Can a computer accept a Hansung No. 5?

As long as you are in field strength coverage, the 1020 card will definitely receive the signal as well!

Use DM500 to change the Chinese station standard software to manually add ** on the corresponding satellite, fill in the corresponding downlink frequency and symbol rate, and then add the channel under the newly added ** device, and fill in the PID on the front ditch of the channel PID option. Note: If you want to add multiple channels to a ** device, each CH ID should be sorted in order, and the same number should not be added.

Upload it to the DM500 and you'll find that the show is here and ready to watch.

Here's how to receive it:

Hansung 5 at 113 degrees east longitude.

On the satellites that can be received in China, there is no free C-band, and the four stations on the C-band and the five stations on the Ku-band on the 138 are all encrypted, and you need to use DM500 receivers and network shares to watch them.

The only one in the KU band is the well-known 113-degree Korean Star No. 5 KU, which is not actually encrypted, but can be received by modifying its VPID and APID.

The parameters are as follows: downlink frequency: 12621

Polarization mode: vertical V

Tick rate: 13333

vpid apid：

S Box PID 1310 5406S CH PID 8018 3922

Note: You can modify the PID code.

A high-frequency head and a receiver card, a pot are required. The computer needs to be equipped with receiving software.

It's too stingy, I won't tell you if I don't give points.

Is the 10750 high-frequency head a mid-nine head, and what kind of machine is used for the machine? View the original post

Receiver Hansung 5 requires at least a biased feed antenna, a KU-band dual-polarized single-output feed-in integrated high-frequency head with a local oscillator frequency of 11300, and an ordinary DVB receiver.

It is necessary to adjust the elevation angle and azimuth angle.

and polarization angle, the 12619h level 12300 signal is used to match the star, and the PID code is modified after locking and depositing after alignment.

Hanxing No. 5, the high-frequency head KU section turns to about 30 degrees south-west at half past four, the town 10750 uplink 12621 symbol 13333 S CH audio PID3922**8018 S Box audio PID5406 **Yes 1310

Hello, to receive 113 Hanxing No. 5, you need at least a bias feed antenna, a KU-band dual-polarized single-output feed integrated high-frequency head with a local oscillator frequency of 11300, and an ordinary DVB receiver is also needed, adjust the elevation angle, azimuth angle and polarization angle, use 12619H level 12300 signal to the star, and modify the PID code after locking and depositing after alignment.

First of all, you have to have two high-frequency heads, and secondly, you have to have a 2-cut 1 switch (electronic, relay can be), and then you adjust a satellite tune, all debug the signal (that is, you can receive the station), and then connect the 2-cut 1 switch, and then a wire leads to the receiver, and the search can be.

This method is suitable for satellites received in cauldrons, such as Asia 3S, Zhongxing 6B, Xinnuo 3, Hanxing 5, etc.

Zhongxing 9, that is, a small cauldron, cannot be received by the receiver of a large cauldron.

Even if you can receive a signal, you can't see it at all.

Yes, you can set the parameters of Han Wu!

Of course, it can be noted that the local oscillator is changed to 11300 or 107500

If your receiver can add programs, it's fine, of course you'll have to enter the corresponding parameters. Good luck!

Hansung 5 has no signal in many parts of China. This can be seen in the image below.

A 10750 or 11300 high frequency head is required. A seeder is required to receive it.

Add a C-segment high-frequency head, and replace the two-cut one-switch with a four-cut one-switch on the middle six, a pot of three-star, you can see the Korean star No. 5, (it costs about 30 yuan), (the middle six is the C-segment high-frequency head.) The middle nine is the high-frequency head of the ku segment, and they c ku two cannot be used as a substitute for handover).

You can brush the trunk with lime water on the trunk, the effect is very good, the insects are on the branches or on the leaves, and the leaves can be oxidized dimethoate.

First, tune to the satellite receiver separately: the satellite should use the number key parameter on the remote control of the satellite receiver to set the downlink frequency and symbol rate of the input Hansung 5. Parameters of polarization. Retune the satellite antenna".