I want to freeze the one in the middle of the fridge!

If you want to freeze the one in the middle of the refrigerator, it should be fine, as long as the temperature is set to the lowest.

The refrigerator generally starts with a single-door model (B is a refrigerator and C is refrigerated), that is, a single-door refrigerator only has a refrigeration function and does not have a freezer, and the temperature of the refrigerator is generally 8 degrees to minus 5 degrees, so if you are a single door, freezing ice is very slow

It is perfectly fine to mix the water in the middle of the refrigerator to freeze, as long as the temperature is lowered to a certain level, the middle will become a freezer.

It doesn't seem to be able to be adjusted, because the middle of the refrigerator belongs to the same length, it will not be transformed into frozen, and its temperature is about 0 degrees.

In the middle of the refrigerator is one that can be frozen, refrigerated or quick-frozen. It can be adjusted directly to the frozen state.

It is impossible to adjust, the middle of the refrigerator is generally a soft freezer, and the bottom one is the freezer.

For refrigerators. If you want to change the refrigerator to a freezer, you must turn the temperature setting switch to the lowest point, so that the refrigerator can also become a freezer.

Ah, the one in the middle is slightly cold, and if you want to freeze him, you have to adjust him to the lowest temperature.

The temperature adjustment of the refrigerator is adjusted according to the amount of food you have, and cannot be adjusted to freeze.

If your good friend turns the middle one up to frozen, if you can, the bigger one may become frozen, I hope it can help you.

The fresh-keeping compartment of the refrigerator, if you want to adjust it to the freezer, it is impossible, their structure is different.

If you want to change the middle to freeze, then there are also requirements for your refrigerator, because there are some refrigerators, which are controlled by the computer, and can be adjusted.

If you want to freeze the middle of the refrigerator, you can adjust it.

That one that doesn't fit into a freezer is um, a little colder than the safe, um, drawer.

Hello, this refrigerator is frozen in the middle of the self will not. Disassemble and assemble, I don't think it's necessary to buy a new one, otherwise it's easy to break it.

The refrigerator is not something that you want to freeze just cold. The freezer compartment of the refrigerator of the general design is underneath.

This doesn't seem to be able to adjust the package, in fact, you can look at the manual, if the manual is not there, you can find a tutorial on the Internet.

The freezer in the middle of the refrigerator is graded and can be adjusted individually.

First of all, it is necessary to determine whether the refrigerator is mechanical or artificial intelligence, and the mechanical type needs to manually adjust the temperature, and the temperature of the freezer can be adjusted up and down. The artificial intelligence refrigerator generally defaults to intelligent temperature adjustment, which does not need to be set manually, and can of course be manually operated on the refrigerator panel.

1. The mechanical type needs to manually adjust the temperature, and there is a circular rotary button in the refrigerator to open the refrigerator, and there is a number of 0 7 on it, and 0 is not working. Of course, the larger the number, the stronger the cooling effect, you only need to rotate the button to adjust the temperature freely, generally in summer is 1 3 gears, spring and autumn is 3 4 gears, winter 14 5 gears.

2. The refrigerator in artificial intelligence mode generally defaults to intelligent temperature adjustment, and there is no need for manual setting. If the AI is not turned on, it can be intelligently switched by pressing the AI on the refrigerator panel in the non-locked state. Early bush.

3. When adjusting the temperature of the refrigerator in summer, it needs to be cooled to 2 or 4 gears, so that the temperature difference between the inside and outside of the refrigerator will maintain a balance, which can make the refrigerator run normally. When adjusting the refrigerator in winter, adjust the thermostat of the refrigerator to a larger position, and choose to increase the thermostat of the refrigerator in the winter to ensure the temperature in the refrigerator freezer Rikuhashi Sakura.

4. The ambient temperature around the refrigerator needs to be lower than 16, and the electric heating compensation switch of the refrigerator can be turned on to ensure the load temperature of the freezer compartment of the entire refrigerator, and at the same time, it can prevent the thermostat from malfunctioning due to too low.

Don't know what you're talking about**icing?

If your refrigerator is directly cooled, it is normal for frost to form on the back wall when the compressor is working, because there is an evaporator inside the back wall.

When the compressor is working, the temperature of the evaporator is very low, which cools the cold room. After the compressor is shut down, the frost will slowly melt away, flow down to the water tank, and then discharge to the water box under the refrigerator through the drain hole, and slowly evaporate through the high temperature generated by the compressor when working.

