The motherboard keeps beeping and won t boot!

Reinstall the memory module graphics card, clear the CMOS settings and try it, if these don't work, it's usually a hardware problem.

HWG4242 is quite right. lz does not prevent the test.

It rang three times quickly, right?

Generally, there is a problem with the memory, unplug it and rub the gold finger and press the strong point OK

Generally, the motherboard rings because the hardware is not connected properly, and there are few BIOS problems, so it is useless to empty the CMOS.

Added: If it is tick. Tick tick. If one is long and two short, the graphics card is not installed, you can try again, unplug the graphics card, erase the gold finger with an eraser, and then install it.

Attached: Award BIOS

1 Short: The system starts normally. Shows that there is nothing wrong with the machine.

2 Short: General error, please go to CMOS installation and re-set the incorrect options.

1 long and 1 short: There is an error in the memory or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard.

1 long and 2 short: The display or graphics card is wrong.

1 long and 3 short: The keyboard controller is wrong. Check the motherboard.

1 long and 9 short: The motherboard BIOS chip is wrong, and the BIOS is damaged. Try a different BIOS chip.

Long Ring: The memory module is not plugged in tightly or is damaged. Reinsert the memory module, or replace the memory.

ami bios

1 Short: The memory refresh failed. Replace the memory module.

2 Short: The memory ECC verification error is incorrect. In the CMOS settings, the memory option for ECC check above can be disabled, but the most fundamental solution is to replace a memory.

3 Short: The basic memory check of the system fails. Change memory.

4 Short: The system clock is wrong.

5 Short: There is an error in the CPU.

6 Short: Keyboard controller error.

7 short: The real mode of the system is wrong and cannot be switched to protection mode.

8 Short: Video memory error. If there is a problem with the video memory, try changing the graphics card.

9 Short: BIOS chip detection error.

1 long and 3 short: memory error. If the memory is damaged, it can be replaced.

1 long and 8 short: Displays a detection error. The monitor cable is not plugged in properly or the graphics card is not plugged in properly.

Not necessarily but ......Because my ami is a normal start ......

You can try the plugging and unplugging method, first unplug the memory and boot the computer. If it's a long ring, then there is no problem with the memory. Next, install the memory, unplug the graphics card and turn it on. If it rings three times, your graphics card is broken.

The graphics card is not recognized, or it is broken, reinsert it, and then pull it up a little, or turn it left or right to start the test, try dozens of times, if it still doesn't work, change the graphics card.

A lot of it is not good contact, and the honest plug is always bad, so it has to be biased.

It's that the memory is not plugged in well, and it is OK to reinsert it

The motherboard will not be called specifically to hear clearly before asking.

Did you have an alarm when you turned it on? If not, you'd better open the case and observe when he calls the alarm to see if it's alarming from time to time, and you may be alarming from time to time.

The power supply is wrong or the graphics card is wrong.