What is the reason for the popular fishbone parquet floor on the Internet, but few people pave it in

The "fishbone parquet" laying method has a high charging standard. "Fishbone parquet" is all-round, the same quality of the floor, "herringbone parquet" is much more expensive than the conventional laying method. In addition, the loss is also relatively large.

The loss of ordinary flooring is about 5%, but the loss of "fishbone parquet" may be as high as 10%.

The main reason is that the cost of such a laying method is relatively high, the loss is relatively large, and the technical requirements for workers are relatively high; Its disadvantage is that it is easy to accumulate stains, which is inconvenient when cleaning.

Because it's more expensive, and then it's not easy to take care of, it's not easy to clean, so that's how it goes.

I really don't know, I haven't understood, and many people have big questions about this issue.

First, the installation method of fishbone parquet flooring.

Measure the size of the room and install it according to the size.

1. Before installation, the ground must be clean, dry, stable, flat and unfurnished.

2. The construction personnel should choose the installation effect according to the requirements of the customer, adjust the orientation of the floor reasonably and scientifically, first lay the moisture-proof mat of the floor, and then start from the corner of the wall, lay the side of the floor with a convex groove against the wall, and insert 8 mm wooden tenon between the floor and the wall to make the floor have a flexible space.

3. Fishbone patching method: first cut off the front mouth 45 degrees, then install the first floor, and assemble the front mouth groove 90 degrees with the reverse small end convex groove.

4. Pat the floor with a clapper and hammer to put the floor together to avoid gaps.

5. After the floor is installed, remove the temporary wooden tenon, ensure that there is an expansion joint, install the baseboard, and combine the baseboard with the floor surface compactly.

6. Lay the floor on the keel designed with geothermal pipes, and the vertical diaphragm part of the floor must be laid on the keel, the width of the keel shall not be less than 45mm, and the center interval of each keel shall not be greater than 300mm

7. For the installation quality of the floor, in line with the principle of who is responsible for the installation, the construction team is requested to strictly follow the construction procedures formulated by the company and the national regulations for the installation of wooden floors to ensure the quality of the project.

<>Second, is the large area of fishbones on the floor good-looking?

Generally, the floor can be covered with fishbones, and the advantages break through the traditional rigid floor laying method, and the disadvantages of herringbone will be relatively large. If you are preparing to make a large area of herringbone flooring, it is best to add some other parquet pattern effect. This will make the floor of the space not seem so monotonous and more interesting.