What is called a knife job for a lathe to turn a workpiece

Jiangsu Juli Gear Co., Ltd. was founded in 1980, after more than 30 years of development and growth, has become a key backbone enterprise in China's gear industry, and has become the designated drafting unit of the industry standard of the China Gear Association, with a distribution company in the United States, is currently a large-scale specialized production enterprise and export base for the production of high-precision bevel gears in China and even in Asia. At present, there are complete sets of production lines such as Gleason Arc Bevel Gear Milling Machine in the United States, Klingenberg Arc Bevel Gear Milling Machine in Germany, Gleason Arc Bevel Gear Grinding Machine, etc., and many sets of Ipsen controllable atmosphere multi-purpose furnace heat treatment production lines, complete testing methods, equipped with Gleason Gear Measurement Center, Ultrasonic Flaw Detection, Magnetic Particle Flaw Detection, Spectrometer imported from Germany, Zeiss three coordinates and other testing and inspection instruments. The machinable module specifications cover 1-40, the diameter of the machining diameter is 2000mm, the diameter of the spindle through hole can reach 320mm, and the transmission ...

One-knife work refers to a clamping process that does all the processing surfaces at the same time.

If you casually put on one side when you load the blank, you will have to clamp the processing surface on the other side again, so it is not a one-time job.

You're not from Sichuan, I probably understand what you mean!

Your master told you that you are not a knife job on that side, but that you only need to turn around with a knife on the side of the three-grab chuck clamp, but you may have to turn around and turn around on this side.

One-cutter work refers to the machining of all the machined surfaces in one clamping. This is the way to ensure geometric tolerances.

A knife job refers to sharpening a knife to turn a workpiece.

A knife job refers to sharpening a knife to turn a workpiece.

1) Concentrate on understanding the performance of your machine tool, sometimes some equipment wear is more serious, the timing of the knife is not necessarily accurate, you should pay attention to yourself. It can be checked with a magnetic table section.

If it is determined that it is a problem with the machine tool, it is best for the boss to repair it, and if he is unwilling to spend money, then you can only use the dial gauge to solve it. When finishing, use the dial gauge to point to the carriage to feed the tool, and the poor machine tool is also accurate.

2) Pay attention to the processing process. Usually a handicap is produced during roughing. Don't measure the size of the trip as many as you want, it will definitely be a lot of cars. The practice of insurance is to take a small knife and a small car for a short time. It's no problem to measure it, and then go to the knife.

Technology depends on accumulation, and most young people are like this, and they will retreat when they encounter a small problem, so there are fewer and fewer people with technology. Come on!! It takes heart and time to achieve success.

My big car is called a knife, and a small car is called a drill knife.

A little trembling plus the knife is not suitable for that situation.