If there is icing in a certain position at the back of the refrigerator, mostly on the left side, and it will not melt, and the more it knots, the more it is formed, the foaming quality of the refrigerator insulation layer should be poor, and the insulation effect is getting worse and worse. Or there is a deformation or door in the refrigerator door.

Caused by poor sealing of seals.

If there is no problem with the refrigerator door and door seal, the new refrigerator should contact the dealer to request a return or exchange, and the warranty period should contact the after-sales service for maintenance. If the warranty period has passed, you can also do a simple transformation to see how it goes. Find a thick aluminum or copper plate, bend it into the same shape according to the shape of the icing place, and then fix it here, through the characteristics of the aluminum plate or copper plate temperature conduction quickly, so that there will be no more icing here.

If the temperature of the refrigerator room is lower than the 3 degrees you set and continues to cool down, the compressor never stops, it means the thermostat.

If the performance is abnormal, you should contact the after-sales service or ask professionals for maintenance in time.

It is normal for the refrigeration room to freeze in the heat exchange part, in the end the refrigerant is below zero degrees, as long as the refrigeration room is not frozen, it is normal, if the refrigeration room is also frozen, it is the temperature control is not accurate, the actual temperature is lower than 3 degrees, you can adjust the temperature appropriately, if it is not frozen, it is normal, and there is a problem with the freezing temperature control.

Analysis of the reasons for freezing vegetables in the refrigerator freezer:

1. There is too much frost on the evaporator, and when it melts, the water overflows into the water tray and flows in the refrigerator, causing the vegetables to be frozen.

2. The water tray in the refrigerator is not aligned with the water receiving funnel, resulting in the water flowing in the refrigerator. Elimination method: Adjust the water connection funnel and align it with the position of the water connection tray.

3. The drain pipe mouth is frozen, so that the defrosting water cannot flow out, and the flow accumulates in the refrigerator. Cover imitation elimination method: the temperature in the refrigerator should not be adjusted below 0 °C, usually 2-6 °C is appropriate, so as to prevent the water from freezing.

4. Cold drinking water or other beverage containers are turned over and flowed in the refrigerator, or the lid of the beverage bottle is not tightened and is placed horizontally on the food shelf, causing the beverage to flow out. Exclusion method: When refrigerating drinks, handle them gently, and the plastic container with the bottle cap should be placed on the food rack of the door leaf, such as the fruit that is back on the food shelf, and the bottle cap should be screwed tightly to prevent the liquid from flowing out.

5. Usually, the refrigerator door is not closed tightly, or the sealing strip is damaged, so that the outside hot air continues to flow in and condense into water. Exclusion method: When using a refrigerator, opening and closing the door is an important job, and it requires care to prevent cold; If the sealing strip is found to be damaged, it should be repaired in time; It is also required to pay attention to whether there is dirt on the door edge and adhesive strip at all times, and if found, wipe it off immediately.

Summary. Hello, the reasons why the refrigerator freezer becomes freezing: 1. The thermostat is out of order; 2. Insufficient refrigerant; 3. Because the compressor works for a long time, the temperature rises to a very high level, which makes the fuse fail.

Hello, the town made the refrigerator freezer for the following reasons: 1. The temperature control sleepy travel talker was out of order; 2. Insufficient refrigerant; 3. Because the compressor works for a long time, the temperature rises to a very high level, which makes the fuse fail to blow the fuse.

Solution: 1. Repair the thermostat, check whether there is an adjustment error or a failure of the thermostat, and replace it if necessary; 2. Add a sufficient amount of refrigerant to make the freezer of the freezer achieve the set chain leakage refrigeration effect; 3. The ambient temperature is too high and the refrigerator door is opened and closed frequently, which will make the compressor run for a long time, resulting in non-stop shutdown and overheating protection for the compressor. Therefore, the freezer should be placed in a well-ventilated and cool environment, and the freezer door should not be opened and closed frequently.

Freezer refrigeration becomes frozen, you need to open the freezer to see the thermostat, adjust it to 6-7 strong gear, its compressor will work non-stop, freeze, and then the refrigeration will become frozen. However, the freezer is not suitable for long-term use of the freezing function, which will cause a burden on the compressor, thus reducing the service life of the freezer.

