Is the new Wuling Light an electronic throttle?

It's not an electronic throttle, so far the throttle of the Wuling Light is all cable.

The electronic throttle uses a wire harness (wire) instead of a cable or a lever, and a micro electric motor is installed on the side of the throttle to drive the throttle opening with an electric motor. The so-called "wire driving" replaces the original mechanical transmission mechanism with a wire.

How it works. The traditional pull line throttle is connected to the throttle pedal at one end of the steel wire and the throttle at the other end, and its transmission ratio is 1:1, that is to say, how much to step on, the opening angle of the throttle is how much, but in many cases, the throttle valve should not be opened at such a large angle, so the angle at which the throttle valve is opened is not necessarily the most scientific, although this way is very direct, but its control accuracy is very poor.

The electronic throttle controls the opening of the throttle through a cable or wiring harness to achieve automatic control function.

This electronic throttle is a high-tech car that is not available at a low price, because it is expensive, and the price comparison is lower when it is installed!!

Generally, the EFI car is not fuel-efficient in neutral, and the cost of electronic throttle is high, so the new light should not be used.

The electronic throttle is not cabled, and it can be distinguished from the board under the foot, and the electronic throttle is like this.

While stepping on the accelerator, see if there is a steel rope dragging under the co-pilot.

Generally, the EFI truck is not fuel-efficient in neutral gear.

That's too technically difficult.

IdlingMotor problems. Go for overhaul.

The idle motor is mainly used to bear the idle speed of the car, and its purpose is to adjust the idle speed according to the engine load at the time of idling. Idle stepper motor.

Fitted in the throttle valve.

Physically, it is used by the engine controller to control the engine idling, and when the engine speed deviates from the idle speed, it is adjusted by the throttle valve, which controls the amount of air entering the intake manifold and is mechanically operated by the accelerator pedal wire rope.

Note. There are many reasons for idling out, and the first thing to do is to analyze the symptoms of idling out. If the engine stalls as soon as it enters idle running, we call it "no idling", and the causes of this failure are generally as follows:

Damage to the engine idle motor or the wiring of the idle motor; Leakage of the vacuum tube of the brake vacuum booster; Broken membrane of the brake vacuum booster; air leakage in the intake manifold; There is a problem with the idle control module in the engine electronic control unit (ECU).

Many reasons can cause the above situation, such as dirty throttle, blocked fuel injector, gasoline pump cannot reach pressure, water temperature sensor damage, spark plug carbon deposit. It is recommended to find a repairer to check it. If it is a new car, it is generally good to clean the throttle.

Have you ever turned on the air conditioner? If the air conditioner is turned on, this phenomenon is normal.

If the idle speed is unstable, look at the 4s to check it.

If the throttle cable of Wuling Zhiguang needs to be replaced, you must go to the 4S shop or repair shop of the car to replace it. Failure to replace the accelerator cable of the car by yourself will lead to damage to the accelerator parts of the car and affect the driving safety of the car.

Although the new car models are electron accelerator control systems, there are still many cars that use accelerator cables. Basically, the accelerator cable is braided from metal that serves as a mechanical connection between the accelerator plate and the accelerator pedal of a car engine. Before messing with the throttle line, figure out if any adjustments are needed.

Look for damage to the outer covering. If the accelerator cable touches any sharp edges or components move away, worn and damaged enclosures will be noted. The metal cables inside the rubber sheath can also be damaged because they can be loose and break at any time.

Remove the old one and replace it with the new one in order. The throttle requires 10 wrenches, and the pedal is a little more laborious, and the small lead bead needs to be cut out.

Summary. Hello dear, the reasons and treatment methods related to Wuling Light automatic fuel throttle are as follows. If the first throttle is too dirty or the idle motor is too dirty, it is recommended to clean the throttle and idle motor first.

Second, if the problem cannot be solved, this suggestion to replace the original idle motor is generally a problem with the idle motor. Third, there is a leakage in the vehicle air intake system, focusing on checking the vacuum pipeline of the carbon canister solenoid valve and the exhaust gas check valve. Hello, I wish you a happy family, if necessary, you can continue to consult, I will always wait for your reply I wish you good luck, everything goes well, and a happy life!

Kiss kiss kiss.

Kiss your town is good, the reasons and treatment methods related to Wuling Light automatic fuel throttle are as follows. If the first throttle is too dirty or the idle reserve motor is too dirty, it is recommended to clean the throttle and idle motor first. Second, if the problem cannot be solved, this suggestion to replace the original idle motor is generally a problem with the idle motor.

Third, there is a leakage in the vehicle air intake system, focusing on checking the vacuum pipeline of the carbon canister solenoid valve and the exhaust gas check valve. Hello, I wish you a happy family, if you need to continue to consult, I will always wait for your reply Good luck, everything goes well, and life is happy! Kiss kiss kiss.

The throttle has been washed, the intake system has just been replaced, in addition to these, what other problems can occur in this situation, hello, this situation should be checked, is it not a lack of engine power? Or it's a lack of cylinders.

There is no engine fault light, this is not enough to change the idle motor.

If the power is fine, then in this case, it is generally enough to replace the idle motor.

To match the electronic throttle of the Wuling Light, follow these steps::

1.Check the date of manufacture of the vehicle, and prepare to purchase the appropriate electronic throttle from the official store of Wuling Yuma.

