The Apple 4S I just bought, the electricity is always disconnected when charging, one will rush, and

It is recommended to use the following methods to check the cause of ** and then solve it:

1. The voltage is not enough: it is recommended to change the socket, if it was originally plugged into the computer for charging, change it to the socket and plug it in.

2. The charger or data cable is not original: replace it with the original mobile phone data cable and the original charger and recharge.

3. Check whether the room temperature is too low: Apple has set up a low temperature protection for the iPhone battery, and sometimes the phone will not be able to charge if the temperature is too low, so as to prevent the deposition in the battery, resulting in a short circuit inside the battery.

4. The charging head has been used for a long time and is aging or the interface is dirty: change the charging head. Take a thin piece of metallographic sandpaper and cut it out to a suitable size, fold it in half a few times, and gently rub it in the interface a few times.

5. The charger or data cable is broken: It is recommended to change the data cable or charger.

6. Battery damage: If you still can't charge despite the above reasons, and suspect that the mobile phone battery is damaged, please go to the local after-sales point for testing.

You try it with a different data cable first, and then look at the charger. Both of these are fine, and then see if it's a problem with your own circuit. Change the plug. It's not a matter of mobile phones anymore.

If you have a problem with the battery compartment plugging in the tail, you can replace it.

Verify whether it is the first 4s

Try to change the cable, and you must change the mobile phone problem.

The reasons why Apple will be disconnected for a while while charging are as follows:1. There are stains on the connector of the mobile phone data cable, resulting in poor contact.

2. The power supply is not plugged in, or the data cable and the mobile phone interface are not plugged in.

3. The use of non-original charging heads or data cables causes unstable charging of mobile phones.

4. There is a problem with the power supply part of the mobile phone.

The charging method of the Apple phone.

1. Use the original charging cable: The design of the iPhone charging cable is very exquisite, in addition to charging, it also has the function of transmitting data, if we do not use the original charging cable to charge, it is likely to damage the battery of the mobile phone.

2. Pay attention to the number and time of charging: When the iPhone only has one-third of the battery left, it needs to be charged. If you wait until the phone is almost out of battery or even turn off and then charge, it will cause more damage to the phone battery.

Hello, please wait 3 minutes, I'll be right away, and I'll reply to your question right away. Hope I can help you oh not a robot oh honey need to type to reply to you.

Good evening Dear, I am a digital expert on Xiaomeng's mobile phone, and I will answer for you now The iPhone will be charged for a while and will not be charged for a while, because the interface at the bottom of the phone is blocked by foreign objects. There are many reasons for the loss of the general mobile phone battery, for example, the charger, the charging cable combination, when you do not pay attention to the charging temperature, the number of charges after charging can not be too much, when charging, unplugging the power ** is not timely, you can keep the battery fully charged, it will accelerate the loss of the battery, and the correct charging habits help to extend the battery life.

The biggest reason is the poor contact of the charging port of the mobile phone, you can send the mobile phone to the mobile phone store for testing and repair.

Questions. If there is a foreign body, what to do.

If there is a foreign body, use a needle to remove it slowly, or use alcohol to clean it with a cotton swab.

If the charging port is in poor contact, it needs to be repaired.

Questions. Thank you.

I hope mine can help you, you can also follow me, and if you have any questions, please consult me directly, if you have no other questions, the trouble point above the "end of service", move your little hands to give Xiaomeng a thumbs up, your satisfaction is very important to me, oh [call].

Reasons and solutions for disconnecting the mobile phone after charging for a while (applicable to most smartphones such as Huawei, Lingqin and Apple):

1. The mobile phone charger plug is not plugged in properly, resulting in poor contact.

Solution: Try plugging the charger back in.

2. It may be the unstable charging caused by poor contact of the socket.

Workaround: Try changing the outlet where your phone is charging.

3. There is a problem with the charger head or data cable.

Solution: Replace the charger with a new one.

4. There is too much dust inside the mobile phone, which leads to poor contact when the mobile phone is charging.

Solution: Try to clean up the dust in your phone.

5. The mobile phone is charged with a non-original charger, resulting in abnormal charging.

Solution: Use the original phone charger to charge your phone.

6. The mobile phone battery is aging, resulting in poor contact with the mobile phone.

Solution: Get a professional to check it out.

7. Abnormalities caused by malware or mobile phone virus intrusion on the mobile phone.

Solution: Uninstall the malware on the phone and carry out a comprehensive anti-virus on the phone, and find a professional to solve the problem if necessary.

8. The hardware of the mobile phone is damaged, resulting in poor contact with the mobile phone.

Solution: Contact the mobile phone after-sales service and find a professional for maintenance.

There are 7 reasons why.

The socket is out of power. The charging cable or adapter is damaged.

Use a non-original charging cable or adapter.

There is a foreign object in the charging port of the mobile phone.

There is a bug in the phone's system.

The temperature of the phone was too high, exceeding 35 .

There is a malfunction of hardware such as the battery.

Hello, I'm glad to answer for you, the reasons why Apple will break for a while are as follows: 1. There are stains on the mobile phone data cable connector, resulting in poor contact. 2. The power supply is not plugged in, or the data cable and the mobile phone interface are not plugged in.

3. The use of non-original charging heads or data cables causes unstable charging of mobile phones. 4. There is a problem with the power supply parts of the mobile phone.