-
First of all, viruses, DDOS and various worms may occupy a lot of system resources, it is recommended that the hard disk is completely formatted and then redo the partition so as to ensure that the system is not toxic.
If the above method does not work, just see if it is a line problem The installation of each RJ45 plug Reinstall the line Some joints look okay, but in fact they are not connected If you can't see it, let people who know some lines see it And the network line can not be with a variety of high-voltage lines Similar to electric heaters, air conditioners, etc., otherwise there will be serious interference problems It will also lead to network instability Unable to access the Internet If it doesn't work, let the play ** Give them to the telecom to see if there is a network error or disconnection in their place...Uh, perfect!
-
The network is unstable, and the machine has to be restored or reinstalled normally, once every six months, and it has not been easy to get stuck for a long time, and telecommunications is now unstable throughout the country, so the network speed is not normal.
-
It may be poisoned, and the next gold mountain will kill it.
-
Use 360 or Super Rabbit to optimize boot up,Turn off all programs that don't need to be booted.。。。 Hope it helps.
-
Let's see if it's a local connection problem? If the local connection is an automatic connection, it is normal to have a slow startup response, and the solution is to manually fill in the IP address.
Or the problem of killing soft, it takes time to start starting.
-
Forehead... All right... This one.. It's amazing... I'm much worse than yours, and it only takes more than 1 minute.
-
Generally, the machine is software first and then hardware, so it is recommended to reinstall the system first. It should be fine.
-
Optimize the system with Master Lu. Close the boot startup program.
-
It could be that there is a problem with the disks, please fix it (fix each disk once, or just fix C).
Built-in disk repair method:
The specific steps are as follows: select the drive letter c in my computer, right-click the right mouse to select the properties, select "Tools Start Checking" in the pop-up drive properties window, and select "Automatically repair file system errors" and "Scan and recover bad sectors", and then click Start, the scanning time will vary depending on the disk capacity and scanning options (after doing it according to the above method, a box will pop up, the point is, repair it at boot after automatic shutdown, win7 select the disk check button according to the plan).
Bad sectors on the hard drive will lead to corruption or loss of computer system files, computer failure to boot or freeze. Hard disk bad sectors can be repaired using NDD Disk Utility or Scandisk.
If the fault persists, please restore the system or reinstall it (it is still not possible to format the hard disk and repartition and reinstall it, if it doesn't work, you will have to replace the hard disk, or overhaul it).
-
1.Check your hard drive for bad sectors!
2.Reinstall the system!
3.Look at the temperature and see if it's too high!
-
First of all, see if it is a problem with the hard disk, check if there is a bad sector, if there is a repair, look at it.
-
The hard disk has bad sectors, and that's it.
If the hard disk is broken, it is divided into logical errors and physical damage, and if the logic is wrong, the system can fix it. If it is physically damaged, it will be miserable, if there is a bad sector, it is the data is lost inexplicably, if it is serious, there is an abnormal sound, then you should be careful to use the pull, or it will not be scrapped, but there is no obvious abnormal sound, there is a general bad sector can also be used with the system's own hard disk scanning tool for bad area scanning, that is a long, long time.
What you said is not very clear.,I don't think it's necessarily the fault of the hard disk.,If the hard disk isn't broken, you can reinstall the system to see if it's not broken.,Is the case not cleaned up for a long time?,Is there a lot of dust in it?,Maybe it's caused by CPU overheating.。 You look at it, and then you write it down in detail.
-
See if there's anything like a USB flash drive and unplug it.
-
The battery is dead, so plug it in and try it.
-
It is recommended to redo the system.
-
The computer takes a long time to boot up, responds slowly, and is difficult to enter the desktop, and there are many reasons for this:
1. Hardware problems:
1) Insufficient memory: If the entry speed was not slow before, now it is slow, and there are two memory, it may be that a memory is faulty, check whether the memory capacity is consistent with the original configuration after entering the system, if it is reduced, find out the damaged memory and replace it; If it was slow in the past, it may be due to insufficient memory, and you need to add memory of the same brand and model as the original memory or replace it with large-capacity memory.
3) Hard disk fragmentation or bad sectors: It is recommended to use the boot U disk to start the computer, and use special tools such as diskgen to detect and repair the hard disk under the PE system.
4) Power-on self-test time is too long: You need to quickly press the DEL key (F2 or other hotkeys for notebooks) to enter the CMOS setting menu when powering on, and turn off the detection of devices that are not installed inside the chassis.
2. Software problems:
2) There are too many boot auto-start programs: many software, especially network software, are set to run automatically at boot by default, which will greatly slow down the boot speed, it is recommended to use 360 security guard or other similar security software to clean up and optimize the computer to accelerate the processing, and you can also manually cancel the boot auto-start of non-essential programs.
3) Trojan horse and virus infection: It is recommended to use 360 Security Guard + 360 Antivirus or other similar security software to check and kill a whole situation.
If the above operations do not work, you need to reinstall the system.
-
Generally, this problem is considered from two aspects, one is the virus in the system, or the accidental deletion of something, resulting in the instability of the system.
The other is that the system has been running for too long and needs to be reinstalled.
There are also too many disk fragments.
The solution to this problem is to reinstall the system and defragment the disk.
-
How to speed up the boot:
1.Computer boot startup items, optimized. Turn on 360 Security Guard - Boot Acceleration.
2.Usually use tools such as 360 Security Guard to clean up system junk and temporary files (IE cache) generated by surfing the Internet, and check and kill malware.
3.Try to set the IP address to a static IP address to reduce the boot time of the computer.
