ASUS F8VA, P8400 CPU, HDD Seagate ST9320320AS system is running very slowly, how to fix it? 5

Hello! Clean the case (if it is a notebook to clean the fan dust) dust, in fact, many people's computer cards, the slow running speed is actually due to the CPU, the graphics card is caused by poor heat dissipation, out of the protection mechanism, so that their working frequency is reduced, resulting in a special card of the computer, this situation mainly appears in the summer or a year does not clean the case (notebook) dust of the computer.

Detect and kill computer viruses and Trojan horses. Many computers have become particularly slow in recent times, so you need to pay attention to this time, it may be a virus in the computer, which causes the work efficiency of your computer to become low. Use antivirus software to completely eliminate the virus, and then use system repair software such as 360 First Aid Kit to repair the system.

3. Clean up the boot startup items and let the computer travel lightly. Many computer families do not pay attention when installing software, resulting in too many startup items, and they have been carrying these "burdens" when the computer is running normally, resulting in the computer slowing down (such as QQ, Thunderbolt 7, Kuwo and many other software are the default boot auto-start). Click "Start" - "Run" - enter "msconfig" - "Start" in this to close all the items that do not need to be booted (you can check them all off, and open them manually when you need a certain software) - "OK" - "Restart the computer".

Clean up your computer's junk. Some people's computers have not cleaned up the computer garbage since they bought it, and they only know how to install the software into the computer, but they have not uninstalled the unwanted ones, and many software even if they are uninstalled, but there will still be residual information in the computer. Click "Start" - "Programs" - "Control Panel" - "Add or Remove Programs", uninstall the unused software, and then use Master Lu or 360 Security Guard to clean up the junk files (cache, registry residual information, etc.) on the computer.

Finally, defragment the disk, double-click to open "My Computer", right-click above the drive letter - "Properties" - "Tools" - "Start Sorting", and you can finish. 5

Troubleshoot bad sectors on the hard drive. After long-term use of the computer, the wear and tear on the hard disk will be great, and the damage to the hard disk generally starts from a small part of the bad sector, and then gradually gets worse and bigger. Use software (you can search for the hard disk bad sector elimination tool) to find out the bad sectors and mark them or set them to hide, and the next time you use the hard disk, you can directly remove the bad sectors and speed up the hard disk.

Set up virtual memory. Programs running on a computer need to be executed through memory, and if the program is executed that takes up a lot of memory or a lot, it will cause the memory to be depleted. To solve this problem, virtual memory technology is used in Windows, that is, a portion of the hard disk space is used as memory usage.

My Computer" Right-click - "Properties" - "Advanced" - Performance "Settings" - "Advanced" - Virtual Memory "Change" - "Custom Size" (times the physical memory).

If it's a 64-bit system, then you can modify the 32-bit one to try, if it's already 32-bit, then please clear some unnecessary boot items, if there is no one to clear, or so, then obediently change back to XP, or replace the hardware CPU, add memory. 32-bit win7 is also quite easy to use, 64-bit occupies a bit more memory.

Sometimes, a reinstallation of the system can improve the operational performance of the machine, and the aging of the system is one of the reasons for the slow operation.

Vista is a garbage system,It takes up a lot of resources,If your memory is small,The card is normal,It is recommended that you change it,Replace it with XP or Win7,Now no one uses Vista this garbage system。

32-bit is good, and maybe your CPU is too weak, my Q8300 is no more than 60% open in some big games such as QQ+**+ Web + Thunderbolt + Call of Duty

You've got too many processes, and it's a bit choked with Vista 1G of RAM.

Hello! The noise of the computer mainly comes from the fan, and many materials have introduced the method of filling the fan with oil to reduce the noise, but I think that the noise of the fan is not necessarily due to the lack of oil in the bearing.

The "eccentricity" of the fan's blades is the main cause of the noise. High-quality fans, the center of gravity of the fan blades on the axis, the operation is very stable, the noise is very small, and the inferior fan, there is often a certain deviation, the center of gravity of the fan blade does not cause "eccentricity" on the axis, such a fan rotates, it is equivalent to an oscillator (the oscillator is to add an eccentric wheel on the motor shaft), with the use of time, the fan bearing gradually wears, or the fan heat sink is not firmly installed, loose, etc., will make the vibration aggravated and the noise becomes larger. The simplest solution to this type of failure is to install the fan as firmly as possible so that it cannot vibrate, of course, this method does not solve the substantive problem, because the fan blades are still "eccentric"; Another method is to inject oil into the fan bearing to cushion the vibration and reduce the noise; There is another way to solve the problem at its root:

Remove the fan blade, use a thin wire to hang the fan blade through the small hole in the center of the fan blade of the town beam, if one end falls, it means that this end is heavier, you can grind a few times on the limb Hu grinding wheel, so several times, and then use a thin wire to hang the fan blade, if the fan blade can be static in the horizontal position, indicating that the transformation is successful. A few questions about oiling the fan:

1.Sewing machine oil or engine oil, I recommend using four-stroke motorcycle oil, because sewing machine oil is very thin, fluidity and volatility, it will not take long after oil injection, and the fan will be "old disease**", and the cushioning effect of sewing oil on vibration is also very small, for weakening noise, it has little effect, and the use of engine oil just avoids the above two shortcomings.

2.After the sealing problem of oil injection, a label paper is attached to the oil injection part of the fan, and after the label paper is removed and oiled, the label paper can generally not be used anymore, what to replace it? I used four or five layers of scotch tape.

