How to replace the filter element of the well spring water purifier?

Filter element: The filter pore size is large and small, generally about microns.

Function: Block the visible bloodworms, sand, rust, colloids and other impurities in the water, with a service life of 1 2 months.

Dissolution spray filter element: the filter pore size is large and small, generally about 5 microns.

Function: Blocks impurities greater than 5 microns in water and colloids, rust and microorganisms in water, with a service life of 3 to 6 months.

3.Ceramic filter element: The filter pore size is in microns, which is slightly larger than the ultrafiltration material.

Function: Filter out bacteria, heat sources, microorganisms and colloids in water, significantly reduce turbidity in water, and the service life is 12-24 months.

4.Ultrafiltration material filter element: pore size in microns.

Function: Filter out bacteria, heat sources, microorganisms, macromolecular organic matter in water, and the service life is generally 12 to 24 months.

5.Activated Carbon Cartridge:

Function: adsorption of bleaching powder (chlorine), discoloration, and odor in water. Activated carbon filters are also subdivided into different types, with a service life ranging from 6 to 18 months.

Reverse osmosis membranes: pore sizes up to 10-6 microns.

Function: Filter out small molecule organic matter, bacteria, viruses, minerals, etc. in water. The service life is related to the pretreatment filter element (PP filter element, activated carbon filter element) and wastewater ratio, etc., which is generally 18 to 36 months.

I want to flush the filter, how do I remove it.

2. The function of PE filter element: it can block impurities such as bloodworms, sand, rust, colloids and other impurities that can be seen by the naked eye in the water;

3. The function of PP dissolution spray filter element: it can block impurities greater than 5 microns in water and colloids, rust and microorganisms in water;

4. The function of the ceramic filter element: it can filter out bacteria, heat sources, micro-envy biomimetics and colloids in the water, and significantly reduce the turbidity in the water;

5. The function of the ultrafiltration material filter element: it can filter out bacteria, heat sources, microorganisms and macromolecular organic matter in water.

<><

1. How to change the filter element of Jinglan water purifier

First of all, you need to disconnect the power supply of the water purifier, and then use the appropriate wrench to open the lid of the water purifier, so that you can see the filter element, then take out the old filter element, and clean the inside of the water purifier at the same time, and finally install the new filter element according to the disassembly steps, and then close the lid. Note that after the replacement is completed, it is necessary to test it, and if it can be used normally, it means that the replacement is successful.

Second, why should the water purifier change the filter element?

1. When the life of the filter element is up, it cannot play a filtration effect

For the water purifier, the filter element is like a battery in the remote control, if it has reached the end of its service life and the user has not replaced it, then it cannot have the effect of filtration, so it has to be cleaned or replaced regularly.

2. The filter element is clogged, which is easy to breed a large number of bacteria

During the operation of the water purifier, it is mainly used to filter impurities through the filter element, so it must be cleaned regularly, otherwise the filtered impurities will be adsorbed on the filter element, and after a long time, a large number of bacteria will breed.

3. How often to replace the filter element

If the tap water source is normal, but the water purifier does not produce water, then it means that the filter element has been seriously blocked, and the ratio is replaced immediately. Regarding the time for replacing the filter element of the water purifier, there is no fixed problem, and it needs to be considered in combination with the local water quality situation and the user's use. If you find that the water becomes turbid, or if you find that the water smells when you drink it, then you need to replace the filter element of the water purifier.

Summary. Hello Dear I am happy to answer for you: How to change the filter element of the Xiangshui Spring Water Purifier:

1. Turn off the power of the water purifier to prevent electric shock and other behaviors during installation. 2. Close the three-way valve of the water purifier, do not open the filter cover directly, and close the water source before operating.

Hello Dear Kiss I am happy to answer for you: How to change the filter element of the Xiangshui Spring Water Purifier Early Potato: 1. Turn off the power of the water purifier to prevent electric shock and other behaviors during the installation process.

2. Close the three-way valve of the water purifier, do not directly open the filter core cover, close the water source first, and then burn the socks for operation.

3. Open the cover of the filter element, the cover of the filter element is generally in rotation mode, and rotate in the correct direction according to the mark. 4. Take out the old filter element in the water purifier, and then rinse the inside of the water purifier. 5. After the installation of the new lead filter element is completed, close the filter cover, open the valve for testing, and after 10 minutes, there is no problem or no abnormal sound, I hope it can help you I wish you a happy life.

Dear, I'm glad to answer for you; 1.Close the water inlet tee, and close when the handle is perpendicular to the direction of the water pipe; 2.Close the pressure barrel ball valve, and the handle is closed when the direction of the water pipe is perpendicular to it; 3.

Turn on the water purification faucet and let the water out of the machine drain the remaining water in the machine for about 10 minutes; 4.Turn off the power, unplug the power cord, and wait for the machine to stop; 5.Unplug the faucet water pipe, pressure bucket water pipe, waste water pipe, etc. in turn; 6.

