How to change the air conditioner filter? How to change your cabin filter

The method of replacing the air conditioner filter element is as follows:1. Disassemble the glove box, there is a lever on the left side of the glove box, press the lever down to detach it from the glove box.

2. Squeeze the glove box from both sides to the middle with your hands to take it off.

3. After removing the glove box, you can see the grid where the air conditioning filter is placed, open the grid, and take out the air conditioning filter to replace it.

Open the hood, the air conditioning filter is close to the co-pilot, covered by a plastic plate, unscrew the screws on this plastic plate, and then tear off a section of the front adhesive strip, and take off the plastic plate to see the air conditioning filter.

There is a buckle on both sides of the air conditioner filter, open the buckle outward, you can pull out the air conditioner filter grid, replace it with a new one, there are two small openings on each side of the filter element, align the protruding place above the filter element and install it back, put the air conditioner filter cartridge back, buckle the buckle, cover the plastic cover, tighten the screws, and then install the rubber strip to complete the replacement.

Precautions for air conditioner filters.

After using it for a period of time, the activated carbon filtration function in the air conditioner filter will be reduced, so you can go to the auto parts market to buy a suitable air conditioner filter for replacement. If the air flow from the air conditioner is significantly reduced, the aircon filter may be clogged. The filter should be cleaned first, or replaced if necessary.

The frequency of cleaning depends on the road conditions (dusty roads, etc.). It is better to clean it early.

The cabin air filter should be installed correctly in its place. Using the air conditioner when the air conditioning filter is removed may cause dust resistance degradation and affect the air conditioning performanceUrban recommendations with poor air quality suggest that riders replace the air conditioning filter twice a year to ensure your health.

Open the co-pilot's storage box (glove box), find the fixing buckle on the right side, and pull it out firmly. Remove the fixing buckle of the glove box cover, and take off the glove box to see the air conditioner filter cover. Remove the cover, pull out the old air conditioner filter, insert the new air conditioner filter, and restore it to its original position in the reverse order of disassembly and assembly.

The steps to replace the cabin air filter are as follows: open the buckle on the air filter housing, remove the air filter cover, remove the air filter element, remove the filter element from the air filter, install the new air filter element into the air filter housing, and then buckle the clamp on the edge to complete the installation.

1.If you want to replace the air conditioner filter yourself, here are a few tips for replacing it.

2.Find the location of the filter in the passenger seat of the car.

3.Gently remove the co-pilot's glove box.

4.Pull out the old cabin filter and replace it with a new one.

5.Reinstall the co-pilot's glove box in place. End 1 Find the location of the filter element in the co-pilot's place in the car, gently remove the co-pilot's glove box, pull out the old air conditioning filter, replace it with a new filter, and reinstall the co-pilot's glove box to it.

1. An elastic adaptor. and sleeves. Ratchet wrench.

2. Short screwdriver, cross-shaped, is the one you pictured. 3. It is more ideal to have the following set, with ratchet wrenches and so on. The most important thing is this elastic adaptor, which can be twisted to the nut at the top of the accelerator pedal.

How to change your cabin filter

The weather is getting hotter and hotter, and when I get in the car and turn on the air conditioner that I haven't used for a long time, a sour and refreshing smell sweeps in, and the culprit of this smell is the air conditioner filter.

The air conditioning filter is like a mask for the car, blocking pollutants such as dust, sanga imitation particles, and bacteria from entering the car, and is the health defense line for the people in the car.

However, when the airflow of the air conditioning outlet is weakened or the gas blown out has a peculiar smell, it will not achieve the expected protective effect, but will harm the health of the people in the car.

Steps to replace the cabin air filter yourself.

Step 1: Find the right position and tighten it.

Generally, the air conditioning filter is hidden behind the co-pilot's glove box. Open the glove box and unscrew the top 3 screws and the bottom 3 screws with a screwdriver.

Step 2: Take out the glove box.

After tightening the screws, find the buckles on both sides of the glove box and punch the fiber, and take out the hand-patted potato box after deducting the buckles.

Step 3: Locate the lattice cover.

After removing the glove box, polish it with a flashlight and find the cover of the air conditioner filter hidden in the innermost part. This step requires a lot of effort. Pay attention to safe operation and avoid scratches.

Step 4: Remove the cabin air filter.

Press the buckle to open the air conditioner filter cover, you can see the center of the air conditioner inside, and then take it out. The aircon filter is made of sturdy materials, so you don't have to worry about damage. Pay attention to safe operation and avoid scratches.

Step 5: Install a new filter cartridge.

When installing a new filter, pay attention to the installation orientation. Follow the arrows on the cartridge and place it in the cover plate and put it back in the glove box to complete the replacement.

