How can there be fog in a watch without water?

It's just that the water is in, but it's not much, and it becomes steam after a long time.

You don't have to take a watch with you when you take a shower, and I had the same experience running in with fog.

Is it in the environment where the watch is in a humid environment?

Summary. If there is fog in the mechanical watch, it is a more serious fault, and it is generally a problem with the sealing ring that leads to poor sealing. When it's cold, you put your hand on the glass, and after a while it gets foggy, and that's the reason.

Water vapor in the hot air condenses into small droplets when it encounters cold glass.

This one needs to be repaired, go and replace the seal. Fogging can cause the parts inside your watch to rust and gradually slow down. If the rust is severe, it is more troublesome to repair, so please use it with care. Hope it helps, thank you!

Is it normal to have water mist inside the watch.

If there is fog in the mechanical watch, it is a more serious fault, and it is generally a problem with the sealing ring that leads to poor sealing. When it's cold, you put your hand on the glass, and after a while it gets foggy, and that's the reason. Water vapor in the hot air condenses into small droplets when it encounters cold glass.

This one needs to be repaired, go and replace the seal. Fogging can cause the parts inside your watch to rust and gradually slow down. If the rust is severe, it is more troublesome to repair, so please use it with care.

Hope it helps, thank you!

Dear, I hope mine is helpful to you, can you give a thumbs up, thank you I wish you a happy life, happy every day

Wrap the table tightly with several layers of toilet paper or moisture-absorbing flannel and bake under a light bulb for about 30 minutesThis eliminates the mist inside, but do not bake it close to the bulb or bake it directly to avoid deformation of the surface by heating.

Wear the surface inwards and the bottom case outwards on your wristThe water mist on the surface can be eliminated after a few hours.

After a few hours, the watch is removed again and the mist inside the watch disappears.

4. IfThe watch is seriously floodedThat's the bestSend it to the watch shop to rub the oil and eliminate the water in the watchto avoid rust on the parts of the table.

Related Notes:

There is fog in the watch, which means that there is moisture in the watch. In general, although the watch is hermetically sealed, there are very small pores in the joints of the case, especially in used watches. When washing hands or washing clothes or on rainy days, water can enter through these pores, especially the hot steam in the kitchen, which is more likely to soak into the case.

In addition, the temperature is high and the humidity is high in summer, so if the watch is suddenly cold, the air containing more moisture in the watch will condense into mist or water droplets, which will stick to the watch glass. If there are mist water droplets in the table, it should be repaired in time to wipe off the fog water droplets to prevent water from entering for a long time, rusting of the parts, and overcolor of the surface. If there is occasionally a little fog, it will disappear naturally after the climate is dry, and it will not have a big impact on the heart.

It is important for the watch to have less contact with water sources. Then it is not to expose the watch to the sun and not to leave the watch in a high temperature environment for a long time. There is also the need to place the watch in a proper position when we are not wearing it. Finally, after the time is set, the crown must be locked.

Kiss. <>

Wrap the watch tightly with several layers of toilet paper or a damp flannel cloth and bake it under a light bulb for about 30 minutes to eliminate the water mist inside. However, do not close to the bulb or bake directly, so as not to cause the surface to be deformed by heating. 2.

The surface is inward, and the bottom shell is outward, so that the orange cavity is worn on the wrist. After a few hours, the water mist inside and outside will also be removed. 3.

If silicone is available, you can put the silicone with the watch in an airtight container with water. After a few hours, take out the watch, and the mist in the watch will disappear. 4.

If the watch is seriously flooded, it is best to send it to a watch shop to wipe the oil stain and remove the water in the watch to avoid rust on the parts of the watch.