Is it better to place the water heater in the ceiling or outside the ceiling

The ordinary installation method is to put it in the ceiling, so that it is more convenient to observe the amount of water in the water heater, and the water temperature can be adjusted at will.

If it is installed in a gusset, it should be designed in advance and the pipe should be reserved. If it has a wire control function, it can be completely hidden, but it is necessary to pre-embed the line pipe and pressure relief valve flow pipe.

Electric water heater bar Hang it on the top This is more beautiful Put it in the ceiling of the kitchen or bathroom Now the ceiling is made of aluminum gusset If there is a problem with the water heater, it is simple to repair Remove the aluminum gusset and you can repair it Hang it outside for easy maintenance.

Is it safe to hang an electric water heater on the wall.

If it is a cement wall, it is not dangerous to hang a water heater, but it is not recommended to hang a water heater if it is gypsum board or hollow wall. When we install electric water heaters, we should pay attention to the following points: 1. The indoor wiring of the family should be reliably grounded, and the grounding resistance value should not be greater than 4.

Household sockets, regardless of single-phase power supply or three-phase power supply, must be grounded with the ground wire of the power supply, and the grounding pole of the socket is not allowed to be empty. 2. The socket equipped with the electric water heater should be a fixed special socket with a ground wire, and the mobile power terminal board cannot be used. The structure, capacity, and jack size of the socket should match the power plug of the electric water heater.

The socket should be placed above the horizontal position of the outlet of the electric water heater to avoid the risk of short circuit caused by water splashing. 3. When using the electric water heater, the power supply shall not be turned off through the switch on the socket, because the leakage protection plug cannot work after the power supply of the socket is turned off, and the protection cannot be provided in the event of a fault such as the ground wire being lived. 4. Check the "test" button of the leakage protection plug regularly (generally weekly) to confirm that the leakage protection plug can work normally.

5. Maintenance and cleaning.

Is it safe for a 60 liter water heater to hang on the toilet.

It mainly depends on whether the brick wall where you hang the water heater is firm, if it is 30 cm, it is okay, and the installation is also from the factory, if not, he will not install it for you. Is it safe to fix an electric water heater? If so, if it's filled with 60 litres of water plus your own body weight, I don't think so.

The water heater can be placed in the curtain bath.

It is best not to put the gas water heater, there are too many brands of water heaters, you want to be more expensive and you can choose the brand of Taurus, you want to be more economical and you can choose Euryat, but the *** point is high, let me tell you. First, in fact, there is no need to pursue the brand effect, *** can be, the second is to match your entire home decoration style, you must be cautious when choosing floor heating, the current market is better is Rifeng and Ruhr, Rifeng everyone knows, is to do pipes in the floor heating pipe, good quality and low price, the most important thing is to cooperate with the decoration of the shower curtain room, water and electricity safety is also to pay attention to. Second, it is best to shop around when buying, different stores ** are not the same, such as Luer water heater, this brand is also available, I heard that as early as 02 years began to make water heaters Yes, the water heater can be placed in the bathroom, which is convenient for bathing.

Dear, there are too many brands of water heaters, if you want to be more expensive, you can choose the brand of Taurus, and if you want to be more economical, you can choose Eurat, but the *** point is high, let me tell you. First, no.

<> electric water heater. It can be installed in the ceiling. The electric water heater is installed above the ceiling, and the installation sequence is to first install the electric water heater and then install the ceiling; If the water heater is half-wrapped under the ceiling, then the water heater will be installed after the ceiling is installed.

Try not to install the water heater too high, try to leave half of it under the ceiling, because the height of the ceiling can be arbitrary.

When installing a water heater, it should be noted that the embedded part is smaller than the exposed part, and a 30 cm access opening must be left on the right side. The ceiling on the right side of the machine can be made into a movable board, or at least 2 cm on both sides of the machine, and at least 3 cm in front of the machine, so that the machine can be taken off for maintenance.

Be sure to reserve a small tube for pressurized water when installing.

This answer is applicable to most brands of electric water heater models such as Wanhe, Midea, and Haier.

It is good to put the water heater half wrapped in the ceiling, because the height of the bathroom ceiling is not particularly high, so the water heater half in it will soften the whole space.

Not good, because once there is a problem with the water heater in the later stage, it is very difficult to maintain, so it is not recommended to wrap it in the ceiling.

Well, to install a semi-embedded water heater, it is necessary to reserve a small tube for pressurized water, so that there is no need to remove the aluminum gusset below when cleaning the scale, which saves a lot of trouble.

