How to disassemble the watch to adjust the time, how to remove the watch to adjust the time?

After >>, you can continue to disassemble the movement, hands, etc. of the watch.

Pay attention to the use of a professional dismantling tool - needle lifter to avoid touching the watch needle, remember to put away the parts when dismantling, so as to facilitate the reinstallation later.

1. First of all, put the back cover of the watch shaft to be disassembled.

2. After that, use a screwdriver to remove the screws on the watch cover.

3. After that, use small tweezers to clamp the gear behind the table.

4. After that, turn the watch shaft, and at the same time clamp out the linkage shaft around the gear with tweezers.

5. After that, the gear shell can be clamped out with tweezers.

6. After that, the gears in the table are clamped out one by one.

7. After that, unscrew the screws immediately adjacent to the watch shaft.

8. After that, the round shell on the fixed watch shaft can be removed.

9. After that, you can take out the watch shaft by hand.

<><3. Then look at the back of the watch, quartz watches are glanded, so it is very convenient to disassemble, and it is easy to open the bottom cover by prying the reserved card position on the main bottom cover with a knife, as shown in the figure.

1. Remove the screws from the electronic watch with a small plum screwdriver, and slowly lift the back cover with a small flat screwdriver (some contain a waterproof sealing ring, pay attention to the installation method), so that you can see the entire watch movement, and the watch core can be taken out as a whole. This makes it possible to reassemble the pushers in the watch case, insert the watch movement and secure the back cover. 2. The back cover of the electronic watch without screws is directly buckled, and there should be a protruding part on the edge of the back cover (a notch that is easy to pry open), which is the prry up, and it can be opened by slowly cocking it with a small flat screwdriver, and the way to take out the movement is the same as above.

If it is the kind of quartz watch + electronic watch with watch hands and adjustment knob, you must take out the adjustment knob rod before taking out the watch movement, which is more complicated, if you don't understand the structure, it is best to go to the repair office to deal with it).

1: There is a small button on the right side of the table, you can twist it. Different watches have different ways to pull out, the old watch and the new watch are different, to look at the front of the watch, sometimes the old watch also remove the second hand, minute hand, hour hand and panel to finally get off the screw, this is a quartz watch, use a screwdriver to unscrew the small screws around it, but be careful.

2: Open the back cover, carefully rotate the handle, a clutch wheel, and the watch handle is fixed on the machine core by the teeth on the pawl, you can remove the table handle, if you don't find a small hole, you can press the pawl, and pull out the watch handle outward at the same time.