Tools Raw materials.

Aircon filter. 1. Remove the three external screws under the glove box.

2. Open the glove box and remove the five screws inside.

3. Pull out the entire glove box and find the cover of the air conditioner filter at the bottom of the center console.

4. Open the lid to see the white air conditioner filter, take out the old filter and replace it with the new one.

5. Close the lid to restore the glove box, and the air conditioner filter will be replaced.

Steps to manually change the cabin air filter: Some models have an air cabin filter under the front windshield of the car. Step 1:

Open the glove compartment and pull down the small hook on the right side. Step 2: Pinch both sides of the glove box and squeeze it in, then you can take it off.

Step 3: This is the cabin air filter grid, loosen the clips on both sides to drag it out. Step 4:

Pull out the filter compartment, put on a new filter, and put it back in the glove compartment and you're done.

1. Open the front panel of the air conditioner. The specific method is shown in the following figure:

2. Slowly push the air conditioner filter inward along the frame. The specific method is shown in the following figure:

3. Insert the lower edge of the filter into the card slot. The specific method is shown in the following figure:

4. The same method is used for the filter on the other side. The specific method is shown in the following figure:

5. Finally, close the lid of the air conditioner. The specific method is shown in the following figure:

First remove the air conditioner, pull out the entire glove box, find the cover of the air conditioner filter at the bottom of the center console, open the lid to see the air conditioner filter inside, take it out and replace it with a new one. The specific steps are as follows:

Operating Tools: Air Conditioner Filter.

1. Remove the three screws under the glove box.

2. Open the glove box and remove the five screws inside.

3. Pull out the entire glove box and find the cover of the air conditioner filter at the bottom of the center console.

4. Remove the lid and see the white air conditioner filter on the register, and take out the old filter and replace it with a new one.

5. Close the lid to restore the glove box, and the air conditioner filter will be replaced.

Car air conditioning filter replacement method: first open the glove box, pull down the small hook on the right side, pinch both sides of the glove box and squeeze it in, you can take it off, and then loosen the clips on both sides to drag it out, install a new filter element, and then install it back into the glove box to complete the replacement.

The position of the air conditioning filter varies from model to model, but there are two main types: under the front windshield and under the front windshield of the passenger seat.

The role is all the same:

1. It can make the air conditioner lattice close to the shell to ensure that the unfiltered air will not enter the cabin.

2. It can separate solid impurities such as dust, pollen, and abrasive particles in the air.

3. It can adsorb water, soot, ozone, odor, carbon oxide, SO2, CO2, etc. in the air; There is a strong and long-lasting mu of jujube to absorb water.

4. It can make the car glass not covered with water vapor, and can effectively sterilize and deodorize.

5. It can ensure that the air in the driving and passenger compartment is clean and does not breed bacteria, and create a healthy environment; It can effectively separate solid impurities such as dust, core powder, and abrasive particles in the air; It can effectively intercept pollen.

Replacing the air conditioner filter can be completely DIY, but you must understand how to remove the car air conditioner filter, and the first thing to know is where the air conditioner filter is. The air conditioning filter of some cars is under the windshield and is covered by a stainless steel sink that drains the air, while the air conditioning filter of most cars is located behind the glove box in front of the front seat, generally on the left side. How to replace the air conditioner filter, the actual disassembly and replacement of different parts below the actual operation:

Air conditioner filter under the drainage hood.

1. Open the engine cover, and the air conditioning filter is covered by a plastic plate in the area close to the front seat;

2. Twist the screws on the plastic plate in this regard, then tear off a section of the sealing strip in front of it, and take out the plastic plate to see the air conditioning filter;

3. There is a buckle on both sides of the air conditioning filter, and the air conditioning filter can be pulled out by opening the buckle outward;

4. Replace the new one, there are 2 small loan openings on both sides of the filter element, and the two ends are aligned with the prominent places on the filter cartridge and installed back;

5. Put the air conditioner filter cartridge back, buckle the buckle, cover the plastic back cover, tighten the screws, and then install the sealing strip for replacement.

Rear air conditioning filter for glove box.

1. Open the glove box to the highest part, you can see the fixed buckle, take it out, and squeeze both sides of the glove box to the middle with both hands, and the glove box can be disassembled and assembled;

2. Open the rear cover of the air conditioner air cleaner and pull out the activated carbon fiber of the air conditioner air filter;

3. Replace the activated carbon fiber of the new air conditioning air filter, if the air conditioning filter is not very dirty, it can be completely removed and re-applied, except for the activated carbon.

4. Install the components in the relative order of decomposition, install the rear cover, install the glove box, and replace it with the buckle.