The first step of the water heater installation on the ceiling is to measure the size of the edge strip, nail the wooden plug after the hole is punched, nail the edge strip to the wall, and start to install the main keel after the edge strip is completed.

Hanging parts, triangular auxiliary keel, the main frame is done immediately after the installation module, the specific operation is as follows:

First, measure the size of the edge strip, punch holes in the wall tiles, and nail the wooden stopper after the hole is punched to facilitate the installation of the edge strips, which is also a test of whether the wall tiles are paved firmly.

Second, after the cork is installed, nail the edge strip to the wall, and pay special attention to the edge strip splicing at the corner of the wall.

3. After the edge strip is done, the main keel hanger will be installed.

Fourth, after the installation of the main keel, the triangular auxiliary keel is installed.

Fifth, due to the beams of the house.

Affecting the installation of the triangular keel must be smashed off the excess.

Sixth, after the main frame is completed, it is immediately followed by the installation of the module.

Precautions: 1. The water heater should not be installed too high, and it is best to leave half of it under the ceiling, because the height of the ceiling can be decided by the owner himself.

Second, the water pipe left on the wall can be used.

3. It is recommended to use an integrated ceiling.

Fourth, you don't have to find guerrillas, you buy an integrated ceiling, and the merchant will come to install it and charge some material fees.

Fifth, if you use the integrated ceiling, you don't need the old switch, as long as there is a line head, the integrated ceiling has a lamp.

Sixth, the water heater should be installed first, and then the ceiling should be suspended.

7. The original water heater should have a power supply, and it can be used if you find it.

This answer is applicable to most brands of water heater models such as Wanhe, Midea, and Haier.

1. The water heater should not be installed too high, and it is best to leave half of it under the ceiling, because the height of the ceiling can be determined by yourself; 2. The two water pipes left on the wall can be used; 3. It is recommended to use an integrated ceiling; 4. You don't have to find an installer, if you buy an integrated ceiling, the merchant will come to install it and charge some material fees; 5. If you use an integrated ceiling, you don't need the old switch, as long as you leave a wire, and the integrated ceiling has a lamp; 6. Install the water heater first, and then the ceiling; 7. The original water heater should have a power supply, and it can be used if you find it.

Expand your knowledge: Precautions for using water heaters.

1. The water heater should be cleaned once every two or three years. When operating, unplug the plug, turn off the cold water and hot water angle valves under the electric water heater, and wait for the water to cool before cleaning. In order to ensure safety and prevent unclean cleaning, no specialized equipment and damage to the water heater, it is recommended that those who have the conditions ask professional maintenance personnel to clean it.

2. Because there are more impurities in the tap water, the residual chlorine used for disinfection, the sediment and rust in the pipes will be brought into the water heater, making the water quality worse; If it is not cleaned for a long time, the scale attached to the heating rod will affect the heating efficiency and increase the energy consumption.

3. In addition, the impurities and metal filings deposited in the water will also cause ** disease, so that the ** sensitive people, the elderly and children will have ** itching, allergies and other discomforts. Therefore, cleaning is a non-negligible part of the water heater's use, and the time of regular cleaning should be judged according to the frequency of use.

First ceiling, if it is a gypsum board ceiling, you can let the decoration master reserve the pipe holes of the hood machine and water heater, and consult the manufacturers of various brands for specific size and location. This size position can make the scene of the cigarette seller and water heater drawn, and the hole must be high inside and low outside.

Not good, the disadvantages are as follows:

1. Difficult maintenance.

The most obvious disadvantage of semi-concealed installation of electric water heaters is the difficulty of maintenance. If you don't estimate the location, it will be troublesome to repair it later, and even if the domestic water heater is broken, almost half of the ceiling will have to be removed to repair it.

2. The ceiling is difficult to match.

Water heaters can generally be replaced after about five years of use, but the bathroom decoration will not be reinstalled in such a short time, so there is a problem. Since the water heater is recessed, it is difficult to find the same style as the ceiling section that was originally missing. Feign.

Electric water heaters have long been updated, and the size may not be able to fill the gap.

If the new water heater is too large, it will be reinstalled in the ceiling. If it's too small, it will expose a big gap, which is very impressive.

3. Pollution. Semi-concealed water heaters are sure to leave gaps around, and there is plenty of water in the bathroom. Use hot water when showering. Water vapor condenses on the ceiling, but when it reaches the top of the ceiling with gaps, it can also be contaminated with bacteria.

