Do you know how to prune the leaves of spider plants?

Spider plant is very familiar to everyone, and it is also a kind of flower that many flower friends are raising. Spider plants do not need to be pruned under normal circumstances. However, some spider plants that have grown for many years and have large plants still need to be pruned when the leaves are denser or some yellowing and dry leaves.

It seems that the plant is more spiritual and more beautiful.

Pruning the leaves of spider plant plants is usually done by pruning some dry and yellowed, broken and deformed leaves, and relatively dense leaves. Under the condition of normal management conditions such as water, fertilizer, light and ventilation, the leaves of spider plants rarely dry up. The leaves are dry and yellow, mostly due to a period of time that is too dry, a serious lack of water, or the soil is too wet for a long time.

Yes or there is a slight amount of fertilizer applied at a certain time. Some older plants that have been growing for a long time sometimes have some old leaves yellowing.

Some operational problems in daily management or due to excessive wind often cause some leaves of the plant to break. When pruning these leaves, it is important to be careful not to break other good leaves. When pruning, one hand straightens the leaf to be cut, and the other hand uses scissors to cut 1cm from the base of the leaf.

Some of the broken green leaves are also pruned in this way, and the little leaves left at the base will soon dry up after pruning. It doesn't matter if you remove it gently after drying or leave it on a plate. Some leaves are just dry leaves, and only the dry part can be slightly expanded.

The main thing is not to apply fertilizer and water for two or three days after pruning.

In addition, some spider plant plants with a lot of vines will also have some yellowing and drying up leaves when the growth time is long or lack of water. These small dry leaves can be removed carefully and gently, and generally do not need to use scissors. In order to make the spider plant more symmetrical, some vine branches that grow too long can be reduced, and some vine branches that are too dense can also be thinned.

The main purpose of pruning spider plant plants is to make the plants more symmetrical and beautiful.

First of all, you can prune the spider plant into a shape you like according to the shape you like, then prune the waste leaves in it, prune all the yellow boring and unnutritious leaves, and then you can transplant the spider plant to other potted plants according to the potted plant.

In the process of pruning, we must cut off those useless branches and leaves, so as to be good for spider plants.

Prune the wilted and excess parts of the spider plant. This is more conducive to the absorption of soil nutrients by spider plants.

Hello landlord, there are too many spider plant branches and leaves, and the tips of the leaves are yellow and dry, all of which need to be pruned.

One is for aesthetics, and the other is conducive to plant lighting. The old leaves are plucked off, the new leaves will grow better, the new flower branches, and then cut when they grow into small spider plants, and the small spider plants can be replanted, or raised in water, which is good.

Usually cut off the yellow leaves at any time. It can be repotted once a year in March to cut off old roots, rotten roots and excess fibrous roots. In early and mid-May, some of the old leaves of the spider plant are cut off, which will promote the germination of more new leaves and small spider plants.

Spider plant is divided into two forms. It is to see the waterfall, that is, to let the main body burst out a lot of leaf buds, and put the spider plant in a high position. A large waterfall is formed, and there is also an ornamental form, that is, he is not allowed to divide the side buds, and the main body will grow very long and very wide in this way.

Do you want to try to make him less. So that's how these two kinds of pruning work. Those who like to see the waterfall let him divide the vegetable teeth, and if he doesn't like to see the waterfall, cut off all the side teeth.

1. Pruning of leaves. Spider plant is a perennial herbaceous plant, pruning is extremely simple, can be carried out at any time, the dead leaves, yellow leaves, old leaves, diseased leaves, pale leaves, drooping leaves, broken leaves, messy leaves on the plant are cut off from the base, if the plant is not perfect, partial crown (one side lush, one side sparse), the leaf dense place can be thinned to ensure that the whole spider plant is symmetrical, complete, transparent, healthy, lush. For leaves with dead leaf tips, if there are many spider plant leaves, they can be cut off from the base, and if there are fewer leaves, only the dead part of the leaf tip can be cut off and the healthy part can be retained.

2. Pruning of stolons. For the stolons drawn from the leaf clusters, there are clusters of stems and leaves, which are independent young plants, and these stolons can be cut from the base in time according to personal preference, or they can be retained. Moderately thinning the stolons, abnormal, weak, and too small clusters of stems and leaves on the stolon.

If the stolons are too long, they can also be cut at suitable parts to promote new clusters of stems and leaves.

3. Pruning of roots. In March every year, combined with potting or transplanting, the old roots, diseased roots, rotten roots, and excessively long roots can be cut off.

4. Post-cutting management. In order to ensure the symmetrical and complete growth of spider plant, the spider plant should be placed in a place where scattered sunlight is irradiated, and it should not be exposed to strong sunlight. Rotate it 30° in a fixed order every week so that it receives light evenly and grows evenly.

1. Breeding. The simplest method of raising seedlings is dividing, that is, cutting seedlings from stolons and planting them directly. In addition, there are less commonly used sowing methods.

2. Potting soil. Spider plant does not have strict soil requirements, and can be prepared with humus and river sand to make loose and fertile, breathable and draining sandy loam soil. Do not plant too deep. For the convenience of management, it can also be directly raised in water for hydroponics, saving the trouble of watering and fertilizing.

3. Fertilizer and water management. Spider plant likes a moist environment, usually keep the potting soil moist, but can not accumulate water or too wet, especially in winter to water less. Fertilization can be done by watering, directly put a few grains of compound fertilizer in water, dissolve and water a little farther away from the roots.