Find a roll of scotch tape, use a knife to cut horizontally, cut through about four or five layers, and then peel off these four or five layers of scotch tape together and you can use it. Note that you must not use only one layer of tape, because a layer of tape paper is easy to vibrate and produce noise when the fan rotates, and it may also be damaged and cause the calendar to splash oil. Another advantage of using scotch tape instead of label paper is whether the fan is short of oil, which can be seen at a glance and does not need to be disassembled.

Let's talk about the hard disk first, what you said should be the rattling sound when the hard disk is working, it is recommended that you use the software of bad sector detection to detect, if there is no problem, it is the noise of the head motor working, there is no need to panic, there is noise is normal, but it is true that there is a lot of noise and some noise is small, as long as there is no bad road, it is no problem.

Let's talk about the fan, because this is a CPU fan, you will definitely accumulate a lot of dust in it when you buy it and use it now, the CPU fan is intelligent, and the temperature will determine the speed of the fan before the forest group according to the current temperature when it reaches a certain level, after all, there is dust in it that will affect the heat dissipation effect, so when you buy it, the working time of the large air volume will be more than the original, and the noise is louder than before, these are normal phenomena.

But I want to remind you that don't modify the working temperature of the fan in the BIOS, because the laptop heat dissipation itself is not good, and if you modify it, it will definitely pose a serious threat to your CPU's life! In addition, don't try to change the CPU fan, because I changed it once at ASUS, and I didn't take it seriously, but it crashed when I changed it, and then I had no choice but to take it to the after-sales service and spend money to replace it with an original one.

Because the hard drive is vacuum-encapsulated and cannot be repaired by an individual, it is difficult to find a solution to your hard drive noise problem without replacing it.

The noise of the same model of hard disk will not be very different, you have to carefully confirm in the same environment, usually it will feel less noise outside.

The problem of the CPU cooling fan can be improved by BIOS settings, enter the BIOS settings, find the control options of the CPU fan (in PC Health), there are two options that need to be modified, one is the target temperature of the CPU or the starting temperature, set it to a high point, you can reduce the number of times the fan starts before laughing, and the other is the speed control of the CPU fan, change it to a lower value, don't be afraid, change it to 0, the fan will still rotate.

There are 2 possibilities1. The heat dissipation performance of the notebook is not as good as that of the desktop, and after a while, the fan will work brightly because the internal temperature of the notebook is too high, and the fan will work automatically to dissipate the heat.

2. That is, your machine has quality problems and the fan is noisy, you can try to change the fan to see.

The fan will work for a while and stop for a while, which belongs to the normal work-to-liter key configuration.

The time to buy it back is still short, why not take it to the warranty.

There are many reasons why copying files is slow.

1. Copy the file to see how much memory is occupied.

2. Check the space usage of the disk where the virtual memory is located.

3. Bad areas or bad sectors on the hard disk are also an important factor.

4. If it is copied to the U disk, the U disk has not been used for a long time or has not been formatted for a long time, and if the U disk is not formatted for a long time, the contents will be incomplete or damaged due to physical reasons such as leakage.

Check it out!!

To resolve slow replication, perform the following steps:

1) Click the Start Menu, go to the Control Panel, select "Programs" and open "Programs and Features".

2) Under "Programs and features," select "Turn Windows features on or off."

3) Wait for a while, the "Windows Features" option box will appear, uncheck the "Remote Differential Compression" option inside, and then click "OK", and then restart the computer to improve the problem of slow file copying.

Hello! The F8V is an early machine, and now that it is used, it may be insufficient to be configured. At present, if the memory is 1G, you can add a 2G DDR2 800MHz memory if you are not in charge.

The system uses the Ludong XP system, do not install too much software, and install it that is often used daily.

Hope you find the above information helpful! If the above reply still does not help you, you can continue to ask or contact ASUS service**400,600-6655 for consultation! Thank you!

This is a garbage configuration, it was released in 2008, and it is not as good as the configuration of the netbook in 2010! The graphics card carried by the disturbance is ATI Radeon HD 3650, a garbage low-end entry-level graphics card, a scumbag card that is not even as good as GT 620M, and the CPU is Intel Core T 9400, which is similar to the Pentium, and it is not as good as i3, so the performance of your book is comprehensive, just your book. The configuration has been slowed down and eliminated.,The card is also normal.,Celery pants can be replaced with a new book.。

The computer is updated quickly, naturally, in a long time to put it.

1. First of all, we can do a simple cleaning of the system's chassis, such as cleaning the dust in the chassis to avoid overheating the CPU temperature caused by the dust problem in the chassis.

2. You can add lubricating oil to the CPU fan, if you feel that the strength of the fan is not enough, it is best to buy a new fan, 3. Add another fan on the chassis, which can have a good cooling effect and speed up the heat dissipation inside the chassis, 4. Observe the configuration of the computer, see if the graphics card, memory or CPU is damaged, do a good job of upgrading the system hardware, and quietly replace the old hardware.

The above methods can solve the problem of high CPU temperature of the system, and I hope the above methods will be helpful to users.

Dear ASUS users, Hello!

According to your description, confirm whether this problem occurs after any optimization operations;

1. Try [Settings] -- Reset & Restore --- restore factory default settings;

2. If the system cannot be restored, it is recommended to back up and save important data to SD memory card, and restore factory settings in Shuangqing;

In the case of power off, press and hold the volume up + power button, do not release, enter flash mode--- through the volume button, select to "recovery" -- select wipe data factory reset and wipe cache partition through the volume control button, and click the power button to start recovery; For detailed recovery steps, please refer to the official website