-
Hello and thanks for using Samsung products!
I'm sorry, but based on your description, it is recommended that you try the following:
1. Take out the battery and try to wipe the contacts.
2. Use the original data cable to connect.
3. Replace the power socket operation.
-
1. Whether to charge after turning off the empty power completely, it is recommended that you charge for ten minutes to see if it can be turned on normally or a charging prompt appears;
2. If it can be turned on, it is recommended that you check whether the third-party software is installed that causes this problem, and try to uninstall or restore the factory settings;
-
Summary. Dear, I'm glad to answer your <>
The charger light is on and it shows that it is full in less than a minute, but the reason why there is no power when you ride is the battery. Because the battery in the battery car has a certain service life, when the service life is reached, the battery capacity in it will continue to shorten. As a result, the charge will be fully charged quickly, but it will run out of power as soon as it is used, which indicates that the car needs to replace a new battery for its battery car.
The charger light is on and it shows that it is full in less than a minute, but what is the problem of running out of power as soon as you ride?
Dear, I'm glad to answer your <>
The charger light is on and it shows that it is full in less than a minute, but the power is out of power as soon as you ride, which is the reason for the battery to be disassembled. Because the battery in the battery car has a certain life span, when the service life is reached, the battery capacity in it will continue to shorten. As a result, the charging will be fully charged quickly, but it will run out of power as soon as it is used, which indicates that the car needs to be replaced with a new battery for its battery car.
Kiss, expand the following <>
It is necessary to charge it every other week to prevent the battery from losing power, and it is best to perform a deep discharge once a month. The battery has been aged, and the battery vulcanization is serious, resulting in a decrease in the digging and concealment capacity. You can try to fix it, if it doesn't work, you can only replace the battery.
There is a premise for burn-up repair, not all batteries can be repaired. If there is a short-circuit fault in a single battery of the electric vehicle battery pack, it will affect the operation of the battery pack. <>
Mine is a Phoenix self-powered battery car, I just bought it for less than a month.
Pro, the Phoenix brand self-help staring at the battery car just bought without a month of Kai rolling, there is another reason that when installing the battery, the line is caused by poor contact, it is recommended to check the battery line to give way to the posture Oh <>
Pro, because poor contact of the battery connector can also cause the <> of this situation
Dear, if you are not far from the shop that sells the car, it is recommended that you do a full inspection, after all, you have just bought the <>
-
1. Turn on the camera - the lightning bolt icon at the top - turn off on and on auto flash - select On.
2. If the flash does not work properly, it is recommended that you try to reset the camera: Camera-Settings-Reset.
3. Back up your data and try to restore factory settings.
Have fun!
-
Hello customer service! I have always trusted the quality and after-sales of your company's products. However, the N7100, which I bought less than a month ago, has blurry photos and the flash is no longer on, what is going on? Can it be returned?
-
Hello! Depending on the description of your issue, it is recommended that you try the following:
1.Turn off the phone and re-install the battery to charge.
2.Try to charge your phone when it's powered off.
3.Check whether the socket of the mobile phone and the charger cable interface are loose If the problem still exists, in order not to delay your use, it is recommended that you can contact the local service center with the invoice and the three guarantees voucher to test the mobile phone and help deal with it
Hope it helps! Have a great day!
-
Based on your description, we recommend that you try it by following the steps below:
1.Turn off the SD card and SIM card, and try again.
2.Clean the contact points of the battery and the phone battery.
3.Connect the data cable to the computer to try charging.
4.Try replacing the data cable.
5.Replace the battery.
6.Backup phone data (**book, SMS information, multi** data, etc.) and restore the phone to factory settings: Settings - Privacy - Factory Reset.
-
Usually the phone cannot be charged is decided by two aspects, the phone battery and the charger.
1. Caused by mobile phone battery failure, such as mobile phone battery damage.
Solution: Replace the battery with a new battery of the same model.
2. The mobile phone charger is damaged, such as the mobile phone charger is damaged.
Solution: Replace the mobile phone charger with the same specifications.
-
Hello: According to your description, it is recommended that you try the following:
1.Shutdown charging test.
2.Replace the charging position to rule out intermittent contact caused by poor contact with the socket.
3.If conditions permit, replace the spare charger for testing. Or send it for repair and testing.
4.When the phone is turned on and charged, if the mobile phone is equipped with a third-party plug-in such as a charging doctor, it is recommended to test it after uninstalling it.
5.Check whether there are foreign objects in the tablet charging interface, such as liquid ingress and debris that cause poor contact between the mobile phone charging interface and the charger, if this situation is recommended to be repaired as soon as possible.
If the problem persists, it is recommended that you bring the three-pack voucher to send the mobile phone and charger to the local Samsung service center for detailed testing
-
Try the battery first with the cradle··· Let's see if it's a problem with the battery·· Or is it a problem with the phone... Or is it a problem with the charger... You have to rule it out
-
If the phone cannot be charged, it can be operated as follows:
Try powering off and charging.
Try a charger to rule out the reason for the charger.
Change the charging position to rule out the cause of poor contact with the socket.
Check whether there are foreign objects in the QR code and charger interface of the mobile phone, and if there is, clean it up and try again.
If it still can't be solved, you can try to back up your data and restore the phone to factory settings.
If there is still a problem, it is recommended to go to the local customer service center for inspection and repair.
1.Web page hovering: When you want to jump from a program to the browser, if the message opens the ** link, the system will prompt you to select the action mode, which not only selects the browser, but also includes the web page hovering function. >>>More
S4 is new ** inflated and has limited improvement.
If you want to be cost-effective, it's still 7100. >>>More
We apologize for the inconvenience, but we recommend that you try the following: >>>More
Hello: Please verify the specific model of the mobile phone, if the mobile phone has a short standby time and high power consumption, it may be related to the operation of the mobile phone or the battery, it is recommended that you try the following operations to reduce battery loss >>>More
First: you don't install other software other than the system into the C drive; The C disk is a system disk, and the installation will affect the speed! But when you install the software, some parts will be automatically installed in the C drive, so don't delete it. >>>More