If condensation drips back into the bathroom, it can also pose a risk to your family's health.

The gap between the water heater and the ceiling can be directly covered with copper plates. Or you can use the scraps of bricks to make up directly. Such a gap may cause the hot air of the water heater to leak out and blacken the ceiling, so you need to pay attention to it.

Summary. The decoration should be the ceiling first and then the gas water heater. Under normal circumstances, it is from top to bottom in turn, but the pipeline position of the water heater is reserved first, and the position where the ceiling is blocked generally must be installed first.

Under normal circumstances, when decorating the kitchen, first install the ceiling, then install the cabinets, and then install the gas water heater, and install these before the ceiling, when the time comes, there will be a lot of things on these, which is easy to get flowers and dirty. According to the specific situation, in general, the gas water heater can also be installed first, and then the ceiling can be installed.

Hello, the ceiling is installed first.

The decoration should be the ceiling first and then the gas water heater. Under normal circumstances, it is from top to bottom in turn, but the pipeline position of the water heater is reserved first, and the position where the ceiling is blocked generally must be installed first. Under normal circumstances, decorate the kitchen, first install the ceiling, then install the cabinets, and then install the gas sensitive water heater, install these before the ceiling, and then make a lot of Dongmu Tanxi Bridge ridges on these, easy to flower and dirty.

According to the specific situation, in general, the gas water heater can also be installed first, and then the ceiling can be installed.

Summary. Hello <>

OK. It is more common for the water heater to be installed on the top, and some small homes or houses with a more compact layout may not have other space for the water heater to be installed, so installing the water heater on the top has become a good option.

It is not possible to install a water heater inside the top.

Hello <>

OK. The water heater is installed on the top is a more common installation method, there are some small houses or houses with a more compact layout, there may be no other space for the installation of the water heater, so installing the water heater on the top has become a good choice.

It should be noted that when installing the water heater, the problem of the flue should be taken into account, because the exhaust port of the gas water heater needs to lead to the outside, and it is necessary to ensure that the distance between the exhaust port and the chain beam inside meets the regulations to ensure safety. In addition, the weight and stability of the water heater need to be considered during installation to ensure that it can be securely fixed to the top to avoid dangerous situations such as shaking or falling off. Finally, it is necessary to pay attention to the maintenance and cleaning of the water heater, regularly clean the flue and check the use of the water heater to ensure its normal operation.

Summary. Kiss, <>

Yes, but there are a few things to keep in mind:1The weight of the water heater:

The weight of the water heater needs to be considered for top-mounted water heaters, if the water heater is too heavy, it may cause pressure on the top structure, resulting in safety hazards. 2.Exhaust Problems:

The water heater needs to discharge the exhaust gas generated after gas combustion, and if the water heater is installed on the top, the problem of exhaust needs to be considered, otherwise the indoor air quality will be affected. 3.Difficulty of repair:

It is difficult to maintain the top water heater, and the top structure needs to be disassembled to be repaired, which is inconvenient. Therefore, if conditions permit, it is recommended to install the water heater on the wall outdoors or indoors, which is safer and easier to maintain.

It is not possible to install a water heater inside the top.

Kiss, [open filial piety smile] <>

Yes, but there are a few things to keep in mind:1The weight of the water heater:

The weight of the water heater needs to be considered for top-mounted water heaters, if the water heater is too heavy, it may cause pressure on the top structure, resulting in safety hazards. 2.Exhaust Problems:

The water heater needs to discharge the exhaust gas generated after gas combustion, and if the water heater is installed on the top, the problem of exhaust needs to be considered, otherwise the indoor air quality will be affected. Eggplant contains 3Difficulty of repair:

It is difficult to maintain the top water heater, and the top structure needs to be disassembled to be repaired, which is inconvenient. Therefore, if conditions permit, it is recommended to install the water heater on the wall outdoors or indoors, which is safer and easier to maintain.

What is it? 1Before using the water heater, you should check that the power configuration of the water heater is correct.

2.When using the water heater, care should be taken to avoid burns, and if there are children, special care should be taken to avoid scalding and damage. 3.

Keep the water heater clean to avoid the accumulation of free chlorine, and replace the water stored in the tank in time to avoid the growth of bacteria. 4.The water valve should be closed when the water heater is in use, and the power should be turned off in time when there is a water leak or failure to avoid endangering safety.

5.Do not place items on the hot water splitting car, so as not to affect the heat dissipation performance. 6.

Regularly inspect the temperature control safety device of the water heater to avoid defects.