-
It's fine to restore the factory settings again.
If it's not good, you can only call the after-sales door-to-door maintenance.
There is no other way.
This is a common occurrence with LG TV.
-
It may be caused by the defect of the lock switch in the TV electromechanical, which is specifically introduced below:
1. Possible causes:
The switch circuit of the TV is soldered or damp, resulting in poor contact, resulting in frequent automatic start-up;
The high-voltage instability of the motherboard circuit of the TV leads to frequent automatic turning on and off;
If it is a problem caused by the hardware failure of the TV, it is recommended to contact the after-sales service of the TV for testing and warranty.
2. Solution:
Turn off the power and unplug the power cord. (Be careful not to touch the high-pressure plate). Flat-mounted TV, mainly to protect the surface of the LCD. Unscrew the back cover and open the back cover of the TV with all the screws;
Locate the switch board on the top of the TV and remove the switch circuit board. Use a soldering iron to replace the 6-pin self-locking switch, or simply solder the 2 pins of the switch control together.
-
LG's LCD TV will automatically turn off after a while, what's the problem???
Hello, the reasons for the automatic shutdown of LCD TV are as follows: 1. The power supply system is unstable, which can also cause the occurrence of automatic shutdown failure, and you can consider configuring a UPS backup power supply with voltage stabilization function. 2.
Fault phenomenon: After the LCD TV is turned on with the curtain drawn, the picture and sound appear, and then the screen is turned off. Repeat the above phenomenon after rebooting with the remote control.
3.Fault phenomenon: It will automatically shut down after watching for a few minutes, and it can be turned on with remote control when it is turned off, and it will be automatically turned off after it is turned on.
Very often. 4. Then use the elimination method to check the memory, graphics card, CPU, CPU fan, motherboard, etc. 5. There may be a problem with the BIOS settings, enter the BIOS to restore the default settings or take out the battery of the motherboard, reverse the buckle discharge, and wait for 5 minutes to reverse install it.
Purpose: To restore the default values of the BIOS settings and eliminate the automatic reboot or shutdown of the BIOS cooling presets. 6. Then check the power supply, the power supply quality is poor, aging or the power is too small, can not meet the power supply needs of the computer accessories, you can replace the high-power and high-quality power supply, if troubleshooting, it is the automatic shutdown fault caused by the power supply.
-
<> LG TV 42-inch automatic start-up is generally due to the fact that the first Yu Qing and the power button of the TV remote control are short-circuited or leakage, resulting in the triggering of the power button, so it will automatically turn on. Clause.
Second, the switch circuit of the TV is soldered or damp and causes poor contact, resulting in automatic start-up. Thirdly, the high-voltage instability of the motherboard circuit of the TV leads to frequent automatic start-up. You can try to power off and reconnect and restart first, and then overhaul if it fails.
The case applies to lgoled65cxpca.
-
<> LG TV automatically turns on the white screen, generally the automatic start is because the standby button of the TV remote control is shorted or not reset after being pressed, the TV switch circuit is soldered, the contact is poor due to moisture, the high-voltage instability of the TV motherboard circuit, and the hardware failure of the TV is simply taken for reasons. The white screen is trembling because the power supply circuit on the driver board to the screen signal is abnormal, but the backlight is working normally, and it looks like a white screen.
This case is available for LG OLED65C9PCA TVs.
The first thing to check is the power supply part to see if the power output is normal. >>>More
Possible causes and solutions for the TV not turning on and the power indicator not lighting up: >>>More
This situation occurs very frequently, many people have encountered it, it is very likely that your internal power supply is faulty, or it is abnormal shutdown and boot on, and the component device is burned out. >>>More
Summary. Pro, there are generally several possible reasons why the TV screen is black but there is sound: 1 >>>More
The TV picture can't be occupied, and suddenly there is no signal, and there is a picture according to the signal source, and suddenly there is no signal.