What should I do if I encounter such an interface when installing Ubuntu?

It's installed with an ISO file.

Make sure there is no problem, write to USB flash drive correctly? Change the write method like raw or something.

The Ubuntu method of installing the GUI can be achieved by following these steps:

1. Confirm the version: First log in to the server ubuntu to check the system version. Then log in with root as shown in the image below:

2. To update apt-get, you must first update the apt-get source and enter apt-get update.

3. Install xinit, which we need to install when we switch to the graphical interface, such as startx and enter the command apt-get install xinit.

4. Install the GDM desktop, then install the GDM desktop, apt-get install GDM, and install the GDM package.

5. Then install ubuntu desktop package, apt-get install ubuntu-desktop, of course, there are many types of desktops here, and kubuntudeskto is used here

6. Install Chinese supportIn addition, we also need to install the Chinese language pack apt-get install language-support

7. Restart the system After the above packages are installed, reboot the server

8. After the login GUI is restarted, we can log in to the UBUNTU GUI.

9. If you enter the character interface, we can switch it through the startx command.

You made a mistake, it's sudo apt-get install ubuntu-desktop

This command will install the standard ubuntu interface for you.

You can also install a KDE-based interface with the commands:

sudo apt-get install kubuntu-desktop

It's actually quite simple:

Step 1: apt-get install taskselStep 2: Execute tasksel

Just choose Ubuntu Destop and Gnome ......The above command requires root privilege.

Wubi kills people It's not easy to update the system with wubi.,There will be problems.。。 It is recommended to install ubuntu natively, and it is not troublesome. You're on the grub page, right?

If I install it normally, I can have a way.,But wubi pretended that I couldn't do anything.,Because I searched all the information before and didn't find it.。。 Because wubi's bootstrap is very different from grub's bootstrapping.

First of all, the installation of the Ubuntu server version will not be repeated here, the basic is still three steps, the first is the ** image, then use Ultraiso to burn to the U disk, and finally install it through the U disk boot. During the installation process, you will be asked to enter a username and password, which must be remembered, as a password is required for subsequent software installations.

Then, after login enters the system, the user interface is installed. Start by entering the following command:

sudo apt-get install xinit。The interface at the time of installation is shown below.

After the above installation is complete, install Environment Manager. I personally tested that it was GNOME installed. Run the following command to install:

sudo apt-get install gdm

The interface at the time of installation is shown below.

Then, install the desktop environment. I personally tested the installation of kubuntu.。 The installation command is as follows:

sudo apt-get install kubuntu-desktop

The interface at the time of installation is shown below.

Some people on the Internet also say to install some necessary packages, such as Xinlide package manager, Chinese support, etc., if you are troublesome, you can not install. After the above installation is completed, reboot directly. After the reboot is completed, you can enter the system again, and the graphical interface will be displayed, as shown in the figure.