Dell 1427 wireless network card driver forwin7

Dell 1427win7 system wireless network card driver installation steps:

Check whether there is a wireless network card driver].

Check and confirm: 1. Right-click "My Computer" -- Properties -- Hardware -- Device Manager -- Network Adapter.

2. See if there is a yellow question mark? If so, the NIC driver is missing.

2. Put the network card disc into the optical drive, right-click "My Computer" -- Properties "-- Hardware "-- Device Manager", "Network Adapter", right-click the network card -- select "Update Driver", open the "Hardware Update Wizard", select "Yes, only this time" -- Next -- Automatically install the software "--Next", the system will automatically search for and install the network card driver in the CD.

1. Open**.

2. Enter the 7-digit service code or 10-11-digit quick service** on your machine to locate your model;

Note: At present, most chip manufacturers are mainly developing 64-bit drivers. It is important that you use Internet Explorer and turn off your security software to ensure that the plug-in is installed and run smoothly.

You can refer to the following methods for details.

Hello: The following methods are for your reference:

Start by determining how you want to get online, i.e., how you want to access the Internet when you don't need routing. There are two types: dial-up or non-dialing.

Wireless router settings for dial-up Internet access.

1.Disconnect the dial-up network normally (normal shutdown is sufficient).

2.Connect your wireless router to your computer. This step can be connected wirelessly, and the wireless connection has no password by default. Or the LAN port of the router and the network port of the computer are wired. If you are not buying a new router, it is recommended to reset the route (usually with a small obscure button.

Located on the router, press and hold for 10 seconds. Refer to the router manual).

3.Go to the wireless router settings page through your computer's browser (usually or refer to the router body or manual).

4.Set the WAN port to PPPoE dial-up connection and enter the account password. Set the wireless network name and password.

5.Connect the modem (modem) and the router WAN port, if it is a network cable to the home, you don't need to go through the modem.

6.Wi-Fi is available.

Non-dial-up mode: Automatically obtains the IP address or the wireless router settings for the specified IP. The view method is to double-click the NIC icon to view it.

1.Connect your wireless router to your computer. This step can be connected wirelessly, and the wireless connection has no password by default. Or the LAN port of the router and the network port of the computer are wired. If you are not buying a new router, it is recommended to reset the route (usually with a small obscure button.

Located on the router, press and hold for 10 seconds. Refer to the router manual).

2.Go to the wireless router settings page through your computer's browser (usually or refer to the router body or manual).

3.Set the WAN port to automatically obtain an IP address or enter a specified route. In general, it is recommended to clone the physical address of the NIC to prevent the upper network from throttling. Set the wireless network name and password. It is recommended that you modify the network segment of this router and do not connect it with the parent router.

Conflicting by device. Generally, it can be modified to sufficient.

4.Connect the LAN port of the higher-level router to the WAN port of the local router.

5.Wi-Fi is available.

It may be that the wireless driver is not ready, it is recommended to update the wireless driver from the new one or use the 360 network disconnection first aid kit to detect.