Alarm when the computer is turned on

According to your sound, the memory should be broken, so let's replace it

Award BIOS Alarm Tone:

1 Short: The system starts normally. There is nothing wrong with that.

2 Short: General error, please go to CMOS Setup and reset the incorrect options.

1 long and 1 short: There is an error with the RAM or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard.

1 long and 2 short: The display or graphics card is wrong.

1 long and 3 short: The keyboard controller is wrong. Check the motherboard.

1 Long 9 Short: Motherboard Flash RAM or EPROM error, BIOS corruption. Try a different block of flash ram.

Constant ringing (long sound): The memory module is not plugged in tightly or is damaged. If it still doesn't work, you can only replace a memory module.

Repeated, short ring: There is a problem with the power supply.

No sound and no display: There is a problem with the power supply.

Alarm tone for AMI BIOS**:

1 Short: The memory refresh failed. Replace the memory module.

2 Short: The memory ECC verification error is incorrect. Setting the memory option for ECC check to Disabled in CMOS Setup will solve the problem, but the most fundamental solution is to replace a memory.

3. Short: The basic memory of the system (the first 64KB) failed to be checked. Change memory.

4 Short: The system clock is wrong.

5 Short: Processor (CPU) error.

6 Short: Keyboard controller error.

7 short: The real mode of the system is wrong and cannot be switched to protection mode.

8 Short: A memory error is displayed. If there is a problem with the display memory, try changing the graphics card.

9 Short: ROM BIOS check and error.

1 long and 3 short: memory error. If the memory is damaged, it can be replaced.

1 long and 8 short: A test error is displayed. The monitor cable is not plugged in properly or the graphics card is not plugged in properly.

The alarm sound can be different for different motherboard manufacturers.

Open the lid and remove the memory There are two clips at both ends and press down to get the memory stick out, and then wipe the gold finger of the memory stick (that is, the contacts on the bottom side are in a row on both sides) with an eraser.

Find a small brush, brush the slot, blow the dust, and then insert the memory module back in Pay attention to the direction and don't reverse the gap Press down at both ends together to automatically go in and lock it Then turn on the computer to see if the problem is solved.

That's usually memory! It's good to remove it and install it on, you won't go to a computer store, and we don't charge money to help you do a good job of these small problems!

It's still not enough to plug in the memory! It's not plugged in, or it's a motherboard problem.

100% the motherboard is burned out!! If I get it right, give me the points!!

What's on the screen?