telecom10000, Netcom 10060
-
1. Try changing the speed of the NIC.
In the device manager, find your network card options, right-click on the properties, click to switch to the "advanced" interface, and then select "connection speed and duplex mode", generally win7 is automatic by default, we can adjust to 10m full duplex or 10m half duplex test network can be used normally.
2. Replace the network cable connected to the computer by the cat.
Aging of network cables will also cause packet loss and disconnection, and it is not difficult to replace network cables, and you can also put it in the first place to test;
3. Replace the broadband modem.
The possibility of cat damage is also very high, and usually the replacement method can find the exact problem.
Fourth, detect broadband lines.
This part is estimated to be completed only by telecommunications, and it is very common for broadband instability caused by aging open-air lines.
-
Call number 10000, when the master contacts you, ask him to help you change the modem first, and by the way, the voice separator in the computer room is also changed. The problem should be solvable.
-
Broadband disconnection is a common fault, and the general cause of failure is divided into 1 computer problem (extremely low probability) is caused by poisoning or improper operation.
2. Cat problems (general probability) are repaired or replaced. 3. Poor line transmission quality (extremely high probability), because the problem of ** cable and your indoor line may cause slow network speed and disconnection. So don't believe what the maintenance staff says the line is normal.
If you can't fix it, you keep complaining. 4. The problem of equipment at the end of the bureau (the probability is super low) is that there is a problem in the computer room, and I can't solve it myself. Therefore, generally speaking, when the broadband network speed is slow and the connection is dropped, it is best to call customer service** to let the maintenance personnel come to deal with it, and it is very difficult to judge the cause at home. o
1. Definition of Dialing Error: Error 678 is one of the faults of broadband. The implication is that the remote computer is unresponsive. >>>More
When a broadband dial-up connection is displayed, the error 678 651 815 is displayed, usually on the entire broadband line, and one of the lines or equipment is interrupted, resulting in the entire broadband connection. The principle is that after the dial-up information of the computer is sent, the feedback information from the server is not received for a long time, and the system judges that the dial-up is interrupted. Troubleshooting Steps: >>>More
When a broadband dial-up connection occurs, error 678 is displayed, usually on the entire broadband line, and one of the lines or devices is interrupted, resulting in the entire broadband network being unavailable. The principle is that after the dial-up information of the computer is sent, the feedback information from the server is not received for a long time, and the system judges that the dial-up is interrupted. You can add [China Telecom Guizhou Customer Service] WeChat through WeChat***, enter the broadband service - broadband troubleshooting for a one-click physical examination, and we will provide the most professional treatment plan for the test results. >>>More
ADSL disconnection involves many problems, including line failure (line interference), ADSL modem failure (heat, quality, compatibility), network card failure (slow speed, outdated driver), and so on. Operators and users should do the following routine checks: whether the ADSL** line connector is safe and reliable: >>>More
The general manifestation of this error is that when you connect to the network, you will automatically disconnect after going online for a period of time, and then dial up the number is "error 676 ** busy", and it generally takes a while to reconnect successfully. And it's often repeated. >>>More