Siemens three door refrigerator, how to take out the middle box

Lift the drawer up from the inside, and there are two buckles in it that come out, which has nothing to do with the track, the drawer is stuck on the track.

The temperature regulation of the refrigeration and freezing layers is too simple, and in order to make up for their shortcomings, the middle layer has a temperature change function. The middle layer has a large temperature span, so it can be used both as a food preservation chamber and as a blast freezer. The temperature of the middle layer is adjusted to minus 18 degrees, and this layer becomes a cryogenic quick-freezing room, where the food can be quickly frozen, which better locks the food nutrition, and truly reflects the complete function of the three-door refrigerator.

The slide drawer can be lifted from the slide and then withdrawn.

1.First, remove the top cover of the refrigerator as well as the back cover of the compressor, and remove the set screws on the back plate. 2.

Then use a flat steel tool to insert it from the top to the bottom of the group, from the middle to the sides, between the back and the foam layer, and gently swing it. 3.After the two are separated, lie down on the refrigerator, insert the flat bar, and gently lift it to loosen the card edges embedded in the back plate on both sides of the box.

4.Finally, one end of the back plate is gently taken out from the card edge, and then taken out and buried at another end after the eggplant is finished.

How to take out the fresh-keeping drawer of Siemens three-door refrigeratorHello, close the stool and kiss, Siemens three-door refrigerator often has more frost knots inside, and the drawer cannot be taken out, you only need to melt the frost first, and the drawer will be taken out naturally. The following is the method of defrosting the drawer and then taking it out: 1. First adjust the temperature compensation to 0, then close the refrigerator (if there is no temperature compensation, it will be closed directly), and unplug the power supply.

Take out all the contents of the freezer layer and the drawer, let the frost melt naturally, wipe it dry with a rag, and then reset. 2. Clear out the things in the refrigerator, use a hair dryer to slowly blow the ice, and add a towel to absorb water at the bottom of the refrigerator. After cleaning all the ice you have, it is best to wipe it with a clean towel dipped in venom and then wipe it off with water.

At the same time, be careful not to block the small holes for drainage. Then, check and clean the sink at the bottom of the refrigerator, if there is water in it, it is usually very dirty. Finally, put the contents of the refrigerator back and remember to wipe the condensation in the air.

In this way, it is not easy to frost again. Similarly, don't have water on the outside of the packaging of things that you usually put in the refrigerator. 3. There are high tricks for refrigerator defrostingSome refrigerators need to be defrosted, and manual refrigerator defrosting is time-consuming and laborious, and the defrosting effect is not good.

Here's a defrosting trick for you. According to the size of the refrigerator compartment, cut a slightly thicker piece of plastic film and stick it to the frosted wall of the refrigerator compartment without using any glue. I hope it can help you, if my answer is helpful to you, please give a like (rate in the lower left corner), look forward to your like, your efforts are very important to me, and your support is also the driving force for my progress.

Finally, I wish you good health and a happy mood!

Summary. 1.To remove the front cover of the foot, first, open the door of the freezer and refrigerator compartment, and then turn the three screws at the front cover of the foot counterclockwise to remove the front cover.

2.Detach the water supply pipe of the refrigerator, unscrew the screws of the clamp, press and hold the pipe fitting and pull out the water pipe to remove it. Remove the hinged lid on the upper part (left and right).

3.Remove the upper hinge cover and remove the wires, rotate the hinge screws and ground screws to remove them and remove the upper hinges in the direction of the arrow, being careful not to slip the freezer door during removal. 4.

Carefully lift the door and remove it from the lower hinge, lift the lower hinge in the direction of the arrow from the lower hinge bracket and remove the lower hinge.

Good. Can you add, I don't quite understand it.

1.To remove the front cover of the foot, first, open the door of the freezer and refrigerator compartment, and then turn the three screws at the front cover of the foot counterclockwise to remove the front cover. 2.

Detach the water supply pipe of the refrigerator, unscrew the screws of the clamp, press and hold the pipe fitting and pull out the water pipe to remove it. Remove the hinged lid on the upper part (left and right). 3.

Remove the upper hinge cover and remove the wires, rotate the hinge screws and ground screws to remove them and remove the upper hinges in the direction of the arrow ant Zheng Tou, being careful not to slip the freezer door during the removal process. 4.Carefully lift the door and pat it off the lower hinge, lift the lower hinge in the direction of the arrow from the lower hinge bracket and remove the lower hinge.