How do you get that WIFI setup on telmex infinitum router?

Telmex, Router Setup Method:

Home Network Environment Cabling]:

1. There is a cat (modem): cat (modem) - router WAN port; The LAN port of the router --- a computer.

2. No modem: network cable --- router WAN port; The LAN port of the router --- a computer.

Computer enters the router]:

1. The computer IP and DNS settings are automatically obtained.

2. Open the browser, enter the general router address in the address bar is this or check the login information on the back of the router) Enter the route - enter the user name and password, (the default is generally admin).

Set Router Dialing]:

1. In the [Setup Wizard], select [PPPoe Dialing] (some are ADSL Dialing), enter the Internet user name and password according to the prompts, and save.

2. In [Network Parameters] --WAN Settings], select [Normal Mode], and select [PPPoe Dialing] in the three options of [Connection]. The next step is to select [Auto Connect], Save, and Exit.

This is Thomson's custom-built router for Telmex.

Username: telmex

Password: The wep key on the back of the router, pay attention to the case.

The account password is either admin or guest

Username: telmex (note capital letters).

Password: The wep key :(10 digits) behind the router

For foreign products, no account password is required by default.

I'm here to answer for you!

Go to the settings page of Password 2wire

Wired connection is not required with a password.

Send a few pictures: PPOE's setting path, wifi's setting path.

PPOE Account Information:

Set up a broadband account:

Wifi settings:

Mine is also a telmex route, but don't know why my setup route is in.

Maybe you can try.

Don't have an instruction manual? Is it an old router, then someone may have changed the login password.

Press and hold the reset button for 5 seconds to reset and try again.

There is also a username admin password blank to try.

Generally, the username and password are admin

Turn on the computer into the router**.