Is there any other way to get rid of the computer noise than turning off Front Pink In?

Updated on technology 2024-05-08
14 answers
  1. Anonymous users2024-02-09

    Computer noise requires the following judgments:

    1.Whether or not an on-board sound card is used, the on-board sound card is prone to noise because the signal-to-noise ratio is lower than that of a premium sound card.

    2.Whether the noise is heightened when launching large programs or games, or even intermittent zi zi. If this happens, the quality of the sound card is not up to par.

    3.Consider upgrading your sound card to the latest drivers, which may provide improvement.

    Subwoofer and headphones also have noise, it is certain that the noise source is in the chassis, if there is an independent sound card, you can judge whether it is a quality problem of the onboard sound card through the independent sound card. If the noise is an independent sound card, then it means that the quality of your sound card is very poor, or has been aged, you can consider using a metal mesh to cover the independent sound card to reduce the noise interference from the electromagnetic environment of the chassis.

  2. Anonymous users2024-02-08

    Here's how to fix the noise on your computer:

    1. The computer start menu ——— run——— enter "regedit" - OK.

    2. Open the registry.

    3. Left-click to select "hkey local machine", right-click "Find" - enter "render" (case differentiation needs to be distinguished), check the "item" and "whole word match" below to find the next one.

    5. As shown in the figure, click on the second sub-item and check the item with the median value of 1 in "properties", and the value after the parentheses of the item is 7. As shown in the figure, the number after the parentheses at the drawing line is 7, type: reg dword data:

    6. This is the item to be found and modified, just change a number.

    7. Select the item, right-click - rename, change the parenthesis after 7 to 6 or 9, and complete.

  3. Anonymous users2024-02-07

    In the sound control (the small speaker in the lower right corner), just mute all the options except the first two.

  4. Anonymous users2024-02-06

    It's useless to reinstall the system.,I'm in this situation too.,Turn it off when listening to songs.,Turn it on again when you're listening.。

  5. Anonymous users2024-02-05

    Front Pink In is the front panel microphone jack.

    Most integrated sound cards have this problem, even when using a microphone, there will be a lot of noise.

  6. Anonymous users2024-02-04

    Master Volume-Rear Pink In-Mute should be checked and will not affect your voice chat with your friends. If you don't check it, you can turn on the microphone all the time. So your speaker will make noise.

  7. Anonymous users2024-02-03

    Rear Pink In is the microphone connector on the front of the computer!

  8. Anonymous users2024-02-02

    As far as the phenomenon is concerned, it is a problem with the sound card setting, and I inadvertently chose the wrong setting, and the seller or a friend who understands the computer remotely, and re-set,

  9. Anonymous users2024-02-01

    Double-click the small speaker in the lower right corner to open the audio properties Options-Properties-Show the following volume controls-Tick them all-Click OK,Except for the main volume,Mute them one by one until the noise disappears,My situation is a little different from you,Mine is to mute the front pink in and the noise is gone。 Then I opened the front pink in advanced options again, and found that the microphone reinforcement was ticked, and then I removed the microphone reinforcement hook, and the front pink in was not muted and there was no noise.

    Own experience.

  10. Anonymous users2024-01-31

    Play a few songs*** and then re-plug the speaker cable.

    Cause of the failure system First, try all of the following solutions.

    The first type of system problem is to go back to the original or redo the system with one click.

    The second type of software problem is to reinstall the software under it.

    The third software virus residual file cleans up the memory.

    Fourth, the software is incompatible with the software.

    Fifth, the cache settings are not reasonable, and the cache is reset.

    Sixth, the system is short of resources, and the memory is deleted and cleaned up.

    The seventh type of virus, Trojan horse detection and killing virus.

    Eighth, the hardware is overheating, the CPU is too hot, and the heatsink is too dusty.

    The ninth hard drive problem is to clean up the disk. Defragment the disk.

    The tenth type of hardware quality hardware should be jumped.

    The eleventh type of hardware overclocking is to de-energize the battery.

    The twelfth type is that the hardware environment is incompatible and re-replaced.

    Only lift the arch solution. No explanation is given.

    1: To boot the computer, restore the BIOS to its factory state. (Battery de-energized) is more critical and must be done.

    2: You copy the following command or in. Command Prompt Input:

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    regsvr32 /s

    3: Restart your computer. Do a comprehensive antivirus.

    Then do the following four points faster on the computer.

    The first is to close all startup items. (msconfig) in Run (tick) ctfmon

    and anti-virus software.

    The second is to empty the ** station. The system needs to clear IE temporary files and records. Delete your own use.

    Patch files. Third, set up a firewall. Right-click on properties on my computer. Point System Restore. (tick).

    Fourth, turn off System Restore on all drives. Turn off automatic updates. Open the Advanced System Properties dialog box, click Settings in the Startup and Recovery area on the Advanced tab of the System Properties dialog box, and uncheck Auto Restart in the Startup and Recovery dialog box.

    In the Advanced tab, click the dot Error Reporting and the dot Disable Error Reporting

  11. Anonymous users2024-01-30

    Turn off the line input (front pink in) in the small speaker attribute (mute), it's fine, I just got it right, and the effect is super good!!

  12. Anonymous users2024-01-29

    Try to change the audio cable, or insert and dial when you put **, see what the reaction is, sometimes the ground wire of the audio cable is not in good contact.

  13. Anonymous users2024-01-28

    Hello you can put the question on the sound source, focus on checking it. For example, use headphones to judge.

    The power supply is not very likely, (you can filter it by adding two 104 capacitors to the power supply input.) At the signal input end first, just 103 or 102 to see how it goes.

  14. Anonymous users2024-01-27

    Refers to the pink microphone (microphone) input port on the front of the computer case.

Related questions
7 answers2024-05-08

How to get rid of bad breath with dried tea: put a few tea leaves and chew them in your mouth three times a day, so that you can keep the fragrance in your mouth, and get rid of bad breath after three days.

21 answers2024-05-08

The most famous strong woman in the Qing Dynasty is Cixi in the late Qing Dynasty, that is a person who survived the late Qing Dynasty, although there are different opinions about him in history, but she is definitely one of the best strong women in history.

19 answers2024-05-08

CPU, memory usage is great, and the graphics card is slow.

7 answers2024-05-08

If you plant eucalyptus trees in Guangxi, of course, it is the tree species of this shusheng, and you still want to grow fast, I think it is the paulownia tree, the paulownia tree grows very fast, and the poplar tree also grows relatively fast.

23 answers2024-05-08

1.If the display screen flashes for a while, and then it is normal again, this problem is that the refrigerator does not reach the artificially set control temperature, no temperature signal is detected, and the LCD screen cannot receive the flickering caused by the signal. Just be careful not to open the refrigerator frequently for a long time without closing the door, the storage inside should not be too full, and the food that has not yet cooled should not be put in the refrigerator in a hurry, and pay attention to the outside of the refrigerator There are 2 >>>More