Why do some fonts disappear in CorelDraw 9 10?

CorelDraw takes a long time, and you often find that the font is missing. Check the fonts directory under Windows, but find that all the fonts are intact, open other software (such as word), the original fonts are still there, this is strange, reloading the font can not solve the problem.

Since a simple reinstallation won't work, let's completely change the registry! Since all fonts are registered in the registry when they are first installed, the font part of the registry needs to be completely removed.

Copy the entire fonts directory under Windows to the root directory first, then open the registry (note to back up before opening), find the hkey local mach ine software Microsoft Windows currentversion key, delete the entire fonts subkey, and then rebuild a new fonts subkey, exit the registry, restart the system, open the control panel, and select "Fonts to install new fonts." The fonts directory that was just copied from the root directory All fonts are installed", OK, and then restart the system.

Open CorelDraw, select the font, and sure enough, all the fonts are back again, and you're done!

Later, after many practices, it was found that as long as there was a problem with the font, or the installation of a new font, "the font has been damaged......and so on, which can be solved with this trick.

I don't know which font yours is gone, you can adjust the font display adjustment in the general settings inside the display Asian text option. If that doesn't make the font work, factory reset the software! The way to do this is to press F8 first, then click on the icon, and finally select CorelDraw9 to confirm.

There are some obscure fonts or symbols that CDR cannot be displayed as a problem with the software itself.

It should be a system problem.,Reinstall the cd.,If it doesn't work, reinstall the system.。

It's not a CDR9 problem, it's probably a system problem.

If there is such a problem, close it and open the software to take a look.

1. Open CorelDraw, draw a rectangle, set to 130mm*130mm.

2. Fill the color with black, and use the Bezier tool to draw rice characters with a white outline.

3. Then enter the text, and the font will be enlarged.

4. The font turns white, then align the graphics and text.

5. Finally, take a look at the effect.

You didn't click to give up fonts and formatting.

If that doesn't work, try pasting it from Word onto WordPad and then into CDR.

Paste into Notepad and then into CD.

The higher version of the CDR font recognition is a bit stronger than the lower version.

Corel software is better not to use adobe fonts...

You can just try it with the imitation song of the system.

Click "Clear Filter" and you're good to go.

The basic operation of the hollow word is to have no fill color, add an outline color, and press "F12" to adjust the width of the outline line.

Another way is to use the contour tool to add a contour to the font slider, and the number of rounds makes the offset value of the hole outline need to be adjusted appropriately, and then split and trimmed.