Why does Hyundai Rena eat tires on the rear wheels, Beijing Hyundai Ruina, do you want to comment af

1.Run the command prompt as administrator: shortcut win+r Enter cmd 2

Enable and set the virtual WiFi network card: Run the command: netsh wlan set hostednetwork mode=allow ssid=meizupc key=bulukawifi After the wifi is turned on successfully, there will be an extra wireless connection 2 with the network card as "Microsoft Virtual WiFi Miniport Adapter" in the network connection.

3.Set up Internet connection sharing: In the "Network Connection" window, right-click on the network connection that is connected to the Internet, select "Properties" "Sharing", and tick "Allow Others?"

Connect (n)" and select "Phone Model WiFi"4Turn on the wireless network: Continue running in the command prompt:

netsh wlan start hostednetwork (change start to stop to turn off the wireless network, and then you only need to run this command again to enable the wireless network after booting up) Open the network connection page next time: We will find out"Meizu wifi"The red cross next to it has disappeared, and the wireless AP has been turned on successfully.

You've got to have a gap in the balance shaft, so fix it.

There are two reasons for eating tires, one is that the inclination angle is wrong, and then the toe is wrong, you can do a four-wheel alignment, ** data is wrong, you can know it at a glance.

The spare tire of Rena car is a non-full-size tire, that is, smaller than the tire of the car, this spare tire is located in the rear trunk of the car, which is used to ensure that the vehicle can continue to drive under the condition of wheel damage, but in order to save space, the tire that is smaller than the normal wheel size of the vehicle is selected as the spare tire, and the specific operation steps to find this spare tire are as follows

1. Open the driver's door of Beijing Hyundai Ruina.

2. Pull up the hand brake of Beijing Hyundai Rena to avoid slipping.

3. Pull up the trunk switch of Beijing Hyundai Ruina.

4. Lift up the suitcase of Beijing Hyundai Ruina.

5. The spare tire of Beijing Hyundai Rena is located under the floor of the luggage compartment.

No, the tire width and aspect ratio are different, narrower and larger, and if you use it, the speed is controlled at 80 or less.

No, the Hyundai Reina's spare tire is a non-full-size tire that is smaller than the other four normal-driving tires.

Whether it's a full-size spare tire or a non-full-size spare tire, it's just an emergency tire. They are not the same as the speed level and load-bearing index of the vehicle's four normal tires and cannot be used instead. The spare tire can only be temporarily replaced, and the maximum speed is within 80 kilometers per hour, and the driving distance is not more than 100 kilometers.

Because there are no specific hard regulations on the size of spare tires, many manufacturers choose a smaller type of tire as a spare tire in order to save costs. For example, the normal tire of the vehicle is 205, and the spare tire is 195, which is a non-full-size spare tire.

It's not the same, it's one size smaller.

The 14-year edition is full-size.

The general ones are different, and I don't know if your car is the same.

Today, I went to repair the tire, and the mechanic said, ours is the same, and I will ask again next time I go to the 4S shop.

Summary. Hello, your question is Beijing Hyundai Rena after changing tires to comment? If you have a tire replaced at Beijing Hyundai's 4S shop, then after the repair is completed, the customer service staff in the store will ask you about your satisfaction with the repair service.

Then the customer service staff of Beijing Hyundai will also pay a return visit to you with satisfaction with this maintenance in the later stage. If there is a little bit in front of the vehicle after replacing the tires, it is recommended that you check whether there are relatively large stones or foreign objects in the tire pattern, and the foreign body can be eliminated by removing the abnormal noise.

Hello, don't click to end, I'm textual to give you the full answer, 2-3 minutes.

As soon as I drove the car, there was a bit of a noise in front of me.

tires. Hello, your wide spike question is Beijing Hyundai Rena do you want to comment after changing tires? If you have a tire replaced at a 4S shop in Beijing Hyundai, then after the repair is completed, there will be a customer service staff in the store to consult you about your satisfaction with the repair service.

Then the customer service of Beijing Hyundai manufacturers will also pay a return visit to you in the later stage of this maintenance. If there is a little bit in front of the vehicle after replacing the tires, it is recommended that you check whether there are relatively large stones or foreign objects in the tire pattern, and the foreign body can be eliminated by removing the abnormal noise.

The spare tire is located in the rear trunk of the car, which is used to ensure that the vehicle can continue to drive in the case of wheel damage, but in order to save space, the tire smaller than the normal wheel size of the vehicle is selected as the spare tire, and the specific operation steps to find this spare tire are as follows

1. Open the driver's door of Beijing Hyundai Ruina.

2. Pull up the hand brake of Beijing Hyundai Rena to avoid speed and delay the code to avoid slipping.

3. Pull up the trunk switch of Beijing Hyundai Ruina.

4. Xiang Mu lifted the suitcase of Beijing Hyundai Ruina.

5. The spare tire of Beijing Hyundai Rena is located under the floor of the luggage compartment.

The rear linkage is suspended, and the force is uneven in extreme driving conditions, resulting in deformation, and the rear wheel is overstressed! It is advisable to check whether the suspension is deformed.

The four wheels are not aligned accurately, resulting in four tires not being in two straight lines on the horizontal bench as required by the standard, so the two wheels on the same side will eat tires when they run up, or the front wheel or the rear wheel is mainly not in a straight line, and the vehicle corrects itself, resulting in an abnormal increase in the friction of a certain part of a tire on the ground, and accelerating wear. I'm a little bit unclear, I don't know how to express it, but anyway, imagine that the four wheels of a car should be in a rectangle with four fixed points, and if not, then it will run hard, and it will cause tire wear.