4.Don't put too many files and icons on the computer desktop, which will slow down the computer's response, and try not to install the software on the C drive. There are too many C disks, and you can also use 360 software housekeeper - toolbox - software to move and solve it.
5.Close some startup programs. Start-Run-Enter msconfig-OK-Click "Start" in the "System Configuration Utility" window-Start, except for the input method (ctfmon) and anti-virus software, the general program can be turned off.
360 Software Manager - Computer Acceleration, Intelligent Optimization Boot Acceleration.
6.It is recommended to install only one main antivirus software, as installing multiple will take up computer resources and make the computer slower.
7.Regularly defragment the disk, open my computer to defragment the disk - Properties - Tools - select the defragmented disk to open the "Disk Defragmenter" window - analyze - defragment - the system will start to defragment.
8.On a regular basis, clean up the dust in your computer.
9.Regularly clean and optimize your computer.
10.The computer hard disk is used for a long time, it will also make the computer slower, repartitioning and installing can fix the logic is bad, the computer will be faster, and the physical read and write speed of the hard disk is slow, and it can only be changed to a better point! The memory module can also be erased down to prevent oxidation.
The system is used for a long time, the computer will run slowly, not that the computer configuration is not good, but the computer garbage and plug-ins are too much, the boot startup project is too much, resulting in the computer card, and the slow situation, at this time, the best choice is to reinstall the system, reinstall the system, will only change the system in the computer C disk, like the computer D and E and F disk files and things will not be less.
According to your computer configuration, you can install the 64-bit operating system of win7. Use the computer hard disk to install the system, you can install the win7 system, the specific operation is as follows:1First of all, go to the ghost system base.
3.Open the unzipped folder, double-click "Hard Disk Installer", and in the window that opens, click "Install".Can.
4.In the window that appears, the ghost image file path will be automatically added, select the partition that needs to be restored, the default is the C drive, and click the "Confirm the difference" button to install it automatically.
-
1. If the hard disk has bad sectors, use software to repair the bad sectors of the hard disk, format the hard disk, repartition and reinstall the hard disk, and replace the hard disk.
2. Upgrading the hardware causes an incompatible state to crash.
Fourth, if it always doesn't work, it is recommended to overhaul it.
-
I'm glad to help you with a good answer:
This is your electric pure brain boot boot program too much.
As a result, some auto-start programs will be started when your computer is turned on.
You try optimizing some software that your computer doesn't need.
I wish the main worker a smooth and happy life!!
-
This phenomenon is usually caused by poisoning. Of course, it could also be a hardware issue. It is recommended to try the antivirus after booting, if it is invalid, and then test the hardware, generally memory, CPU, graphics card.
The computer is too stuck, because of the garbage cache in the computer, malicious plug-ins and other reasons caused by Caton, it is recommended that you use Tencent Computer Manager, Tencent Computer Manager has a professional intelligent screening function, to help you divide the useless garbage cache, etc., one-click to clean up the garbage. There is also a high-energy cleaning plug-in, which helps you intelligently distinguish what is useful and what is not, and you can selectively clean it up according to your own Xi Peichun computer situation.
-
It may be the source of the disadvantage caused by the problem of the landlord's network speed allocation, if the landlord himself uses the network independently, you can use the network speed protection to prioritize the web page, open Tencent Computer Manager - the hand toolbox in the lower right corner of the home page interface - click Internet speed protection - select the bar and select "Web Page Priority" - Complete.
China's first, the first product that responds to the international mainstream and integrates anti-virus + management functions. On the basis of 6 years of security service and the experience and professional strength of protecting hundreds of millions of netizens, it was born.
-
It may be that there are too many background processes in the landlord's computer, or it may be that the computer garbage has not been clear for a long time.
Then click on the computer stove to speed up, optimize it after scanning, and then restart the computer, and you're good to go.
-
The more garbage the system gets older.
This can cause your computer to slow down or get stuck.
It's best to check it all out.
Prevention is the virus playing tricks.
If you have too many games, too many applications, and too many old materials installed in your system, your computer will run slower and slower, and the boot time will become longer and longer. Therefore, it is a good idea to do a comprehensive maintenance of your computer every once in a while. Click "Start" "Programs" "Accessories" "System Tools" "Maintenance Wizard", and then click the "OK" button to perform a comprehensive maintenance on your computer, which will keep your computer in the best condition.
For hard disks, it is best to do "disk defragmentation" every 2 weeks, which will significantly speed up the program startup, click "System Tools" "Disk Defragmenter". Note that when defragmenting the disk, the disk where the system is located must be organized, so that it can be true.
Speed up the boot sequence of Windows.
Your situation is typical for booting up and needs to be warmed up. Under normal circumstances, the computer does not need to be warmed up, it is required"Preheat"If it takes a while to boot up normally, you can check whether the capacitors on the motherboard are normal, especially some of the capacitors around the processor. If capacitance is found. >>>More
1. The CPU is overloaded, or it is not working properly. Check CPU and graphics card cooling, dust removal, oiling, or replace fans. >>>More
1. Establish a dial-up connection and save the username and password; >>>More
There's a problem with the motherboard settings.,There's a power supply setting.,I'm not very clear about what the specific place is.,Open it yourself and see it.,It's English.,You should be able to understand it.,No, find a dictionary to look it up while looking!
Do you dial out the CPU and plug it into another computer first, or is this a pure core question? If so, it is estimated that the CPU is not compatible with the motherboard, or the CPU working voltage is not compatible with the working voltage of the power supply. >>>More