TE1402 Divide Bandwidth Equally, TE1402 Router Bandwidth Setting How to Set

1. Enter the route first find the MAC address binding, and bind the 6 computers in your dormitory to the MAC (network card) address If you assign an address, please assign a fixed intranet address to each computer first Set only the computer bound to the MAC address to access the external network 2. Enter the QoS setting 6M broadband**The maximum speed is about 620KB Then set the maximum downlink speed of each computer to 100KB Uplink 80KB I don't know if your route has a setting to borrow free bandwidth If you have one, you can also set it up so that you don't waste bandwidth.

The best thing to do is to buy a router with an IP-controlled rate limiting function, which is too cumbersome to restrict with software.

This router doesn't come with this feature.

Divide the total bandwidth by 4 to get the bandwidth for each person...

And then use P2P to make everyone limited to Tong Shenshan so much speed in the game.,That's it.。。。

Note: The uplink bandwidth is half of the downlink bandwidth, so you have a total of 1M uplink bandwidth.

You don't have to cut off the oak front, as long as you don't watch a movie, 4 more are enough for you, as long as you have 1 person** or watch a movie, then you don't have to play.

Dusk. Router Management Interface Traffic Control.

As far as I know, only the more expensive limb with routers has the macro smile with bandwidth function.

Let's just say it's okay to communicate.

If the speed limit function is used, the route speed limit is preferred.

If Qingchangguo does not have it, it is recommended to use Jusheng network management to limit the speed. Note that it is best to distribute the front hall evenly.

Just use a router.

Not all routers have the function of traffic control, so you have to pay attention to the specific configuration inside. If that doesn't work, you have to use other software.

Start-Run-Input: Under the Management Template under Computer Configuration (Network - QoS Packet Scheduler) and find the "Limit Reserved Bandwidth" option in the right window. Set the values inside and try it.

Try it with Jusheng network management.,This is very easy to use.,The operation is relatively simple.。。