When renovating a new house, should I replace all the electrical wiring?

If funds are sufficient, consider replacing them all. In addition, under normal circumstances, the wire break point is renovated, and the socket that needs to be increased can be led from the socket reserved by the developer.

The opening method of the lamp reserved by the developer (single control, double control) meets our daily needs and can not be replaced.

It should be noted here that the location of the lamp is based on the design of the center of the room or ceiling, and whether the wires in the kitchen socket and the reserved air conditioning socket are 4 square wires, if not, it is recommended to replace them. If there are no high-power appliances in the bathroom, square wires can be used.

Of course, new wires need to be replaced. In the current house decoration, the wires are basically buried in the wall, and the old wires are difficult to repair and maintain once they have an accident. Therefore, replace all the wires to avoid trouble later.

It is best to replace all the wires and rearrange the new lines when decorating the new house, the old lines may continue to be used or there may be some aging problems, and if you are not familiar with the old lines when leaving the old lines, you may not be able to remove the hidden dangers of the old.

There is no need to replace all the wires, and some switches and sockets can be changed. The wires of the new house are still relatively qualified.

In fact, there is no need to replace all the wires, because now the supervision of building delivery is very strong, if there is a quality problem, it is difficult to pass the acceptance, and there are doubts about whether you buy a new wire, so it is not necessary. It is good to replace the new cable with a new socket when a new socket, switch or part of the original socket changes its function.

Wires will generally be buried in the wall, when the wires are not destroyed by smashing the wall, the original wires do not need to be replaced, if the new wires or the original building structure is not installed enough to use the quantity, you can increase the wires according to the demand, you must choose the wires that meet the quality standards to ensure the safety and reliability of electricity.

When renovating a new house, should you replace all the wires according to your own situation? If your home uses a lot of electricity, then it is better to replace it all, if it is not very large, you only need to put the kitchen and bathroom. Well, the wire can be replaced.

They can still use the light line in the evil, and they are all able to use a lot of them.

Yes, the current developer can deliver the wires when they are configured, which can meet the needs of daily use.

This is decided according to the use of the home in the later stage, and there are no special requirements.

In particular, the commercial housing of some large developers has done a good job in the selection of materials and branches of wires and water pipes. All we need to do is fine-tune it according to our actual needs. You don't need to change them all, according to the power used in the electrical appliances at home, compare whether the cross-sectional area of the wires of each branch is enough, for example, now the kitchen electrical equipment is large and many, and the bus to the kitchen is best to be six square lines, and the kitchen equipment is not very powerful, so there is no need to change it.

<>Of course, if you have money, you can change it! Theoretically, such hidden dangers are smaller, but theoretically This is a thing that is not good for "owners" and "social resources", but is beneficial to "decoration practitioners"! Sudden rise in water pressure during the test, how big is the water pressure, and when you hand over your room, the water pressure has been adjusted, you can increase it if you don't change it, you just need to see if it is a copper core wire, it is generally not changed, you can increase but do not use aluminum core wire, you should know that the hydropower warranty of some bad developers is generally two years, if you are a developer warranty for two years, will you spend 10 years warranty cost?

However, the house has to be lived in for 10 years, or even 30 years.

Like the false welding of hot melt welding of water supply pipes, the leakage caused by over-welding quality problems is generally in 5 - but if you replace all the original developer's lines, as long as there is a problem, you can confidently find this decoration company to give you free maintenance (man-made unintentional damage is not included), so that it is not involved in the property side, as long as the owner and the decoration of the new house when the economy allows, it is best to replace the water pipe, because it is not clear how the quality of the water pipe used by the developer, cut off and replace it from the water pipe into the house, In this way, the burst of the water pipe in the later stage can be avoided to a large extent and the loss can be reduced. 10 wires used in the main line of the house, 10 wires can drive about 11,000 watts at most, for home circuits, all electrical appliances cannot be used at the same time, so 10 wires are enough to use.

There is no need to replace all the wires when the new house is renovated, the water and electricity renovation project carried out by the developer before the delivery of the house can meet the basic use requirements, and the wires selected are basically in line with the requirements of the national standards, and the quality of the wires itself is a qualified product.

to be replaced. Because a lot of the wires are old. At this time, it is very dangerous, and all the wires must be replaced when decorating the house.

No, because it takes a long time to replace all the wires and costs a lot of money.

In fact, the original wires are not necessarily bad, and they may be removed if they are finely decorated, because there may not be enough plug-in places, so they need to be re-walked.

There is no need, basically the first use of the developer is qualified, and it will be more troublesome to replace all the wiring, I think when developing a new circuit, use some good wires, it should be enough.

I don't think this thing is necessary, don't you feel particularly troublesome to replace the wire, as long as it has no problems with the circuit, it can be used, but it's still up to you.

There is no need to replace it, because it will only waste your wires, just replace the wires where you need to install the socket, and replace the wires in some high-power electrical places.

Need. Because we need to convert the appropriate wires according to our living habits and the size of the electrical power, to avoid the phenomenon of short circuit or aging of the wires after moving in, which will affect the living experience.

No, when renovating a new house, you should find a professional electrician to check all the circuits and change the wires for the circuits in question.

No, you can replace one part, and the other part should be left behind, and some of the wear and tear and bad ones can be replaced.

Yes, in this case, the replacement of wires is worth protecting, and it can also reduce the occurrence of fires or accidents.

We should replace all the wires so that we can have a better life in the future and avoid unnecessary things happening.