2.Clean the vehicle's air flow sensor plug and connect the electronic throttle to the air flow sensor plug.

3.Reinstall the connected electronic throttle and check if it is working properly to suppress the fidder.

4.Re-set the parameters on the diagnostic, and adjust the electronic throttle of Wuling Light to make it work properly.

Summary. You're going to have this problem, it's related to the electronic throttle, it's related to both the gas pressure and the brake signal. When the engine computer receives the throttle signal and the brake signal at the same time, it will stop refueling based on the brake signal, and the engine will return to the idle state, and the throttle problem will also cause computer protection, so that it cannot be refueled.

When this problem occurs, you can repeatedly press the accelerator pedal to try it, after pressing the power recovery is the brake switch is damaged, after removing it still does not work, consider the problem caused by the electronic throttle valve or the failure of the accelerator pedal, you can use the diagnostic instrument according to the fault code prompt to further determine the fault point.

Hello, this question can give you a perfect reply, wait for me to sort out the information, I'm typing, 2-3 minutes, don't finish.

The things that should be changed have been changed, the things that should be cleaned have been cleaned, and sometimes they are not oiled.

You're going to have this problem, it's related to the electronic throttle, it's related to both the gas pressure and the brake signal. When the engine computer receives the throttle signal and the brake signal at the same time, it will stop refueling based on the brake signal, and the wheel core engine will return to the idle state, and the throttle problem will also cause computer protection, so that it cannot be refueled. When this problem occurs, you can repeatedly press the accelerator pedal to try it, after stepping on the power recovery is the brake switch is damaged, after removing it still does not work, considering the problem of the electronic throttle valve or the failure of the accelerator pedal caused by the problem before the chaos, you can use the diagnostic instrument to further determine the fault point according to the fault code prompt.

I've changed everything, tell me everything.

In this case, can you read the fault code, throttle damage has nothing to do with cleaning, if it is damaged, the cleaning will not get better, or if it is too dirty, it will not lead to failure, and the throttle failure. Before this situation, the situation still considers that the throttle itself is damaged, the accelerator pedal is faulty, and the brake switch is damaged, and the signal verification cannot pass these three places.

Ask about custom messages].

The reasons why the car fuel pedal cannot be added: (1) The oil circuit is blocked, first check whether the steam filter is blocked, whether the gasoline pump pressure is bright enough, and whether the fuel injector is blocked. (2) The exhaust system is blocked, and check whether there is any blockage in the three-way catalytic converter and the entire exhaust pipe.

3) It may be that the throttle has too much carbon deposit, the idle position sensor, and the air flow meter are damaged.

1. When the vehicle is driving normally, the foot should not be placed on the clutch pedal.

2. When driving, do not use the semi-linkage clutch, and when the semi-linkage is required under special circumstances, the semi-linkage time should be shortened as much as possible to prevent the clutch friction plate from burning out.

3. Due to the progress of automobile manufacturing technology, the two-foot clutch operation method is generally no longer used in cars or some models with transmission synchronizers. However, in special cases, it is still necessary to use it when driving downhill and muddy ice and snow roads that require a quick downgrade of one gear.

4. The speed of the clutch should not be too violent, generally the first gear is the slowest, and the other forward gears should be slightly faster. When starting in first gear, the clutch pedal must be stepped to the bottom. When continuing to upshift, the clutch pedal can be shifted after the clutch friction plate is disengaged, and the clutch pedal does not have to be stepped all the way down.

5. When using the clutch pedal, you should step on the clutch pedal mold with the forefoot part, and do not step on the clutch pedal with the center of the foot, because it is not easy to step on the pedal to the end with the use of the center of the foot, which will affect the operation of starting and shifting. It is also not possible to press the clutch pedal on your toes to prevent slipping.

Answer: Wuling Hongguang is an electronic throttle, and the cable is electronic.

Electronic throttle concept: The electronic throttle uses a wire harness (wire) instead of a cable or a lever, and a micro motor is installed on the side of the throttle to drive the throttle opening with an electric motor. The so-called "wire driving" replaces the original mechanical transmission mechanism with a wire.

Introduction to Electronic Throttle:

In the internals of a motor vehicle, the device that controls the amount of fuel supplied to the internal combustion engine is called the throttle. Its function is to manipulate the electronic throttle opening to control the flow of combustible mixture, and change the speed and power of the engine to meet the needs of the car. The traditional engine throttle control mechanism works by connecting the accelerator pedal (accelerator pedal) at one end and the throttle linkage plate at the other end by connecting the cable (soft steel wire) or tie rod.

However, the application scope of this traditional throttle is limited and lacks precision, and in the rapid development of automotive electronic technology, an electronic throttle (EGAS) came into being.

The electronic throttle is an electronic control device that transmits the signal of the depth and speed of the throttle pedaling through the position sensor, so as to realize the throttle function. This signal will be received and interpreted by the on-board microcomputer, and then a control command will be issued to open the throttle quickly or slowly according to the command. The process is precise and fast.

There will be no problems with mechanical wear.

Hello, yes. Wuling Hongguang is an electronic throttle.

Wuling Hongguang is an electronic throttle, and the cable is electronic.

Hello Wuling Hongguang is an electronic throttle.