How do you take the brakes on the horns of the dead flyer?

<> lift the rubber inside the ring, and there are hexagon socket screws inside, which can be removed with a tool.

To remove the brakes on the knobs of the Dead Flying Bull, you can do so by following these steps:

1.Prepare the tools. Tools needed include a screwdriver or Allen wrench.

2.Lift the rubber handle on the horn handle and you'll see the Allen screw.

3.Use a screwdriver or Allen wrench to remove the screws.

4.Gently pull the brake cord to remove the brake.

Please note that before dismantling, always park the vehicle in a safe place and make sure it will not be disturbed in any way. If you have any questions about the disassembly process, it is advisable to consult the help of a professional.

Steps to take out the handlebar: Lift the rubber cover of the neutral part of the handlebar, there are hexagon screws inside, and loosen the handlebar with a tool to remove it.

How to remove the brake handle of the dead flying bike, take out the handlebar steps: lift the rubber cover of the neutral part of the handlebar, there are hexagon screws inside, and the handlebar can be removed by loosening it with a tool.

1. Remove the sweat-absorbing handlebar strap of the handlebar.

2. Roll the rubber dust pad at the rear of the brake lever forward to expose the mounting seat of the brake lever (a metal ring is connected to the bending handlebar).

3. Use an inner hexagonal wrench to loosen the fastening screws on the side of the mount.

4. Remove the brake handle from the curved handlebar.

Japanese-style horn handle and American-style potato horn handle cavity pin (also called horn straight handle) Japanese-style cow wool leather horn handle.

American-style horn handle (horn straight handle).

Brake installation precautions:

The hydraulic station is equipped with a circuit and a one-way solenoid valve (without self-locking function), or the hydraulic station is replaced by a double-pneumatic pressurized cylinder. As soon as the oil inlet circuit is connected to the brake oil inlet, do not remove the exhaust port of the brake first, it must be installed on the brake disc to do the clamping action, and do not empty the clamp when there is no disc, so as not to cause the brake pad to fall. After the brake is installed, after the clamping action, loosen the exhaust hole slightly until there is oil overflow, and then lock it.

Let the tubing air drain and it will return to normal.

It is best to modify it with disc brakes, which are easy to dirty the car with rubber brakes, and they are not good-looking.

Yes, as long as you want to install it, you can basically install it......

Absolutely. Isn't it okay to put it on the horizontal handle, but you can also put it on the head if you want, because there are also that kind of brake handles.