Of course, you need to, because as long as the wires are replaced, you can make your home free of safety hazards and no fires.

It is not necessary to replace all the wires, just replace some of the wires that are often used due to wear and tear.

Many people choose to replace all the electrical wiring in their home with new ones when they are decorating a new house, but this is not necessary. Because most of the wires in the house are buried when building the house, it is difficult to replace them all. At the same time, when the house is built, the wires have been connected, and the home needs to buy their own wires when decorating.

However, there is no need to replace the wires installed by the developer after building the house. <>

When decorating a house at home, the first step is to take water and electricity. Therefore, when taking water and electricity, most people choose to replace all the wires in order to make the wires durable. But in fact, this approach is obviously a bit wasteful, especially for the developer's installed wires, there is no need to renovate them, which is time-consuming and laborious.

When developers install wires, they will choose better quality wires, and also take into account that wires need to be used for a long time. <>

When taking hydropower for the wires at home, you must choose a better wire brand, and most of today's people buy wires based on copper wires. Because the copper wire is more durable, the ** of the copper wire is also the highest, for the ordinary small family in the decoration, it is generally the best to choose to use a 4 square line. Because a variety of electrical appliances are used in today's home decoration, it is better to choose more power than smaller power when choosing to install wires.

There are many brands of home decoration wires on the market, and when choosing home improvement wires, you must choose a better brand. Most of these brands have quality assurance, and at the same time, the wires should be selected as the best, especially when walking the wires, according to the experience of the decoration master. Most of them bury their electrical wiring and pipes in the ground, so that if there is a leak in the water and electricity in the home, there is no way to repair it.

So in order to prevent waterproof conduits from loopholes, you must choose the best product.

I think it depends on whether your budget is enough, if you have a spare budget, I think it is a good choice to replace all the wires, after all, the wires are very dangerous and daily necessities, if you want to live in the future is not so troublesome, I personally recommend replacing them.

Yes, there is no problem with the use of the wires delivered by the developer at present. The quality is no problem, and it can meet daily use.

No, you don't. Because it will be very expensive to replace it all, there are some threads that do not need to be replaced, which can save a lot of money.

This is not required, and there is no need to replace all the wires in places that are not commonly used, which can also reduce some costs and shorten the construction period.

Yes, because we are not sure whether the line used by the decorator when building the house is not good, and it is very troublesome to overhaul it.

There is no need to replace the developer's original wires.

NowMost developers are actually looking for quality firstThe wires they use are all of the top brands in our country.

Generally speaking, developers choose wires, have to go through some strict procedures。The first step is to choose a cooperative manufacturer according to the manufacturer's popularity and the recognition of the material. The second step is to strictly confirm the samples of the materials sent by these manufacturers, and only after passing the standard can they be purchased.

In the third step, after the materials enter the site, each batch must be accepted on site, and then sampling and retest will be carried out in accordance with the regulations. Finally, it is necessary to pass the relevant acceptance specifications before the final delivery can be carried out. Therefore, if it is a regular developer, the wires they use, whether it is the quality of the wires or the quality of construction, are considered to be medium and upper-class.

Personally, I think that if the layout of the electricity point at home meets our requirements, we do not need to replace the wires at all.

Because now the home miscellaneous altar has found that many families are rearranging the circuit when decorating, and all the original circuits are scrapped. But this is wasteful and costs unnecessary time and money.

Therefore, my personal point of view is that we can use the lines originally laid out by the developer as much as possibleIf modification is necessary, partial potential modification can be carried out。The specific method is to use the original circuit to add sockets or switches locally at points that do not meet our use needs.

There is no need.

The new house, whether it is the electrical wiring or water pipes in the home, has been installed by the developer. These water pipes and wires are accepted by the developer, the supervisor and the construction party, and the material acceptance materials are done to meet the relevant standards of the construction industry, the requirements for the use of architectural design, and the brands and specifications of the relevant materials used need to be reported to the quality supervision station of the Construction Committee (Urban Construction Bureau).

If you use substandard products, counterfeit and shoddy products, you will be punished by the industry and compensate for the losses caused.

The cable used by the developer, whether it is purchased by the developer by bidding or purchased by the construction party, needs to be accepted by the material, and the original product quality certificate of the wire manufacturer, the original product quality certificate of the wire manufacturer, and the copy needs to be stamped with the manufacturer's official seal, and the appearance, diameter specification, and conductivity of the wire are checked by the material acceptance party. There is a strict quality management system. And recorded in the record, made into building construction materials.

Therefore, the wires provided by the developer can be used after passing through the relevant departments, in line with relevant industry regulations and national regulations. In addition to the wires in the owner's home, the distribution box and cable in the corridor, the power supply project of the entire community is tendered and constructed by the developer, which does not meet the regulations and cannot be used. The replacement is only to replace your own home, and the entrance cable in the corridor is still provided by the developer.

Inspection of existing wires.

Disassemble the electrical box and look at the wires, or open the panel of the socket switch to check the wiring inside.

Consider whether to replace according to the demand, first of all, according to the layout of household appliances in each location of your new house, calculate the electricity demand of each place, and consider whether the wires should be replaced according to the demand. Check whether the number of wires is enough, and consider whether they need to be replaced according to the electricity demand of different electrical appliances and whether the number of matching wires is satisfied.

To see whether the layout of the wires is reasonable, home decoration is to design the house according to the home habits; The developer is uniformly set up when setting up the circuit, and there may be some places that are not suitable for their own, so it is necessary to consider changing the circuit or even replacing the wires.