Is it normal for the legendary GA4 engine to be too hot?

Definitely not normal, the reason why the water temperature of the car engine is too high:

1. Insufficient engine coolant;

2. The water temperature sensor or water temperature meter is faulty;

3. Downwind driving or long-term low-speed and high-load driving in high temperature season;

4. Ignition time too early or too late;

5. The blinds cannot be fully opened;

6. The mixture is too thin or too thick;

7. The outside of the water tank is dirty or the internal scale is serious, resulting in poor heat dissipation, and the water tank needs to be opened (cleaned) or replaced;

8. The fan clutch engages too late or the cooling fan does not work, the fan rotation resistance is too large, the blades are installed in reverse, the blades are damaged, etc.;

9. The performance of the electric fan is poor or there is no high speed;

10. Excessive carbon deposition in the combustion chamber;

11. The water pump belt is too loose;

12. There is a problem with three-way catalysis;

13. The phenomenon of "punch" is caused by air and water;

14. The thermostat is not opened well and needs to be replaced;

15. Other water pipes, elbows and water holes of the waterway are blocked;

16. The pump does not work well (the circulating water volume is not enough);

Solution: If the temperature of the car engine water tank is too high, you should pull over and stop in a safe area, erect a warning sign next to it, open the engine cover, and turn off the engine. Then wait a while until the water temperature of the engine has dropped sufficiently, and then check the amount of cooling water in the engine.

Check the water level of the engine water tank and add enough water, bring a wet towel to cover it when opening the water tank cover, loosen a little and slowly release the gas to prevent hot water from spraying out scalding, and then check the entire cooling system, the radiator, cooling fan, water tank, thermostat, and water pump are working normally, and after confirming that there are no other faults, you can start the engine and continue driving.

If there is no shortage of water, if the engine overheats and the temperature of the water tank is high, it is a mechanical failure, so you have to go to the repair shop.

It is not normal for the engine temperature to be high, and if there is no lack of lubricating oil in the engine, there will be no such phenomenon, and the built-in components will be worn.

During the use of the GAC Trumpchi GS4 engine, the fuel in the cylinder is burning, so the heating is normal. But if the engine overheats it is not normal, be careful.

There are many reasons why the motive is overheated. When this happens, try to check the following recommendations:

1.Thermostat block: The thermostat does not open and close properly, usually due to mechanical failure or incomplete filling of the cooling system. The updated thermostat has a different temperature coefficient from the original oak penetration, resulting in failure.

2.Fan problem: The fan motor does not move or the fan clutch is faulty and cannot be cooled properly.

3.Coolant leakage: If the pipes of the cooling system are broken, the coolant will be lost and the heat dissipation will not work properly; This situation can be improved with a new tube Kaizai.

4.Radiator cover: If the pressure of the radiator cover is different, the spring will come loose and the cover will not close tightly.

5.Exhaust: The three-way catalytic converter is clogged or the pipe is ruptured, resulting in a clogged exhaust and the engine overheating.

6.Water pump: After the water pump is highly worn out for a long time, the parts wear and fall off; The only solution is to replace this pump with a new one.