Precautions for the use of the freezer:

1. Pay attention to the surrounding environment.

In the use of the freezer, if the surrounding temperature rises, it will affect the heat dissipation of the freezer, which will cause the temperature in the box to drop slower and increase power consumption. Moreover, if the temperature difference between the inside and outside of the box is too large, there will also be a lot of cooling loss, and the freezer shutdown time will be shortened, and the continuous operation will also increase the power consumption. It is best to put it in a well-ventilated location, if there are boxes and other debris around, or close to the wall, it is not good for its heat dissipation, and there is also a 30cm vacancy on the top surface to fully dissipate heat.

The floor of the place should be flat and solid, so that the compressor can be in a horizontal position and vibration can be reduced.

2. Pay attention to handling.

The freezer must be handled carefully, not dragged on the ground, to lift the crack pie only to move the manuscript, and the inclination angle can not exceed 45 degrees, it is forbidden to invert, horizontal cultivation handling, which will cause the internal refrigeration oil to enter the refrigeration pipeline, thereby affecting the refrigeration effect. At the same time, it is necessary to prevent bumps, vibrations, and rainwater soaking. <>

Hello, the refrigerator freezer can not be changed to a freezer ready to open. Freezing is leakage, evaporator refrigeration is internal evaporator, the temperature difference between the two is too large. It is a wrong idea to freeze in the refrigerator compartment, because the evaporator in the refrigerator compartment is small, and it takes a long time to turn on the machine to reach the temperature below zero; Even if it does not stop to achieve, the consequence is that the power consumption is too large, the press is overheated, the refrigeration efficiency is reduced, and the gains outweigh the losses.

In fact, the operation is also very simple, that is, to turn the thermostat to the maximum, that is, to quickly destroy the freeze, and the orange will not stop. But be sure to dial it back within a certain amount of time.

The refrigerator is not refrigerated when the refrigerator appears, but the possible reasons why the freezer is normal are:

1. Insufficient refrigerant.

2. In the refrigerator refrigeration system, the refrigerant enters the freezer evaporator for evaporation and heat absorption after the capillary throttling and depressurization, and then enters the refrigerator evaporator for refrigeration. When the refrigerant is insufficient, most of the refrigerant has evaporated and absorbed heat in the freezer, which will lead to a decrease in the refrigeration effect of the refrigerator or even no refrigeration.

The solenoid valve in the refrigerator compartment is faulty.

3. When the solenoid valve of the refrigerator cannot be opened, the refrigerant cannot enter the inside of the evaporator in the refrigerator, resulting in the refrigeration room not being refrigerated.

4. The sealing strip of the refrigerator is aged or deformed. After the sealing strip of the refrigerator is aged or deformed, the sealing of the refrigerator will decrease, and the cold air inside will leak to the outside through the aging or deformed parts, and the hot air from the outside will also enter the inside, resulting in the reduction of the refrigeration effect of the refrigerator.

Hello, the reason is: in addition to controlling the temperature of the refrigerator, the refrigerator room thermostat also controls the working state of the solenoid valve, that is, when the refrigerator reaches the set temperature, it will cut off the power supply line of the compressor and make the solenoid valve energized and engaged. At this time, the refrigerant only enters the evaporator through the second capillary.

When the temperature of the refrigerator rises to the temperature of the opening point of the column, the thermostat is connected to the power supply line of the compressor to cut off the solenoid valve. The circulation channel of the refrigerant becomes: the first capillary, the cold room evaporator, the freezer evaporator, and the compressor.

There are two reasons why the refrigerator compartment of the refrigerator becomes a freezer, one is that the temperature parameters of the refrigerator thermostat have drifted. Second, the solenoid valve is not tightly closed, resulting in a small amount of refrigerant circulating in the evaporator of the refrigeration room when the refrigerant is refrigerated.

1. In summer, due to the high ambient temperature in summer, the temperature regulator should be adjusted to 2-3 gears during the use of the freezer.

2. In winter, due to the low temperature in winter, the gear of the temperature regulator should be adjusted to 4 gears or more.

The purchased freezer has only one refrigerated room thermostat to control the temperature of refrigeration and freezing, because the refrigeration temperature is technically required to be controlled between 0-10 degrees, and generally in winter, the ambient temperature is relatively low, the freezer is easy to reach the set temperature, so the temperature can be slightly higher, and the opposite is true in summer.