It can also be applied at one time to slow fertilizer or spray foliar fertilizer, the general principle is to apply thin fertilizer frequently, rather light than thick, rather less than more.

Spider plant does not need to be pruned, the spider plant can be divided into pots if it grows a lot, and the whole pot of spider plant must be poured out by dividing the plant, and it is divided into one plant by one along its stem, and each plant must have roots. But the landlord had better wait, the summer is not good for the pot, heh, I'm sorry, just remembered this, you can be in the spring.

The autumn two seasons change, and the summer is hot and I am afraid that it is not good to slow down the seedlings.

The spider plant you said has grown long flowers like a branch sprout, which is the stem of the spider plant, and there are aerial roots underneath, which can be pinched down and planted from scratch.

It's a new spider plant, and when it gets out of its roots, it can be cut off and planted in another pot

Do not need to prune, each of the spider plants.

The leaves are connected to the rhizome, and the growth of the roots will be affected by pulling them out directly or cutting them short, and the spider plant after pruning the leaves is not beautiful.

There are a few things you need to pay attention to:

1) Control water and fertilizer.

Pay special attention to watering, be sure to "see wet and dry". The spider plant has a well-developed root system and strong water storage capacity, so it is important to control water. As for fertilization, once a month is fine.

2) Good ventilation.

When the spider plant reaches the point of pruning, it means that the environment is not good, and it is necessary to ventilate it in time and strengthen the light.

The landlord should be watering too often to cause the spider plant to grow, the leaves are too long and drooping and broken, which affects the ornamentation.

Suggestion: Spider plant is a fleshy root, very drought tolerant, watering should rather dry than wet, dry can still last for many days, watering a small amount of watering, but the leaves are short and wide.

Trim to your liking

Generally speaking, if the leaves of the spider plant are very unsightly, with yellow leaves, dry tips or wilting, they can be cut off, because the vitality of the spider plant is very strong, and its leaves will continue to grow.

First, check the root of the spider plant, how the root of the spider plant is not a problem, then you can shave the head of the spider plant.

2. Leave 10 to 12cm of spider plant head at the bottom of the spider plant and cut off all its leaves.

3. After cutting, you can dig out the cut spider plant head from the pot, pay attention not to damage the roots, and change the pot and loosen the soil.

Spider plant can be pruned after flowering, and when the plant grows vigorously, side branches that grow too fast will appear, absorbing a lot of nutrients and affecting the overall density of the plant. It can be pruned in time to ensure that the nutrients of the whole plant are sufficient.

1. Do spider plants need to be pruned after flowering?

Spider plants can be pruned after flowering, and their plant growth needs sufficient nutrients, but if the surrounding side branches grow vigorously and absorb a large amount of nutrients, it will affect the growth of the main branches, resulting in uneven nutrient absorption of the whole plant and problems with thinning density. Therefore, it is necessary to prune the side branches properly, and use a professional knife to cut off the long side branches. The surrounding dry and rotten branches and leaves, diseased branches and leaves, and old rotten branches and leaves need to be pruned in time.

Observe the growth of the flowers, and you can also prune them appropriately to ensure the value of the plants.

Second, the pruning method.

1.Chop off and trim.

In the case of very poor growth of spider plants, keep the branches 6 cm long from the roots, and cut off all the remaining spider plants. After trimming, place in a shaded and ventilated position and wait for the wound to heal.

2.Prune the roots.

The root system of spider plant is well developed, and it needs to be repotted after growing for a period of time. When repotting, you can check the growth of the roots of the spider plant, and prune the rotten and excess roots to clean up. Make sure that the pot has enough space for the plants to grow.

3. Precautions.

1.Illumination. After the spider plant is pruned, it cannot be directly exposed to sunlight to avoid sunburn in the song hall. It needs to be placed in a cool, ventilated location, waiting for the wound to heal, and returning to normal growth before applying light.

2.Disinfect. The tools used when pruning spider plants must be disinfected and soaked in carbendazim solution before use to avoid infection.

Yellow leaves appear in spider plants, such as yellow leaf tips, which indicates that the leaves of spider plants have aged and can no longer photosynthesize. At this time, it is necessary to prune the spider plant, cutting off its dry leaves and old leaves, so that it can germinate more new leaves.

Sometimes, the phenomenon of yellow leaves of spider plant is very serious, at this time, just pruning the leaves does not play a role, you need to cut off the head of the spider plant, remove most of the leaves, so that it can grow leaves again.

1. Shave the head to ensure the health of the root system of the spider plant, and then prune the leaves of the spider plant about 6-7cm away from the root system.

2. The pruned spider plant should be placed in a cool and ventilated place, and the first water should be permeable, taking care not to let the water drip onto the wound of the spider plant.

3. After that, watering follows the principle of seeing dry and wet. Water less at first, wait until the leaves start to grow, and then water normally, taking care to avoid sun exposure.

The root system of the spider plant grows quickly, so there will be a lot of old roots and rotten roots, which occupy a lot of space in the pot, and also limit the growth of the spider plant.

1. First of all, take out the spider plant plant, hold the rhizome of the spider plant with one hand, and hold the flower pot with the other hand to take out the spider plant.

2. After taking out the plant, the root system of the spider plant is soothed, and then the rotten root system is cut off to keep the healthy part.

3. The trimmed spider plant needs to be disinfected, soaked in carbendazim or potassium permanganate solution, placed in a cool place to dry, and then it can be re-potted.