How to deflate the hot water bottle How to deflate the electric hot water bottle?

Wait for the hot water bottle to cool, pull up the small plastic plug, try to lift the small opening of the plastic slightly, and then you can squeeze it but not too hard, otherwise the electrolyte will be squeezed out (it is quite dirty inside).

Lift the exhaust area, then open the plastic cover, and squeeze it slowly, taking care not to get the oil out.

Summary. Hello! 1.

If it's filled with water, the mouth is facing up, and then the plug is pulled open and the gas is released. 2.If it is a warm baby that is charged, if it is often flatulent, you can shake it up and down, left and right when it starts to swell, so that he is heated evenly, and there will be no flatulence.

3.There is also the general warm baby has exhaust holes, you can just flush the flatulence, you can use 1method of deflating.

How to deflate a hot water bottle without vents.

Hello! 1.If it's filled with water, the mouth is facing up, and then the plug is pulled open and the gas is released.

2.If it is a warm baby that is charged, if it is often flatulent, you can shake it up and down, left and right when it starts to swell, so that he is heated evenly, and there will be no flatulence. 3.

There is also the general warm baby has exhaust holes, you can just flush the flatulence, you can use 1method of deflating.

There are no vents.

Very flatulent. Hello! Hello! It is recommended that when the hot water bottle is bulging, you can spread your left and right hands and shake it a few times, and it will generally go down immediately.

First place the hot water bottle flat on the table, the energized interface is facing up, and then find the upper air vent, check whether the small air vent can be taken out directly by hand, if not, then you need to use some tools, such as tweezers, etc.

After removing the vent, press the hot water bottle flat on top of the table with the palm of your hand and slowly press out the air until it becomes its original size.

In winter, when the temperature is low, you will feel hands, and people often stay in an air-conditioned room is not good for your health, so you can wear thicker clothes in winter. However, some people like to buy hot water bottles for heating, but there are also many things that need to be paid attention to during the use of hot water bottles, and improper use will also become very dangerous. So how to vent and deflate the hot water bottle, and whether the water bottle should be vented?

Let me find out below.

How to vent and deflate the hot water bottle:

1. First put the hot water bottle flat on the table, pay attention to the side of the energized interface to go up, and then carefully look for the air vent on the hot water bottle, which is used to release the air in the hot water bottle.

2. Because the vent is relatively small, it is not easy to take it out, if you can't take it out by hand, you can use tweezers in the dust shed.

Pry the plug, be careful when prying, pry all the way up to the side, and never damage the exhaust port.

3. After the vent is pried open, you can deflate, and then gently press the hot water bottle flat on the table until it becomes the original size.

Should the hot water bottle be vented? This problem depends on the specific situation, if it is a new water bottle, there is no need to exhaust, but the electric hot water bottle is used for a long time, and there is a gas expansion after the change of section is energized and heated.