What is the toe-in is an angle at which the front wheels are slightly inclined to the inward side Similar to the figure of the inside This is the best angle for high-speed stable driving All cars have their own toe angle This angle will also eat tires if the angle is not adjusted The same as the first article.

Failure of the steering machine will also cause tire mistracking, etc.

The unevenness and loss of shape of the girder will also cause tire eating, for example, the reason for some accident cars to eat tires is the deformation of the girder body.

1.Simply put, there is one or several tires with abnormal acceleration wear on the inside or outside of a tire that wears out a certain part of a tire very quickly than several other tires. 2.

What causes it Generally speaking, there are several reasons aThe four wheels are not aligned accurately, resulting in four tires that are not in the horizontal and vertical two straight lines required by the standard, so the two wheels on the same side will eat tires when they run up, or the front wheel or the rear wheel is mainly not in a straight line, and the vehicle corrects itself, resulting in an abnormal increase in the friction of a certain part of a tire on the ground, and accelerates wear. I'm a little bit unclear, I don't know how to express it, anyway, slow signs, you disturb the rent, imagine that the four wheels of a car should be in a rectangular position at four fixed points, if not, then it will run hard, and it will cause tire wear.

b.Inaccurate toe-in adjustment will also cause tyre eating What is toe-in is an angle of the front wheel slightly inclined to the inside Similar to the inner figure This is the best angle for high-speed and stable driving All cars have their own toe-in angle This angle will also eat tires if the angle is not adjusted The reason is the same as the first article cThe failure of the steering machine will also cause tire misalignment and other d

The unevenness and loss of shape of the girder will also cause tire eating, for example, the reason for some accident cars to eat tires is that the girder body is deformedThe air pressure of each tire is too different, and it will eat tires Different specifications of tires will also eat tires The reason is the same is that the four feet are not in harmony If you don't work in a smooth environment, you will eat tires Because you can't eat anything else Hahahaha The main reason is almost these 3How to solve it, the deformation of the girder has no choice but to correct the rest, look at it yourself, it is not difficult, most of the tires can be corrected by adjusting the toe and four-wheel alignment

Hello friends, there are basically two reasons for the stupid brother who eats fetal dust celery: 1The tires are misaligned, and it is necessary to take the J to do four-wheel alignment and dynamic balancing. 2.If the tire pressure is unstable for a long time, check it.

It is possible that the rear wheel balance lever is bent.

Generally speaking, there are several reasons for thisThe four wheels are not aligned accurately, resulting in four tires that are not in the horizontal and vertical two straight lines required by the standard, so the two wheels on the same side will eat tires when they run up, or the front wheel or the rear wheel, mainly not in a straight line, the vehicle corrects itself, causing a certain part of the tire to the ground friction is abnormally increased, and the wear is accelerated. I'm a little bit unclear, I don't know how to express it, but anyway, imagine that the four wheels of a car should be in a rectangle with four fixed points, and if not, then it will run hard, and it will cause tire wear.

b.Inaccurate toe-in adjustment will also cause tyre eating What is toe-in is an angle of the front wheel slightly inclined to the inside Similar to the eight characters of the Omen-Hongyu This is the best angle for high-speed and stable driving All cars have their own toe-in angle This angle is not adjusted well will also eat tires The reason is the same as the first article cThe failure of the steering machine will also cause tire misalignment and other d

The unevenness and loss of shape of the girder will also cause the tire to eat For example, the reason for the tire eating of some accident cars is that the girder body is deformedThe air pressure of each tire is too different, and it will eat tires, and tires of different specifications will be mixed, and they will also eat tires, and the reason is the same, that is, the four feet are not in harmony, and if you don't work in a smooth environment, you will eat tires Because you can't move when you eat something else, hahahaha, the main reasons are almost these.

One is caused by the deformation of the rear axle, if confirmed, the rear axle can only be replaced, and then it is done for four-wheel alignment.

Road conditions, car conditions, and the quality of tires affect the details, so it's best to buy better tires. Michelin eats tires.

As long as one of the 4 screws fixing the tire is bent, it directly leads to the phenomenon of eating tires.

The newly bought Rena, driving on the road, friends on the road looked at the rear tire from behind, what happened? Going to a repair shop to do a four-wheel alignment can solve the problem of throwing tires.

There are two cases of rear wheel flicking:

First, there is only one tire of the twin wheel, and the other is that the tire does not throw, which is caused by the deformation of the wheel support and spokes.

Second, it is the twin tire at the same time or a single tire one wheel throw, the reasons are as follows:

1) The thread of the adjustment nut, lock nut and half-shaft casing of the wheel bearing is loose and loose, so that the axial clearance of the wheel bearing increases, or the axial direction of the wheel is not controlled and moves outward, so that the wheel is thrown.

2) The half-shaft casing and the bearing hole of the axle casing are loose and displaced, or the axial clearance of the wheel bearing is increased due to the laceration and deformation of the half-shaft casing, resulting in the wheel throwing.

3), the combination of wheel Yi and the end face of the wheel is uneven, or the laceration deformation, or the nut is loose, so that the end face of the wheel is too large, the wheel is shaken.

These reasons can cause the wheel to swing and throw the rear wheel out, so full attention should be paid to it.

Whether there is any abnormality during the driving process, (shaking, body shaking, etc.). If so, it is recommended to overhaul it as soon as possible: see if the rim is deformed (you can do a dynamic balance) and whether the bolts are loose; If not, it may be due to visual error (although it is better to do a good repair).

Only by doing a dynamic balance can you know that it may not be accurate to the naked eye.