After the water pipe is unplugged, there will still be missing water flowing out, and the prepared rag can be used to dry the water; 7.Take out the water purifier, put the flat pants on the table, open the water purifier cover, and see the position of the filter element; 8.Use a special wrench to open the lid of each of the five filter barrels in turn.

Note: Align the slot on the wrench first, press it with the left leather lifting hand to prevent slipping, and open the filter barrel lid in a counterclockwise direction. )9.

After opening, the old filter element can be taken out in turn and replaced with a new filter element (the RO membrane needs to be pulled out with diagonal nose pliers); 10.After the replacement is completed, connect the water pipe, remember to insert the card if there is a blocker, and then tighten the filter barrel cover; 11.Then Hu Chun covered the cover, put the water machine back in place, plugged in the water pipe and power supply, and opened the water inlet tee (Note:

Observe for water leaks around the lid of the filter barrel. If there is, the valve needs to be closed again and the filter barrel cover should be screwed again); 12.Wait for about 20 seconds, wait for the air to be discharged, turn on the faucet, and let the water drain for 10 minutes after a few seconds, one is to activate the filter element to ensure the filtration function and prolong the service life at the same time, and the other is that there may be a small amount of activated carbon powder to be washed out to cause the dark color water to be cleared; 13.

Turn off the water faucet, replace the filter element, and wipe the leakage of the water dispenser and its surroundings with a rag.

Summary. Dear, I'm glad to answer your <>

1. Unplug the switching power supply of the water inlet, then open the back cover of the water purifier, and remove the filter element to replace. It must be noted that the filter element should be disassembled and assembled according to the prompts of the filter element, and the filter element of different brands of water purifiers is also dismantled in different ways, generally screwed to the left, that is, to remove the filter element in a counterclockwise direction, and to the right side is to install the filter element. 2. When installing a new filter element, the outer packaging should be removed and then the PP cotton filter element should be installed.

The specific installation method is very similar to the demolition, the removal is rotated in a counterclockwise direction, and the installation is rotated in a clockwise direction. 3. When the filter element is installed, the back cover of the water purifier can be installed. It is necessary to pay attention to the frequency of replacement of the filter element, and the replacement of the PP cotton filter element is usually a <> every three to six months

How to replace the filter element of Wangquan water purifier.

Dear, I'm glad to answer your <>

1. Unplug the switching power supply of the water inlet, then open the back cover of the water purifier, and remove the filter element to replace. It must be noted that the filter element should be disassembled and assembled according to the prompts of the filter element, and the filter element of different brands of water purifiers is also dismantled in different ways, generally screwed to the left, that is, to remove the filter element in a counterclockwise direction, and to the right side is to install the filter element. 2. When installing or imitating the new filter element, the outer packaging should be removed and then the PP cotton filter element should be installed.

The specific installation method is very similar to the demolition, the removal is rotated in a counterclockwise direction, and the installation is rotated in a clockwise direction. 3. When the filter element is installed, the back cover of the water purifier can be installed. It is necessary to pay attention to the frequency of replacement of the filter element, and the replacement of the PP cotton filter element is usually a <> every three to six months

Qinqin Wangquan Water Purifier Company was established in Jiangmen registered in Tanqi Zheng, which belongs to the drinking water treatment equipment, and the main industry is the drinking water treatment equipment in Kongzhou. The office address of Wangquan Water Purifier Company is Shop <>, 110, No. 17, Lemei Road, Jiangmen City, Guangdong, China

Summary. Hello! The method of replacing the filter element of Wangquan water purifier, 1. Turn off the power of Wangquan water purifier to prevent electric shock and other behaviors during installation.

2. Close the three-way valve of Wangquan water purifier, do not open the filter cover directly, and close the water source before operating. 3. Open the cover of the filter element, generally the cover of the filter element is in rotation mode, and rotate in the correct direction according to the marking. 4. Take out the old filter element in the water purifier, and then rinse the inside of the water purifier.

5. After the installation of the new filter element is completed, close the filter cover, open the valve for testing, and there will be no problem or abnormal sound after 10 minutes.

Hello! The method of replacing the filter element of Wangquan water purifier, 1. Turn off the power of Wangquan water purifier to prevent electric shock and other behaviors during installation. 2. Close the three-way valve of Wangquan water purifier, and Buchanghui can directly open the filter cover, and close the water source before operating.

3. Open the cover of the filter element, generally the cover of the filter element is in rotation mode, and rotate in the correct direction according to the marking. 4. Take out the old filter element in the water purifier, and then rinse the inside of the water purifier. 5. After the installation of the new filter element is completed, close the filter cover, open the valve to resist the door and test, and after 10 minutes, there is no problem or no abnormal sound.

Hello! The above is how to replace the filter element of the Wangquan water purifier.